x框架-核心筒结构高层办公楼施工组织设计.doc
《x框架-核心筒结构高层办公楼施工组织设计.doc》由会员分享,可在线阅读,更多相关《x框架-核心筒结构高层办公楼施工组织设计.doc(11页珍藏版)》请在三一文库上搜索。
1、昆明同丰置业有限公司写字楼建设项目施工招标 投标施工组织设计 XXXX有限公司写字楼建设项目(E1-10-1地块)土XX程招标施工组织设计编制单位:云南XX集团第XX建筑有限公司low rotor, until rotor of weight by steam end sliding block and Reed end rotor Bay support, in put low rotor of while should in Reed end rotor Bay at added pad sleeper, due to stator has preliminary adjustment f
2、inished, so stator within bore exists must Yang degrees, so should note adjustment makes rotor keep and stator within bore concentric, makes rotor not and coil contact. Panasonic lane hook, remove wire rope hoist, wrapped at the rotor excitation-side shoulder arc washer, and move the lifting wire ro
3、pe to protect mat. Two 5T chain hoist end beam connections and welded to the rotor carriers, length adjusted for field conditions, and at the other end of the stator lifting hook or end cap end lugs connected, as shown in Figure 11.4.3-1. With Lane slightly single head upgrade rotor Reed end, keep r
4、otor level, demolition rotor Bay or support sleepers, then slowly synchronization pull two only chain gourd, makes rotor in steam end sliding block of support Xia along arc skateboard to steam end sliding, this process in the, lane must and rotor of sliding keep synchronization, in rotor of steam en
5、d and Reed end are due hand guardianship rotor and stator Zhijian of clearance. Dang by steam end side has nursing ring protection of coil end Department into stator within bore Hou, slightly upgrade rotor Reed end, in rotor ontology following loaded into Central sliding block, its loaded into Hou m
6、ust very carefully to along axis to for find are, and note observation rotor coupling in wear loaded process in the whether turned, as has should stop wear loaded, needed on Central sliding block location again for find are, while should note in Central sliding block placed yihou only allows steam e
7、nd sliding block beyond stator within bore, and in Central sliding block and steam end rotor nursing ring Zhijian at least should keep must of distance ( 300MW 76mm, 1000MW is 50mm). When the steam side slider close to steam at the end of the stator bore1 云南建工集团第十建筑有限公司目 录第一章 编制原则及依据6第一节 编制原则6第二节、编制
8、依据6第二章 工程概况10第一节 招标文件概述10第二节 工程概况10第四节 工程特点及重点难点11第三章 施工部署13第一节、施工部署的指导思想及原则13第二节 工程施工管理目标15第三节 工程施工组织18第四节、施工准备26第五节、主要施工工序31第四章 施工技术方案36第一节 工程测量控制方案36第二节 地基基础45第三节 主体工程54第四节 装饰装修工程方案84第五节 防水工程方法95第六节 水电安装工程方案100第五章 工程重点、难点施工方法及控制措施123第一节地下室混凝土防水123第二节大体积、大面积混凝土施工126第三节铝模板施工130第六章 质量承诺及保证措施133第一节 质
9、量承诺133第二节、质量保证体系133第三节 质量管理制度144第四节 技术保证措施162第五节 原材料的质量控制措施172第六节 计量保证措施178第七节 主要分部分项工程质量保证措施178第八节 质量通病的产生原因及防治措施197第九节 成品和设备保护措施215第十节 施工图纸会审与设计变更管理219第十一节 技术交底管理规定224第七章 工期承诺和保证措施228第一节、工期承诺228第二节、保证措施228第二节 人、才、物保证措施229第三节 施工机械保证措施230第四节 施工技术保证措施231第五节 雨天施工工期保证措施232第六节 夜间施工措施233第七节 农民工工资保障措施234第
10、八章 安全施工保证措施236第一节 安全保证体系236第二节 安全管理措施237第三节 安全防护措施240第四节 施工机械的安全措施245第五节 “五大”伤害防护措施246第九章 文明施工及环境保护措施249第一节 文明施工目标249第二节 组织机构及保证体系249第三节 我公司的责任和义务250第四节 现场安全文明施工标准251第五节 文明施工管理措施256第六节 现场文明施工具体措施258第七节 文明施工管理办法261第八节 传染病预防措施261第十章 绿色施工及环境保护措施263第一节 环境保护措施263第二节 减少扰民、降低环境污染及噪声措施265第三节 夜间施工措施266第四节 环境
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- 框架 核心 结构 高层 办公楼 施工组织设计
链接地址:https://www.31doc.com/p-2056040.html