AS 5000.3-2003---聚合物绝缘电力电缆第三部分:多芯控制电缆.doc
《AS 5000.3-2003---聚合物绝缘电力电缆第三部分:多芯控制电缆.doc》由会员分享,可在线阅读,更多相关《AS 5000.3-2003---聚合物绝缘电力电缆第三部分:多芯控制电缆.doc(18页珍藏版)》请在三一文库上搜索。
1、Australian/New Zealand StandardTM澳大利亚/新西兰标准TMElectric cablesPolymeric insulatedPart 3: Multicore control cables聚合物绝缘电力电缆第三部分:多芯控制电缆This Joint Australian/New Zealand Standard was prepared by Joint Technical Committee EL-003, Electric Wires and Cables. It was approved on behalf of the Council of Stand
2、ards Australia on 29 November 2002 and on behalf of the Council of Standards New Zealand on 27 November 2002. It was published on 3 February 2003.本澳大利亚/新西兰联合标准由EL-003电线电缆技术联合委员会编制,以澳大利亚标准委员会和新西兰标准委员会的名义分别于2002年11月29日和2002年11月27日获得审批通过,并于2003年2月3日出版。The following are represented on Committee EL-003:E
3、L-003委员会由下列单位参加:Australasian Railway Association澳大利西亚铁路协会Australian Electrical and Electronic Manufacturers Association澳大利亚电气与电子制造商协会Australian Industry Group澳大利亚工业集团Canterbury Manufacturers Association New Zealand新西兰坎特伯雷制造商协会Department of Defence (Australia)澳大利亚国防部Department of Mineral Resources N.
4、S.W. 新南威尔士矿产资源部Electrical Contractors Association of New Zealand新西兰电气承包商协会Electrical Regulatory Authorities Council电气监管机构委员会Electricity Supply Association of Australia澳大利亚供电协会Institution of Engineers Australia澳大利亚工程师协会Ministry of Economic Development (New Zealand)新西兰经济发展部National Electrical and Comm
5、unications Association国家电气与通信协会Keeping Standards up-to-date关于标准的更新Standards are living documents which reflect progress in science, technology and systems. To maintain their currency, all Standards are periodically reviewed, and new editions are published. Between editions, amendments may be issued.
6、 Standards may also be withdrawn. It is important that readers assure themselves they are using a current Standard, which should include any amendments which may have been published since the Standard was purchased.标准是应适时更新的文件体系,反映人们在科学、技术及系统方面取得的进步。为了保持标准的版本最新,所有标准都得定期进行评审并出版新的版本。在刊印不同版本期间,可能还会发行标准
7、的修正内容。标准也可能会被取消。因此,读者使用的版本必须是最新版本,其中应包括在购买标准以来出版的所有修正版本的内容。Detailed information about joint Australian/New Zealand Standards can be found by visiting the Standards Australia web site at .au or Standards New Zealand web site at www.standards.co.nz and looking up the relevant Standard in the on-line c
8、atalogue.如需了解有关澳大利亚/新西兰联合标准的详细信息,可访问澳大利亚标准局网站.au或新西兰标准局网站www.standards.co.nz,查阅在线目录中的相关标准。Alternatively, both organizations publish an annual printed Catalogue with full details of all current Standards. For more frequent listings or notification of revisions, amendments and withdrawals, Standards A
9、ustralia and Standards New Zealand offer a number of update options. For information about these services, users should contact their respective national Standards organization.另外,两家机构每年都出版附有当前所有标准全部信息的印刷版目录。如需进一步了解修订、增补和撤销清单或公告的最新信息,请咨询澳大利亚标准局和新西兰标准局。有关这些服务的信息,用户可联系相应国家的标准机构。We also welcome suggest
10、ions for improvement in our Standards, and especially encourage readers to notify us immediately of any apparent inaccuracies or ambiguities. Please address your comments to the Chief Executive of either Standards Australia International or Standards New Zealand at the address shown on the back cove
11、r.我们同时也欢迎读者提出宝贵意见,以改进我们的标准,尤其鼓励读者一经发现任何明显的不准确或者模糊不清的内容立即通知我们。请通过背封面上的地址向澳大利亚国际标准公司或新西兰标准局负责人提交您的宝贵意见。This Standard was issued in draft form for comment as DR 02017.本标准以草案的形式发布(文件名为DR 02017),用于征求意见。ISBN 0 7337 7622 1Australian/New Zealand StandardTM澳大利亚/新西兰标准TMElectric cablesPolymeric insulatedPart 3
12、: Multicore control cables聚合物绝缘电力电缆第三部分:多芯控制电缆Originated as AS 2373.11 980.Previous edition AS/NZS 2373.1:1995.Jointly revised and redesignated as AS/NZS 5000.3:2003.初次版本为AS 2373.11 980前次版本为AS/NZS 2373.1:1995联合修订并重新命名为AS/NZS 5000.3:2003COPYRIGHT Standards Australia/Standards New ZealandAll rights ar
13、e reserved. No part of this work may be reproduced or copied in any form or by any means, electronic or mechanical, including photocopying, without the written permission of the publisher.Jointly published by Standards Australia International Ltd, GPO Box 5420, Sydney, NSW 2001 and Standards New Zea
14、land, Private Bag 2439, Wellington 6020ISBN 0 7337 5000 1版权声明澳大利亚标准局/新西兰标准局保留所有权利。未经发行人的书面同意,不得以电子、机械(包括影印)等任何形式或手段转载、复制本标准的内容。由澳大利亚国际标准公司(地址:GPO Box 476, Sydney, NSW 2001)和新西兰标准局(地址:Private Bag 2439, Wellington 6020)联合出版。PREFACE前言This Standard was prepared by the Joint Standards Australia/Standards
15、 New Zealand Committee EL-003, Electric Wires and Cables, to supersede AS/NZS 2373.1:1995, Electric cables for control and protection circuits, Part 1: Multicore control cables.本标准由澳大利亚标准局/新西兰标准局EL-003电线电缆联合委员会编制,用以取代AS/NZS 2373.1:1995控制和保护回路电力电缆第一部分:多芯控制电缆。The objective of this Standard is to provi
16、de construction, dimensions and tests for cables used for control, supervisory, protection and instrumentation circuits.本标准提供控制、监控、保护以及仪表回路电缆的构造、尺寸和试验要求。This Standard differs from the 1995 edition as follows:本标准与1999版的不同之处在于:(a) The voltage designation has been changed from 0.6/1 kV to 450/750 V.(a)
17、规定电压已由0.6/1kV调整为450/750V。(b) Insulation and non-metallic sheath thicknesses have been decreased.(b)绝缘层和非金属护层厚度已降低。(c) A 0.5 mm2 conductor size has been included.(c)新增一种规格为0.5 mm2的导体。(d) Conductors are no longer restricted to a minimum of seven wires.(d)导线的最少数量不再局限于7条。(e) A compatibility test has bee
18、n included as a type test.(e)新增一种兼容试验,作为型式试验的一种。In the preparation of this Standard, consideration was given to the following publications and acknowledgment is made of the assistance received.编制本标准时,曾参考了下列文献。我们从中获得了不少帮助,对此深表谢意。NZS 6401, Specification for PVC-insulated cables for electric power and
19、lightingNZS 6401电力和照明PVC绝缘电缆的规格BS 6004, Electric cablesPVC insulated, non-armoured cables for voltages up to and including 450/750 V, for electric power, lighting and internal wiringBS 6004电力、照明以及内部布线用450/750V及以下PVC绝缘无铠装电力电缆The term informative has been used in this Standard to define the applicatio
20、n of the appendix to which it applies. An informative appendix is only for information and guidance.本标准采用术语 “供参考”来表明附件的适用情况。 “供参考”的附件仅做参考和指示性使用。CONTENTS 目录Page页码1 SCOPE范围42 REFERENCED DOCUMENTS参考文献43 DEFINITIONS定义44 VOLTAGE DESIGNATION规定电压45 CONDUCTORS导体46 INSULATION绝缘体57 ASSEMBLY OF CORES芯线装配58 BED
21、DING (OPTIONAL) 垫层(备选)59 METALLIC SCREENS (OPTIONAL)金属屏蔽(备选)610 SEPARATION LAYER (OPTIONAL)隔层(备选)611 ARMOUR (OPTIONAL)铠装(备选)612 METALLIC SHEATH (OPTIONAL) 金属铠装(备选)613 NON-METALLIC SHEATH非金属护层614 FURTHER PROTECTION (OPTIONAL)辅助保护(备选)615 MARKING标识616 TESTS试验717 GUIDE TO BENDING RADIUS弯曲半径指南7APPENDICES
22、 附件A PURCHASING GUIDELINES采购指南8B GUIDE TO BENDING RADIUS OF MULTICORE CONTROL CABLES多芯控制电缆的弯曲半径指南9STANDARDS AUSTRALIA/STANDARDS NEW ZEALAND澳大利亚标准局/新西兰标准局Australian/New Zealand StandardElectric cablesPolymeric insulated澳大利亚/新西兰标准聚合物绝缘电力电缆Part 3: Multicore control cables第三部分:多芯控制电缆1 SCOPE1 范围This Stan
23、dard specifies requirements for screened and unscreened insulated multicore control cable for voltages up to and including 450/750 V.本标准规定450/750 V及以下电压等级屏蔽和非屏蔽绝缘多芯控制电缆的要求。It applies to cables intended for use in control, supervisory, protection and instrumentation circuits. Control cables complying
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- AS 5000.3-2003-聚合物绝缘电力电缆第三部分:多芯控制电缆 5000.3 2003 聚合物 绝缘 电力电缆 第三 部分 控制 电缆
链接地址:https://www.31doc.com/p-2364283.html