NXP PN7150 NFC控制器单板计算机(SBC)解决方案.doc
《NXP PN7150 NFC控制器单板计算机(SBC)解决方案.doc》由会员分享,可在线阅读,更多相关《NXP PN7150 NFC控制器单板计算机(SBC)解决方案.doc(5页珍藏版)》请在三一文库上搜索。
1、NXP PN7150 NFC控制器单板计算机(SBC)解决方案nxp公司的PN7150是新一代RF无接触前端,根据NFCIP-1和NFCIP-2,ISO/IEC 14443,ISO/IEC 15693以及MIFARE Classic 卡和FeliCa卡指标,支持各种发送模式,嵌入ARM Cortex-M0 MCU核和集成的固件支持NCI 1.0主通信,工作电压3.0V-4.75V,并提供较高的发送输出功率。器件高度集成了解调器和译码器,RF电平检测器和用于发现自动设备的轮询回路,主要用在需要NFC功能的所有设备,TV,机顶盒,蓝光译码器和音频设备,家庭自动化,网光和无线路由器,家用电器,可穿戴
2、,遥控,健康和健美以及打印机,IP电话,游戏控制台和附件。本文介绍了PN7150主要特性和优势,发送模式框图和框图,以及演示板OM5578/PN7150S 单板计算机主要特性,NFC控制器板电路图,材料清单和PCB设计图。Best plugn play and high-performance full NFC solution PN7150 is a full NFCcontroller soluTIon with integrated firmware and NCI interface designed for contactlesscommunicaTIon at 13.56 MHz.
3、 It is compaTIble with NFC forum requirements.PN7150 is designed based on learnings from previous NXP NFC device generaTIon. It is the ideal solution for rapidly integrating NFC technology in any application, especially those running O/S environment like Linux and Android, reducing Bill of Material
4、(BOM) size and cost, thanks to:Full NFC forum compliancy (see 1) with small form factor antennaEmbedded NFC firmware providing all NFC protocols as pre-integrated featureDirect connection to the main host or microcontroller, by I2C-bus physical and NCI protocolUltra-low power consumption in polling
5、loop modeHighly efficient integrated power management unit (PMU) allowing direct supply from a BatteryPN7150 embeds a new generation RF contactless front-end supporting varioustransmission modes according to NFCIP-1 and NFCIP-2, ISO/IEC 14443, ISO/IEC15693, MIFARE Classic IC-based card and FeliCa ca
6、rd specifications. It embeds anARM Cortex-M0 microcontroller core loaded with the integrated firmware supporting theNCI 1.0 host communication. It also allows to provide a higher output power by supplyingthe transmitter output stage from 3.0 V to 4.75 V.The contactless front-end design brings a majo
7、r performance step-up with on one handa higher sensitivity and on the other hand the capability to work in active load modulation communication enabling the support of small antenna form factor.Supported transmission modes are listed in Figure 1. For contactless card functionality,the PN7150 can act
8、 autonomously if previously configured by the host in such a manner.PN7150 integrated firmware provides an easy integration and validation cycle as all the NFC real-time constraints, protocols and device discovery (polling loop) are being taken care internally.In few NCI commands, host SW can config
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- NXP PN7150 NFC控制器单板计算机SBC解决方案 NFC 控制器 单板计算机 SBC 解决方案
链接地址:https://www.31doc.com/p-3263845.html