BS EN 442-1-1996 散热器和热空气对流加热器规范.第1部分技术规范和要求.pdf
《BS EN 442-1-1996 散热器和热空气对流加热器规范.第1部分技术规范和要求.pdf》由会员分享,可在线阅读,更多相关《BS EN 442-1-1996 散热器和热空气对流加热器规范.第1部分技术规范和要求.pdf(18页珍藏版)》请在三一文库上搜索。
1、BRITISH STANDARD BS EN 442-1:1996 Incorporating Amendment No. 1 Specification for radiators and convectors Part 1: Technical specifications and requirements The European Standard EN 442-1:1995, with the incorporation of amendment 1:2003, has the status of a British Standard ICS 91.140.10 BS EN 442-1
2、:1996 This British Standard, having been prepared under the direction of the Engineering Sector Board, was published under the authority of the Standards Board and comes into effect on 15 July 1996 BSI 26 February 2004 The following BSI references relate to the work on this British Standard: Committ
3、ee reference RHE/6 Draft for comment 94/711410 DC ISBN 0 580 25776 2 Committees responsible for this British Standard The preparation of this British Standard was entrusted to Technical Committee RHE/6, Air or space heaters or coolers without combustion, upon which the following bodies were represen
4、ted: Aluminium Federation Association of British Health-Care Industries Boiler and Radiator Manufacturers Association Limited Building Services Research and Information Association Chartered Institution of Building Services Engineers Hevac Association Institute of Domestic Heating Engineers Institut
5、e of Refrigeration Manufacturers Association of Radiators and Convectors Limited National Association of Plumbing, Heating and Mechanical Services University of Portsmouth Coopted members Amendments issued since publication Amd. No.DateComments 1486126 February 2004Changes to EN foreword and see nat
6、ional foreword BS EN 442-1:1996 BSI 26 February 2004 i Contents Page Committees responsibleInside front cover National forewordii Foreword2 Text of EN 442-13 BS EN 442-1:1996 ii BSI 26 February 2004 National foreword This British Standard has been prepared by Technical Committee RHE/6 and is the Eng
7、lish language version of EN 442-1:1995, Radiators and convectors Part 1: Technical specifications and requirements, including amendment 1:2003, published by the European Committee for Standardization (CEN). The start and finish of text introduced or altered by amendment is indicated in the text by t
8、ags . Tags indicating changes to CEN text carry the number of the CEN amendment. For example, text altered by CEN amendment A1 is indicated by . EN 442-1 was produced as a result of international discussion in which the UK took and active part. BS EN 442-1 and BS EN 442-2 supersede BS 3528:1977 whic
9、h is withdrawn. It should be noted that in5.1.3 reference is made to alloy AlSi9Cu (N.46 000 and N.46 001) with a Footnote. These references related to a draft from CEN/TC 132, now available as prEN 1706 which has yet to be published and it is envisaged that the references in this standard will be r
10、evised by amendment after publication. Cross-references The British Standards which implement international or European publications referred to in this document may be found in the BSI Catalogue under the section entitled “International Standards Correspondence Index”, or by using the “Search” faci
11、lity of the BSI Electronic Catalogue or of British Standards Online. This publication does not purport to include all the necessary provisions of a contract. Users are responsible for its correct application. Compliance with a British Standard does not of itself confer immunity from legal obligation
12、s. 1) Summary of pages This document comprises a front cover, an inside front cover, pages i and ii, the EN title page, pages 2 to 13 and a back cover. The BSI copyright notice displayed in this document indicates when the document was last issued. 1)The European Standard refers to ISO 31-4:1978 whi
13、ch has been superseded by ISO 31-4:1992. EUROPEAN STANDARD NORME EUROPENNE EUROPISCHE NORM EN 442-1 December 1995 +A1 September 2003 ICS 91.140.10 Descriptors: Space heaters, heat radiators, convectors, specifications, mechanical strength, calorific power, marking, labelling English version Radiator
14、s and convectors Part 1: Technical specifications and requirements (includes amendment A1:2003) Radiateurs et convecteurs Partie 1: Spcifications et exigences techniques (inclut lamendement A1:2003) Radiatoren und Konvektoren Teil 1: Technische Spezifikationen und Anforderungen (enthlt nderung A1:20
15、03) This European Standard was approved by CEN on 1995-05-04; amendment A1 was approved by CEN on 7 June 2003. CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alte
16、ration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the Central Secretariat or to any CEN member. This European Standard exists in three official versions (English, French, German). A version in any other language made by trans
17、lation under the responsibility of a CEN member into its own language and notified to the Central Secretariat has the same status as the official versions. CEN members are the national standards bodies of Austria, Belgium, Czech Republic, Denmark, Finland, France, Germany, Greece, Hungary, Iceland,
18、Ireland, Italy, Luxembourg, Malta, Netherlands, Norway, Portugal, Slovakia, Spain, Sweden, Switzerland and United Kingdom. CEN European Committee for Standardization Comit Europen de Normalisation Europisches Komitee fr Normung Central Secretariat: rue de Stassart 36, B-1050 Brussels 1995 All rights
19、 of reproduction and communication in any form and by any means reserved in all countries to CEN and its members. Ref. No. EN 442-1:1995 + A1:2003 E EN 442-1:1995 BSI 26 February 2004 2 Foreword This European Standard has been prepared by Technical Committee CEN/TC 130, Space heating appliances with
20、out integral heat sources, of which the Secretariat is held by UNI. This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by June 1996, and conflicting national standards shall be withdrawn at the latest b
21、y June 1996. This document has been prepared under a mandate given to CEN by the European Commission and the European Free Trade Association, and supports essential requirements of EU Directive(s). For relationship with EU Directives, see informative Annex ZA, which is an integral part of this docum
22、ent. According to the CEN/CENELEC Internal Regulations, the following countries are bound to implement this European Standard: Austria, Belgium, Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and the United Ki
23、ngdom. Foreword to amendment A1 This document EN 442-1:1995/A1:2003 has been prepared by Technical Committee CEN/TC 130, Space heating appliances without integral heat sources, the Secretariat of which is held by UNI. This Amendment to the European Standard EN 442-1:1995 shall be given the status of
24、 a national standard, either by publication of an identical text or by endorsement, at the latest by March 2004, and conflicting national standards shall be withdrawn at the latest by March 2004. This document has been prepared under a mandate given to CEN by the European Commission and the European
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- BS EN 442-1-1996 散热器和热空气对流加热器规范.第1部分技术规范和要求 442 1996 散热器 空气 对流 加热器 规范 部分 技术规范 要求
链接地址:https://www.31doc.com/p-3644341.html