BS EN 4604-001-2009 Aerospace series — Cable, electrical, for signal transmission Part 001 Technical specification.pdf
《BS EN 4604-001-2009 Aerospace series — Cable, electrical, for signal transmission Part 001 Technical specification.pdf》由会员分享,可在线阅读,更多相关《BS EN 4604-001-2009 Aerospace series — Cable, electrical, for signal transmission Part 001 Technical specification.pdf(14页珍藏版)》请在三一文库上搜索。
1、? ? ? ? ? ? ? ? ? Licensed Copy: x x, The University of Sheffield, 22/06/2009 15:52, Uncontrolled Copy, (c) BSI ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? Licensed Copy: x x, The University of Sheffield, 22/06/2009 15:52, Uncontrolled Copy, (c) BSI BS EN 4604-001:2009 EUROPEAN STANDARD NORME EURO
2、PENNE EUROPISCHE NORM EN 4604-001 April 2009 ICS 49.060Supersedes EN 4604-001:2006 English Version Aerospace series - Cable, electrical, for signal transmission - Part 001: Technical specification Srie arospatiale - Cbles lectriques pour transmission de signaux - Partie 001 : Spcification technique
3、Luft- und Raumfahrt - Elektrische Leitungen fr Signalbertragungen - Teil 001: Technische Lieferbedingungen This European Standard was approved by CEN on 7 February 2009. CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
4、Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN Management Centre or to any CEN member. This European Standard exists in three official versions (English, F
5、rench, German). A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same status as the official versions. CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cypr
6、us, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom. EUROPEAN COMMITTEE FOR STANDARDIZATION CO
7、MIT EUROPEN DE NORMALISATION EUROPISCHES KOMITEE FR NORMUNG Management Centre: Avenue Marnix 17, B-1000 Brussels 2009 CENAll rights of exploitation in any form and by any means reserved worldwide for CEN national Members. Ref. No. EN 4604-001:2009: E Licensed Copy: x x, The University of Sheffield,
8、22/06/2009 15:52, Uncontrolled Copy, (c) BSI BS EN 4604-001:2009 EN 4604-001:2009 (E) 2 Contents Page Foreword 3 1Scope 4 2Normative references 4 3Terms and definitions .4 4Materials and construction of cables 4 5Required characteristics .5 6Test methods 5 7Quality assurance 9 8Identification, marki
9、ng and colour 10 9Packaging, labelling and delivery length . 10 Licensed Copy: x x, The University of Sheffield, 22/06/2009 15:52, Uncontrolled Copy, (c) BSI ? BS EN 4604-001:2009 EN 4604-001:2009 (E) 3 Foreword This document (EN 4604-001:2009) has been prepared by the Aerospace and Defence Industri
10、es Association of Europe - Standardization (ASD-STAN). After enquiries and votes carried out in accordance with the rules of this Association, this Standard has received the approval of the National Associations and the Official Services of the member countries of ASD, prior to its presentation to C
11、EN. This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by October 2009 and conflicting national standards shall be withdrawn at the latest by October 2009. This document supersedes EN 4604-001:2006. Att
12、ention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. CEN and/or CENELEC shall not be held responsible for identifying any or all such patent rights. According to the CEN/CENELEC Internal Regulations, the national standards organizations o
13、f the following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slo
14、vakia, Slovenia, Spain, Sweden, Switzerland and the United Kingdom. Licensed Copy: x x, The University of Sheffield, 22/06/2009 15:52, Uncontrolled Copy, (c) BSI ? BS EN 4604-001:2009 EN 4604-001:2009 (E) 4 1 Scope This standard specifies the required characteristics, test methods, qualification and
15、 acceptance conditions of signal transmission electrical cables. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced docume
16、nt (including any amendments) applies. EN 3475-100*, Aerospace series Cables, electrical, aircraft use Test methods Part 100: General. EN 3838, Aerospace series Requirements and tests on user-applied markings on aircraft electrical cables.1) EN 9133, Aerospace series Quality management systems Quali
17、fication procedure for aerospace standard parts. ISO 2574, Aircraft Electrical cables Identification marking. TR 6058, Aerospace series Cable code and identification list. 2) 3 Terms and definitions For the purposes of this document, the terms and definitions given in EN 3475-100 apply. 4 Materials
18、and construction of cables 4.1 General The composition, dimensions and mass of the cable shall conform to the characteristics below, as well as the values specified in the product standards. 4.2 Conductor 4.2.1 Material See product standards. 4.2.2 Construction See product standards, conductor shall
19、 not be spliced. * And all parts quoted in Table 1. 1) In preparation at the date of publication of this standard. 2) Published as ASD Technical Report at the date of publication of this standard. Licensed Copy: x x, The University of Sheffield, 22/06/2009 15:52, Uncontrolled Copy, (c) BSI ? BS EN 4
20、604-001:2009 EN 4604-001:2009 (E) 5 4.3 Dielectric See product standards. 4.4 Screening 4.4.1 Material The materials used for screening are defined in the product standards. The screen strands or strips shall be free of kinks or cracks and their surface shall have no corrosion at all or any other im
21、purities. 4.4.2 Construction Construction shall be in accordance with the product standard. Splices of the individual strands or strips may be affected by brazing, soldering or folding in. The number of splices shall not exceed 1 per 3 m length of cable. 4.4.3 Screen coverage The screen is construct
22、ed in such a way that the screen meets the electrical requirements defined in the product standards. 4.5 Outer jacket See product standards. 4.6 Colours of components and jacket See product standards. 5 Required characteristics The characteristics of the cables, tested according to the methods descr
23、ibed hereafter, shall comply with the values given in the product standards. 6 Test methods See Table 1. Licensed Copy: x x, The University of Sheffield, 22/06/2009 15:52, Uncontrolled Copy, (c) BSI ? BS EN 4604-001:2009 EN 4604-001:2009 (E) 6 Table 1 Tests: methods, application and requirements No.
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- BS EN 4604-001-2009 Aerospace series Cable electrical for signal transmission Part 001 Technical specification 4604
链接地址:https://www.31doc.com/p-3644957.html