AS 3533-2-2009 Amusement rides and devices Part 2 Operation and maintenance.pdf
《AS 3533-2-2009 Amusement rides and devices Part 2 Operation and maintenance.pdf》由会员分享,可在线阅读,更多相关《AS 3533-2-2009 Amusement rides and devices Part 2 Operation and maintenance.pdf(88页珍藏版)》请在三一文库上搜索。
1、 AS 3533.22009 Australian Standard Amusement rides and devices Part 2: Operation and maintenance AS 3533.22009 This Australian Standard was prepared by Committee ME-051, Amusement Rides and Devices. It was approved on behalf of the Council of Standards Australia on 9 July 2009. This Standard was pub
2、lished on 31 July 2009. The following are represented on Committee ME-051: Australian Amusement Association Australian Amusement Leisure and Recreation Association Australian Chamber of Commerce and Industry Australian Industry Group Australian Ski Areas Association Consumers Federation of Australia
3、 Department of Justice and Attorney General, Qld Department of Labour, New Zealand Department of the Premier and Cabinet, SA Engineers Australia Ministry of Economic Development, New Zealand Safety Institute of Australia Showmens Guild of Australasia Victorian Showmens Guild WorkCover New South Wale
4、s WorkSafe Victoria WorkSafe Western Australia This Standard was issued in draft form for comment as DR 05589. Standards Australia wishes to acknowledge the participation of the expert individuals that contributed to the development of this Standard through their representation on the Committee and
5、through the public comment period. Keeping Standards up-to-date Keeping Standards up-to-date Australian Standards are living documents that reflect progress in science, technology and systems. To maintain their currency, all Standards are periodically reviewed, and new editions are published. Betwee
6、n editions, amendments may be issued. Standards may also be withdrawn. It is important that readers assure themselves they are using a current Standard, which should include any amendments that may have been published since the Standard was published. Detailed information about Australian Standards,
7、 drafts, amendments and new projects can be found by visiting www.standards.org.auwww.standards.org.au Standards Australia welcomes suggestions for improvements, and encourages readers to notify us immediately of any apparent inaccuracies or ambiguities. Contact us via email at mailstandards.org.aum
8、ailstandards.org.au, or write to Standards Australia, GPO Box 476, Sydney, NSW 2001. The Standard is downloaded from Standard Sharing AS 3533.22009 Australian Standard Amusement rides and devices Part 2: Operation and maintenance Originated as part of AS 35331988. Revised and redesignated in part a
9、s AS 3533.21997. Second edition 2009. COPYRIGHT Standards Australia All rights are reserved. No part of this work may be reproduced or copied in any form or by any means, electronic or mechanical, including photocopying, without the written permission of the publisher. Published by Standards Austral
10、ia GPO Box 476, Sydney, NSW 2001, Australia ISBN 0 7337 9205 7 AS 3533.22009 2 PREFACE This Standard was prepared by Joint Standards Australia/Standards New Zealand Committee ME-051, Amusement Rides and Devices, to supersede AS 3533.21997. This Standard was prepared by the Australian members of the
11、Joint Standards Australia/Standards New Zealand Committee, ME-051. After consultation with stakeholders in both countries, Standards Australia and Standards New Zealand decided to develop this Standard as an Australian Standard rather than an Australian/New Zealand Standard. The objective of this St
12、andard is to provide proprietors and operating staff with requirements and guidance for operation and maintenance of amusement rides and devices in order to protect the health and safety of both operating staff and patrons. Originally developed from technical literature, existing regulations and gui
13、delines, this Standard has been developed through the combined experience of the Committee and the organizations represented on it, along with contributions from several individuals and organizations having expert knowledge in those areas covered by this Standard. The Committee acknowledges the cont
14、ributions made by those individuals and organizations and wishes to record its appreciation for their permission to include this material. Major changes to the previous edition are as follows: (a) Reference to AS 3533.3 for the procedures for conducting any in-service inspections required by this St
15、andard. (b) Introduction of requirements for daily inspections and test runs and major inspections for amusement rides and devices. (c) Expansion of requirements for records pertaining to the amusement ride or device, its inspection and maintenance in place of the information previously presented in
16、 AS 3533.2 Supp 1, Amusement rides and devices, Part 2: Operation and maintenance, Supplement 1: Logbook. (d) Expansion of requirements and guidance concerning bolts. (e) Relocation of expanded specific requirements for inflatable structures, particularly for their anchoring to prevent undue movemen
17、t with wind changes, to a separate part in the AS 3533 series. (f) Relocation of specific requirements for roller coasters to a separate part in the AS 3533. (g) Removal of passenger ropeways and passenger conveyors from the scope of AS 3533.2. (h) Replacement of requirements concerning clearances f
18、rom power lines with general guidance on the types of requirements implemented by regulatory authorities. The Committee also intends to refer to a new Standard for flying foxes that is under preparation by Committee SF-047 Artificial Climbing Structures, to replace the requirements in Clause 4.9. Wh
19、en the new Standard is published, this Standard will be amended accordingly. This Standard (AS 3533.2) was created to cater specifically for the proprietors and operating staff of amusement rides and devices by providing them with a set of guidelines for the day-to-day operation of such devices. The
20、 Standard is downloaded from Standard Sharing 3 AS 3533.22009 The occupational health and safety obligations laid out in AS 3533.1 for designers and manufacturers of amusement rides and devices are continued in this Part (AS 3533.2). This Part is intended essentially as a working document and ready
21、 reference for the proprietors and operating staff associated with both mobile and permanently installed devices. The terms normative and informative have been used in this Standard to define the application of the appendix to which they apply. A normative appendix is an integral part of a Standard,
22、 whereas an informative appendix is only for information and guidance. AS 3533.22009 4 CONTENTS Page SECTION 1 SCOPE AND GENERAL 1.1 SCOPE 6 1.2 REFERENCED DOCUMENTS 6 1.3 DEFINITIONS 8 SECTION 2 SITE LAYOUT, ASSEMBLY AND ERECTION, AND ELECTRICAL REQUIREMENTS 2.1 SITE LAYOUT . 12 2.2 ASSEMBLY AND ER
23、ECTION 14 2.3 ELECTRICAL REQUIREMENTS 24 SECTION 3 ORGANIZATIONAL ARRANGEMENTS 3.1 PLANNING. 29 3.2 OPERATION. 30 SECTION 4 SPECIFIC OPERATIONAL REQUIREMENTS 4.1 GENERAL 32 4.2 AQUATIC AND WATERBORNE AMUSEMENT DEVICES. 32 4.3 KARTS AND KART TRACKS. 34 4.4 FERRARI 500-TYPE KARTS AND TRACKS. 36 4.5 TO
24、BOGGANS (LAND-BASED) 38 4.6 AMUSEMENT DEVICES INCORPORATING ELASTIC SUSPENSION SYSTEMS. 39 4.7 AIR CUSHIONED VEHICLES. 39 4.8 PARASAILING. 40 4.9 FLYING FOXES. 42 4.10 CABLE WATERSKIING 43 4.11 MINI BIKES AND MINI BIKE TRACKS 44 4.12 DRY SLIDES 45 4.13 STEAM AND HOT WATER EQUIPMENT. 45 4.14 HYDRAULI
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- AS 3533-2-2009 Amusement rides and devices Part Operation maintenance 3533 2009
链接地址:https://www.31doc.com/p-3645728.html