BS EN 15182-4-2007+A1-2009 消防用手持式支管.高压支管PN161.pdf
《BS EN 15182-4-2007+A1-2009 消防用手持式支管.高压支管PN161.pdf》由会员分享,可在线阅读,更多相关《BS EN 15182-4-2007+A1-2009 消防用手持式支管.高压支管PN161.pdf(14页珍藏版)》请在三一文库上搜索。
1、BRITISH STANDARD BS EN 15182-4:2007 Hand-held branchpipes for fire service use Part 4: High pressure branchpipes PN 40 ICS 13.220.10 - - - - - - - - - - - - !“ - - - - - - - - - - - - - - - - - - - - - - - - - - - w - - - - EUROPEAN STANDARD NORME EUROPENNE EUROPISCHE NORM EN 15182-4:2007+A1 Novembe
2、r 2009 ICS 13.220.10 Supersedes EN 15182-4:2007 English Version Hand-held branchpipes for fire service use - Part 4: High pressure branchpipes PN 40 Lances main destines aux services dincendie et de secours - Partie 4: Lances haute pression PN 40 Strahlrohre fr die Brandbekmpfung - Teil 4: Hochdruck
3、strahlrohre PN 40 This European Standard was approved by CEN on 23 December 2006 and includes Amendment 1 approved by CEN on 29 September 2009. CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a n
4、ational standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN Management Centre or to any CEN member. This European Standard exists in three official versions (English, French, German). A version
5、in any other language made by translation under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same status as the official versions. CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmar
6、k, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom. EUROPEAN COMMITTEE FOR STANDARDIZATION COMIT EUROPEN DE NORMALISATI
7、ON EUROPISCHES KOMITEE FR NORMUNG Management Centre: Avenue Marnix 17, B-1000 Brussels 2009 CEN All rights of exploitation in any form and by any means reserved worldwide for CEN national Members. Ref. No. EN 15182-4:2007+A1:2009: E EN 15182-4:2007+A1:2009 (E) 2 Contents Page Foreword 3 1 Scope 4 2
8、Normative references 4 3 Terms and definitions .4 4 Requirements .5 5 Testing and proofs.9 BS EN 15182-4:2007+A1:2009 EN 15182-4:2007+A1:2009 (E) 3 Foreword This document (EN 15182-4:2007+A1:2009) has been prepared by Technical Committee CEN/TC 192 “Fire service equipment”, the secretariat of which
9、is held by BSI. This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by May 2010, and conflicting national standards shall be withdrawn at the latest by May 2010. Attention is drawn to the possibility tha
10、t some of the elements of this document may be the subject of patent rights. CEN and/or CENELEC shall not be held responsible for identifying any or all such patent rights. This document includes Amendment 1, approved by CEN on 2009-09-29. This document supersedes EN 15182-4:2007. The start and fini
11、sh of text introduced or altered by amendment is indicated in the text by tags ! “ EN 15182 consists of the following parts, under the general title Hand-held branchpipes for fire service use: Part 1 : Common requirements; Part 2 : Combination branchpipes PN 16; Part 3 : Smooth bore jet and/or one f
12、ixed spray jet angle branchpipes PN 16; Part 4: High pressure branchpipes PN 40. According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denma
13、rk, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom. BS EN 15182-4:2007+A1:2009 EN 15182-4:2007+A1:2009 (E) 4 1 Scope I
14、n addition to the requirements given in EN 15182-1, this document applies to hand-held high pressure branchpipes (nozzles) PN 40 with a maximum flow rate of 200 l/min at a reference pressure of 6 bar (0,6 MPa). It deals with: safety requirements; performance requirements; test methods; classificatio
15、n and designation; operating instructions; marking and maintenance. This part of this European Standard applies to branchpipes as defined in Annex A of EN 15182-1:2007. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated referen
16、ces, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. EN 15182-1:2007, Hand-held branchpipes for fire service use Part 1: Common requirements 3 Terms and definitions For the purposes of this document, the terms
17、and definitions given in EN 15182-1:2007 and the following apply. 3.1 high pressure branchpipe branchpipe including a shut-off device and !an adjustable pattern“ corresponding to the following definitions NOTE Branchpipe is defined in 3.1 of EN 15182-1:2007. 3.1.1 high pressure branchpipe type 1 hig
18、h pressure branchpipe with !adjustable pattern“ at variable flow NOTE Changing pattern changes the flow. 3.1.2 high pressure branchpipe type 2 high pressure branchpipe with !adjustable pattern“ at constant flow NOTE Changing pattern does not change the flow. BS EN 15182-4:2007+A1:2009 EN 15182-4:200
19、7+A1:2009 (E) 5 3.1.3 high pressure branchpipe type 3 high pressure branchpipe with !adjustable pattern“ at selectable, constant flow NOTE Changing pattern does not change the flow. 3.1.4 high pressure branchpipe type 4 (automatic branchpipe) high pressure branchpipe with constant pressure NOTE Chan
20、ging pattern does not change the flow. 3.1.4.1 high pressure branchpipe type 4.1 high pressure branchpipe with !adjustable pattern“ at constant pressure 3.1.4.2 high pressure branchpipe type 4.2 high pressure branchpipe with !adjustable pattern“ and selectable flow at constant pressure 3.2 jet 3.2.1
21、 narrow spray jet intermediate position between the straight jet and the wide spray jet providing throw as well as protection 3.2.2 wide spray jet jet solely providing protection for the operator(s) 3.3 haptical device single mechanical device engaging detents 4 Requirements 4.1 General The branchpi
22、pes, covered by this standard, shall comply with EN 15182-1. 4.2 Mechanical characteristics 4.2.1 Dimensions and mass The branchpipes (without inlet coupling) shall not exceed the dimensions and masses specified in Table 1. BS EN 15182-4:2007+A1:2009 EN 15182-4:2007+A1:2009 (E) 6 Table 1 Dimensions
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- BS EN 15182-4-2007+A1-2009 消防用手持式支管.高压支管PN161 15182 2007 A1 2009 消防 用手 持式支管 高压 PN161
链接地址:https://www.31doc.com/p-3646723.html