BS EN 13279-1-2008 Gypsum binders and gypsum plasters Part 1 Definitions and requirements.pdf
《BS EN 13279-1-2008 Gypsum binders and gypsum plasters Part 1 Definitions and requirements.pdf》由会员分享,可在线阅读,更多相关《BS EN 13279-1-2008 Gypsum binders and gypsum plasters Part 1 Definitions and requirements.pdf(24页珍藏版)》请在三一文库上搜索。
1、? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? BS EN 13279-1:2008 EUROPEAN STANDARD NORME EUROPENNE EUROPISCHE NORM EN 13279-1 August 2008 ICS 01.040.91; 91.100.10Supersedes EN 13279-1:2005 English Version Gypsum binders and gypsum plasters - Part 1: Definitions and requirements Liants-
2、pltres et enduits base de pltre pour le btiment - Partie 1: Dfinitions et exigences Gipsbinder und Gipstrockenmrtel - Teil 1: Begriffe und Anforderungen This European Standard was approved by CEN on 11 July 2008. CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipula
3、te the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN Management Centre or to any CEN member. This European Standard ex
4、ists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same status as the official versions. CEN members are the national standards
5、 bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom
6、. EUROPEAN COMMITTEE FOR STANDARDIZATION COMIT EUROPEN DE NORMALISATION EUROPISCHES KOMITEE FR NORMUNG Management Centre: rue de Stassart, 36 B-1050 Brussels 2008 CENAll rights of exploitation in any form and by any means reserved worldwide for CEN national Members. Ref. No. EN 13279-1:2008: E BS EN
7、 13279-1:2008 EN 13279-1:2008 (E) 2 Contents page Foreword3 Introduction.4 1Scope 5 2Normative references5 3Terms and definitions .6 4Types of gypsum binders and gypsum plasters8 5Requirements.8 6Evaluation of conformity.12 7Designation of gypsum binders and gypsum plasters14 8Marking, labelling and
8、 packaging14 Annex ZA (informative) Clauses of this European Standard addressing essential requirements or other provisions of EU Directives15 Bibliography20 ? BS EN 13279-1:2008 EN 13279-1:2008 (E) 3 Foreword This document (EN 13279-1:2008) has been prepared by Technical Committee CEN/CENELEC/TC 24
9、1 “ Gypsum and gypsum based products” , the secretariat of which is held by AFNOR. This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by February 2009, and conflicting national standards shall be withdr
10、awn at the latest by February 2009. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. CEN and/or CENELEC shall not be held responsible for identifying any or all such patent rights. This document supersedes EN 13279-1:2005. This sta
11、ndard differs from EN 13279-1:2005 as follows: a) definitions 3.1, 3.2, 3.9, 3.20 revised; b) definition and requirements for finishing products included. This document has been prepared under a mandate given to CEN by the European Commission and the European Free Trade Association, and supports ess
12、ential requirements of EU Directive(s). For relationship with EU Directive(s), see informative annex ZA, which is an integral part of this document. This European Standard on gypsum binders and gypsum plasters consists of two parts: Part 1: Definitions and requirements; Part 2: Test methods. Accordi
13、ng to the CEN/CENELEC Internal Regulations, the national standards organizations of the following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia,
14、 Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and the United Kingdom. ? BS EN 13279-1:2008 EN 13279-1:2008 (E) 4 Introduction Figure 1 shows the family of gypsum binders and gypsum plasters (see also Table 1): Figure 1 F
15、amily of gypsum binders and gypsum plasters Raw gypsum A1 Gypsum binders for direct use or further processing A2 Direct use on site A3 Further processing Gypsum plasters: B1 Gypsum building plaster B2 Gypsum based building plaster B3 Gypsum-lime building plaster B4 Lightweight gypsum building plaste
16、r B5 Lightweight gypsum based building plaster B6 Lightweight gypsum-lime building plaster B7 Gypsum plaster with enhanced surface hardness Gypsum plasters for special purposes: C1 Fibrous plasterworks C2 Gypsum mortar C3 Acoustic plaster C4 Thermal insulation plaster C5 Fire protection plaster C6 T
17、hin coat plaster, finishing product Manufactured elements, e. g.: Gypsum plasterboards Gypsum blocks Gypsum elements for suspended ceilings Gypsum boards with fibrous reinforcement ? BS EN 13279-1:2008 EN 13279-1:2008 (E) 5 1 Scope This European Standard specifies the characteristics and performance
18、 of powder products based on gypsum binder for building purposes. This includes premixed gypsum building plasters for plastering of walls and ceilings inside buildings where they are applied as a finishing material which can be decorated. These products are specially formulated to meet their applica
19、tion requirements by the use of additives/admixtures, aggregates and other binders. Gypsum and gypsum based building plasters for manual and mechanical applications are included. This European Standard also applies to gypsum binders both for direct use on site and for further processing into gypsum
20、blocks, gypsum plasterboards, gypsum boards with fibrous reinforcement, gypsum fibrous plasterwork and gypsum ceiling elements. Gypsum mortar for internal not load bearing partitions not exposed to water is also included. Calcium sulfate used as binder for floor screeds is not covered by this Europe
21、an Standard. This European Standard defines the reference tests for technical characteristics and provides for the evaluation of conformity of the products covered by this European Standard. Building lime, as calcium hydroxide, can be used as an additional binder together with gypsum binder. If gyps
22、um binder is the principle active binding component in a plaster then this plaster is covered by this European Standard. If building lime is the principle active binding component in a plaster then the plaster is covered by EN 998-1. 2 Normative references The following referenced documents are indi
23、spensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. EN 12664, Thermal performance of building materials and products Determination of thermal re
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- BS EN 13279-1-2008 Gypsum binders and plasters Part Definitions requirements 13279 2008
链接地址:https://www.31doc.com/p-3647187.html