BS EN 61158-4-13-2008 工业通讯网络.现场总线规范.数据链路层协议规范.13型元件.pdf
《BS EN 61158-4-13-2008 工业通讯网络.现场总线规范.数据链路层协议规范.13型元件.pdf》由会员分享,可在线阅读,更多相关《BS EN 61158-4-13-2008 工业通讯网络.现场总线规范.数据链路层协议规范.13型元件.pdf(86页珍藏版)》请在三一文库上搜索。
1、BRITISH STANDARD BS EN 61158-4-13:2008 Industrial communication networks Fieldbus specifications Part 4-13: Data-link layer protocol specification Type 13 elements ICS 25.040.40; 35.100.20 BS EN 61158-4-13:2008 This British Standard was published under the authority of the Standards Policy and Strat
2、egy Committee on 30 May 2008 BSI 2008 ISBN 978 0 580 61582 5 National foreword This British Standard is the UK implementation of EN 61158-4-13:2008. It is identical with IEC 61158-4-13:2007. Together with all of the other sections of BS EN 61158-4, it supersedes BS EN 61158-4:2004 which is withdrawn
3、. The UK participation in its preparation was entrusted to Technical Committee AMT/7, Industrial communications Process measurement and control, including Fieldbus. A list of organizations represented on this committee can be obtained on request to its secretary. This publication does not purport to
4、 include all the necessary provisions of a contract. Users are responsible for its correct application. Compliance with a British Standard cannot confer immunity from legal obligations. Amendments/corrigenda issued since publication DateComments EUROPEAN STANDARD EN 61158-4-13 NORME EUROPENNE EUROPI
5、SCHE NORM February 2008 CENELEC European Committee for Electrotechnical Standardization Comit Europen de Normalisation Electrotechnique Europisches Komitee fr Elektrotechnische Normung Central Secretariat: rue de Stassart 35, B - 1050 Brussels 2008 CENELEC - All rights of exploitation in any form an
6、d by any means reserved worldwide for CENELEC members. Ref. No. EN 61158-4-13:2008 E ICS 35.100.20; 25.040.40 Partially supersedes EN 61158-4:2004 English version Industrial communication networks - Fieldbus specifications - Part 4-13: Data-link layer protocol specification - Type 13 elements (IEC 6
7、1158-4-13:2007) Rseaux de communication industriels - Spcifications des bus de terrain - Partie 4-13: Spcification des protocoles des couches de liaison de donnes - Elments de type 13 (CEI 61158-4-13:2007) Industrielle Kommunikationsnetze - Feldbusse - Teil 4-13: Protokollspezifikation des Data Link
8、 Layer (Sicherungsschicht) - Typ 13-Elemente (IEC 61158-4-13:2007) This European Standard was approved by CENELEC on 2008-02-01. CENELEC members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national sta
9、ndard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the Central Secretariat or to any CENELEC member. This European Standard exists in three official versions (English, French, German). A version in any ot
10、her language made by translation under the responsibility of a CENELEC member into its own language and notified to the Central Secretariat has the same status as the official versions. CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Cyprus, the Czech Repu
11、blic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, the Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and the United Kingdom. Foreword The text of document 65C/474/FDIS, fut
12、ure edition 1 of IEC 61158-4-13, prepared by SC 65C, Industrial networks, of IEC TC 65, Industrial-process measurement, control and automation, was submitted to the IEC-CENELEC parallel vote and was approved by CENELEC as EN 61158-4-13 on 2008-02-01. This and the other parts of the EN 61158-4 series
13、 supersede EN 61158-4:2004. With respect to EN 61158-4:2004 the following changes were made: deletion of Type 6 fieldbus, and the placeholder for a Type 5 fieldbus data-link layer, for lack of market relevance; addition of new fieldbus types; partition into multiple parts numbered 4-1, 4-2, , 4-19.
14、The following dates were fixed: latest date by which the EN has to be implemented at national level by publication of an identical national standard or by endorsement (dop) 2008-11-01 latest date by which the national standards conflicting with the EN have to be withdrawn (dow) 2011-02-01 NOTE Use o
15、f some of the associated protocol types is restricted by their intellectual-property-right holders. In all cases, the commitment to limited release of intellectual-property-rights made by the holders of those rights permits a particular data-link layer protocol type to be used with physical layer an
16、d application layer protocols in type combinations as specified explicitly in the EN 61784 series. Use of the various protocol types in other combinations may require permission from their respective intellectual-property-right holders. Annex ZA has been added by CENELEC. _ Endorsement notice The te
17、xt of the International Standard IEC 61158-4-13:2007 was approved by CENELEC as a European Standard without any modification. _ BS EN 61158-4-13:2008 2 CONTENTS INTRODUCTION. 1 Scope. 1.1 General . 1.2 Specifications 1.3 Procedures 1.4 Applicability. 1.5 Conformance. 2 Normative references . 3 Terms
18、, definitions, symbols and abbreviations 3.1 Reference model terms and definitions 3.2 Service convention terms and definitions.1 3.3 Data-link service terms and definitions 1 3.4 Symbols and abbreviations1 3.5 Common conventions 1 3.6 Additional conventions 1 4 Overview of the DL-protocol . 4.1 Ove
19、rview.1 4.2 General description .1 4.3 Service assumed from the PhL2 4.4 DLL architecture2 4.5 Local parameters and variables.2 5 General structure and encoding of PhIDUs and DLPDU and related elements of procedure.2 5.1 Overview.2 5.2 MA_PDU structure and encoding.2 5.3 Common MAC frame structure,
20、encoding and elements of procedure 2 5.4 Invalid DLPDU.2 6 DLPDU-specific structure, encoding and elements of procedure.2 6.1 General .2 6.2 Overview. 6.3 Start of synchronization (SoC). 6.4 PollRequest (PReq).3 6.5 Poll response (PRes) 3 6.6 Start of asynchronous (SoA)3 6.7 Asynchronous send (ASnd)
21、 .4 7 DLE elements of procedure 4 7.1 Overall structure4 7.2 Cycle state machine (CSM) .4 7.3 Isochronous transmission TX/RX control (ITC) 6 7.4 Asynchronous transmission TX/RX control (ATC) 6 7.5 Asynchronous slot scheduler (ASS).7 7.6 Exception signaling (ES) .7 7.7 NMT signaling (NS) .7 7.8 DLL m
22、anagement protocol.7 Bibliography8 - - - - . BS EN 61158-4-13:2008 3 Figure 1 Relationships of DLSAPs, DLSAP-addresses and group DL-addresses1 Figure 2 Slot communication network management Figure 3 Overall flow of data frames during one cycle Figure 4 Interaction of PhS primitives to DLE.2 Figure 5
23、 Data-link layer internal architecture2 Figure 6 Type 13 fieldbus DLPDU.2 Figure 7 State transition diagram of the MNs CSM.5 Figure 8 State transition diagram of MNs CSM at CSM_MS_NON_CYCLIC .5 Figure 9 State transition diagram of MNs CSM at CSM_MS_CYCLIC.5 Figure 10 State transition diagram of the
24、CNs CSM .5 Figure 11 State transition diagram of CNs CSM at CSM_CS_NON_CYCLIC Figure 12 State transition diagram of CNs CSM at CSM_CS_CYCLIC6 Figure 13 Multiple slot assignment.6 Figure 14 State transition diagram of ITC.6 Figure 15 State transition diagram of ATC .7 Figure 16 State transition diagr
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- BS EN 61158-4-13-2008 工业通讯网络.现场总线规范.数据链路层协议规范.13型元件 61158 13 2008 工业 通讯 网络 现场总线 规范 数据链 协议 元件
链接地址:https://www.31doc.com/p-3647833.html