BS EN 813-1997 防止坠落的个人保护装置.坐骑用带状装置.pdf
《BS EN 813-1997 防止坠落的个人保护装置.坐骑用带状装置.pdf》由会员分享,可在线阅读,更多相关《BS EN 813-1997 防止坠落的个人保护装置.坐骑用带状装置.pdf(14页珍藏版)》请在三一文库上搜索。
1、| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | BRITISH STANDARD BS EN 813 : 1997 The Euro
2、pean Standard EN 813 : 1997 has the status of a British Standard ICS 13.340.99 NO COPYING WITHOUT BSI PERMISSION EXCEPT AS PERMITTED BY COPYRIGHT LAW Personal protective equipment for prevention of falls from a height Sit harnesses BS EN 813 : 1997 This British Standard, having been prepared under t
3、he direction of the Health and Environment Sector Board, was published under the authority of the Standards Board and comes into effect on 15 June 1997 BSI 1997 The following BSI references relate to the work on this standard: Committee reference PH/5 Draft for comment 92/43615 DC ISBN 0 580 27606 6
4、 Amendments issued since publication Amd. No.DateText affected Committees responsible for this British Standard The preparation of this British Standard was entrusted to Technical Committee PH/5, Industrial safety belts and harnesses, upon which the following bodies were represented: Arboricultural
5、Safety Council Association of Consulting Scientists British Constructional Steelwork Association Ltd. British Electrical Systems Association (BEAMA Ltd.) British Narrow Fabrics Association British Telecommunications plc Confederation of British Forgers Construction Fixings Association Cordage Manufa
6、cturers Institute Electricity Association Federation of the Electronics Industry Health and Safety Executive Industrial Rope Access Trade Association National Engineering Laboratory National Federation of Master Steeplejacks and Lightning Conductor Engineers SATRA Footwear Technology Centre Safety E
7、quipment Association Suspended Access Equipment Manufacturers Association TES Bretby Limited BSI 1997i BS EN 813 : 1997 1)Undated in the text. National foreword This British Standard has been prepared by Technical Committee PH/5, and is the English language version of EN 813 : 1997 Personal protecti
8、ve equipment for prevention of falls from a height Sit harnesses, published by the European Committee for Standardization (CEN). Cross-references Publication referred toCorresponding British Standard EN 358 : 19921)BS EN 358 : 1993 Personal protective equipment for work positioning and prevention of
9、 falls from a height Work positioning systems EN 364 : 1992BS EN 364 : 1993 Personal protective equipment against falls from a height Test methods EN 365 : 19921)BS EN 365 : 1993 Personal protective equipment against falls from a height General requirements for use and for marking Compliance with a
10、British Standard does not of itself confer immunity from legal obligations. Summary of pages This document comprises a front cover, an inside front cover, pages i and ii, the EN title page, pages 2 to 8, an inside back cover and a back cover. iiblank ? CEN European Committee for Standardization Comi
11、te Europe en de Normalisation Europa isches Komitee fu r Normung Central Secretariat: rue de Stassart 36, B-1050 Brussels 1997 Copyright reserved to CEN members Ref. No. EN 813 : 1997 E EUROPEAN STANDARDEN 813 NORME EUROPE ENNE EUROPA ISCHE NORM February 1997 ICS 13.340.20 Descriptors: Personal prot
12、ective equipment, protection against fall, accident prevention, height, safety devices, safety harnesses, specifications, design, manufacturing, tests, marking, labelling, packing English version Personal protective equipment for prevention of falls from a height Sit harnesses Equipement de protecti
13、on individuelle pour la pre vention contre les chutes de hauteur Ceintures a cuissardes Perso nliche Schutzausru stung zur Verhinderung von Abstu rzen Sitzgurte This European Standard was approved by CEN on 1997-01-11. CEN members are bound to comply with the CEN/CENELEC Internal Regulations which s
14、tipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the Central Secretariat or to any CEN member. This European Standar
15、d exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the Central Secretariat has the same status as the official versions. CEN members are the national standar
16、ds bodies of Austria, Belgium, Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and United Kingdom. ? Page 2 EN 813 : 1997 BSI 1997 Foreword This European Standard has been prepared by Technical Committee CEN/TC
17、160, Protection against falls from a height including working belts, the secretariat of which is held by DIN. This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by August 1997, and conflicting national
18、standards shall be withdrawn at the latest by August 1997. This European Standard has been prepared under a mandate given to CEN by the European Commission and the European Free Trade Association and supports essential requirements of the EU Directive(s). For relationship with EU Directive(s), see i
19、nformative Annex ZA, which is an integral part of this standard. According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following countries are bound to implement this European Standard: Austria, Belgium, Denmark, Finland, France, Germany, Greece, Iceland, Ire
20、land, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and the United Kingdom. Contents Page Foreword2 1Scope3 2Normative references3 3Definitions3 3.1element3 3.2component3 3.3sit harness fastening and adjustment element3 3.4sit harness attachment element3 3.5sit harness
21、3 3.6load bearing parts4 3.7non load bearing parts4 4Requirements4 4.1Ergonomics4 4.2Design, materials and construction4 4.2.1Materials4 4.2.2Attachment elements4 4.2.3Load bearing parts4 4.2.4Sit harness fastening and adjustment elements5 4.2.5Visual inspection5 4.2.6Dynamic performance5 4.2.7Stati
22、c strength5 5Test methods5 5.1Dynamic performance tests5 5.1.1Apparatus5 5.1.2Test method5 5.2Static strength test6 5.2.1Apparatus6 5.2.2Test method6 5.3Load bearing parts test6 6Marking7 7Information to be supplied by the manufacturer including instructions for use7 Annex ZA(informative) Clauses of
23、 this European Standard addressing essential requirements or other provisions of EU Directives8 ? Page 3 EN 813 : 1997 BSI 1997 1 Attachment element 2 Straps connecting leg loops to waist belt 3 Leg loop 4 Sit strap 5 Fastening and adjustment element Figure 1. Examples of sit harnesses and elements
24、1 Scope This standard specifies requirements, testing, marking and instructions for use of sit harnesses for use in work positioning and restraint systems, where a low point of attachment is required. Sit harnesses are not suitable to be used for fall arrest purposes. 2 Normative references This Eur
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- BS EN 813-1997 防止坠落的个人保护装置.坐骑用带状装置 813 1997 防止 坠落 个人 保护装置 坐骑 带状 装置
链接地址:https://www.31doc.com/p-3648240.html