IEEE Std 1277-2010 IEEE Standard General Requirements and Test Code for Dry-Type and Oil-Immersed Smoothing Reactors for DC Power Transmission.pdf
《IEEE Std 1277-2010 IEEE Standard General Requirements and Test Code for Dry-Type and Oil-Immersed Smoothing Reactors for DC Power Transmission.pdf》由会员分享,可在线阅读,更多相关《IEEE Std 1277-2010 IEEE Standard General Requirements and Test Code for Dry-Type and Oil-Immersed Smoothing Reactors for DC Power Transmission.pdf(108页珍藏版)》请在三一文库上搜索。
1、? ? ? ? ? ? !?“?#?$? ?%? +1 978 750 8400. Permission to photocopy portions of any individual standard for educational classroom use can also be obtained through the Copyright Clearance Center. Authorized licensed use limited to: Tsinghua University Library. Downloaded on December 25,2010 at 10:35:06
2、 UTC from IEEE Xplore. Restrictions apply. Introduction This introduction is not part of IEEE Std 1277-2010, IEEE Standard General Requirements and Test Code for Dry- Type and Oil-Immersed Smoothing Reactors for DC Power Transmission. In 1986 the Transformers Committee of the Institute of Electrical
3、 and Electronic Engineers created the HVDC Converter Transformers and Smoothing Reactors Subcommittee. This committee developed from the working group that prepared paper 85 SM 375-1, “Recommended Dielectric Tests and Test Procedures for Converter Transformers and Smoothing Reactors.” Although smoot
4、hing reactors for HVDC application have been built and operated for over 30 years, prior to IEEE Std 1277 there were only a limited number of papers, guides, and standards available that presented suggested dielectric tests for the HVDC equipment (see Annex G of this standard for a list of some of t
5、he most relevant documents). The IEC reactor standard IEC 60076-6:2007 B9 also covers smoothing reactors in a specific clause; focus is not, however, application-specifi c.a With the increased activity in HVDC transmission, there was a signifi cant need for a standard specifi cally covering the requ
6、irements and testing of smoothing reactors for HVDC applications, and the fi rst responsibility of the new subcommittee was to create proposed standards for converter transformers and smoothing reactors for HVDC application. Two separate standards were developedone for oil-fi lled converter transfor
7、mers and one for both dry-type and oil-fi lled smoothing reactors. IEEE Std 1277 was originally released in 2000 as “trial use” and, approximately two years later in 2002, was granted “full use” status. Signifi cant accomplishments of IEEE Std 1277-2000 included: a) Establishment of dielectric tests
8、 on HVDC equipment. In addition to the polarity reversal and 1 h dc tests recommended by previous papers, a special 1 h ac-applied voltage test was included for oil- fi lled smoothing reactors to demonstrate insulation integrity for service conditions. b) A consistent test methodology was developed
9、for both oil-immersed and dry-type air-core smoothing reactors that reflects both in-service operating stresses as well as current test equipment capability. The purpose of this current revision is the same as the original document, which is to define requirements and test code for dry-type and oil-
10、immersed smoothing reactors for HVDC application. Although requirements are usually construction independent, test code is not, and the revision of the standard will continue to reflect this characteristic. This revision is required to upgrade test code, design considerations and application informa
11、tion based on feedback from manufacturers and “end users”dry-type or oil- immersed specific when required. Test code methodology has been modified to reflect current technology. Notice to users Laws and regulations Users of these documents should consult all applicable laws and regulations. Complian
12、ce with the provisions of this standard does not imply compliance to any applicable regulatory requirements. Implementers of the standard are responsible for observing or referring to the applicable regulatory requirements. IEEE does not, by the publication of its standards, intend to urge action th
13、at is not in compliance with applicable laws, and these documents may not be construed as doing so. a The numbers in brackets correspond to those of the bibliography in Annex G. iv Copyright 2010 IEEE. All rights reserved. Authorized licensed use limited to: Tsinghua University Library. Downloaded o
14、n December 25,2010 at 10:35:06 UTC from IEEE Xplore. Restrictions apply. Copyrights This document is copyrighted by the IEEE. It is made available for a wide variety of both public and private uses. These include both use, by reference, in laws and regulations, and use in private self- regulation, s
15、tandardization, and the promotion of engineering practices and methods. By making this document available for use and adoption by public authorities and private users, the IEEE does not waive any rights in copyright to this document. Updating of IEEE documents Users of IEEE standards should be aware
16、 that these documents may be superseded at any time by the issuance of new editions or may be amended from time to time through the issuance of amendments, corrigenda, or errata. An official IEEE document at any point in time consists of the current edition of the document together with any amendmen
17、ts, corrigenda, or errata then in effect. In order to determine whether a given document is the current edition and whether it has been amended through the issuance of amendments, corrigenda, or errata, visit the IEEE Standards Association web site at http:/ieeexplore.ieee.org/xpl/standards.jsp, or
18、contact the IEEE at the address listed previously. For more information about the IEEE Standards Association or the IEEE standards development process, visit the IEEE-SA web site at http:/standards.ieee.org. Errata Errata, if any, for this and all other standards can be accessed at the following URL
19、: http:/standards.ieee.org/reading/ieee/updates/errata/index.html. Users are encouraged to check this URL for errata periodically. Interpretations Current interpretations can be accessed at the following URL: http:/standards.ieee.org/reading/ieee/interp/ index.html. Patents Attention is called to th
20、e possibility that implementation of this standard may require use of subject matter covered by patent rights. By publication of this standard, no position is taken with respect to the existence or validity of any patent rights in connection therewith. The IEEE is not responsible for identifying Ess
21、ential Patent Claims for which a license may be required, for conducting inquiries into the legal validity or scope of Patents Claims or determining whether any licensing terms or conditions provided in connection with submission of a Letter of Assurance, if any, or in any licensing agreements are r
22、easonable or non-discriminatory. Users of this standard are expressly advised that determination of the validity of any patent rights, and the risk of infringement of such rights, is entirely their own responsibility. Further information may be obtained from the IEEE Standards Association. v Copyrig
23、ht 2010 IEEE. All rights reserved. Authorized licensed use limited to: Tsinghua University Library. Downloaded on December 25,2010 at 10:35:06 UTC from IEEE Xplore. Restrictions apply. vi Copyright 2010 IEEE. All rights reserved. Participants At the time this standard was submitted to the IEEE-SA St
24、andards Board for approval, the HVDC Converter Transformers and Smoothing Reactors Working Group had the following membership: Richard F. Dudley, Chair Sten Andersson Jack Aromin Gene Blackburn Fred E. Elliot Joseph Foldi Alan C. Forrest Jan Hajek Peter Heinzig Lars-Erik Juhlin Robyn L. Page Klaus P
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- IEEE Std 1277-2010 Standard General Requirements and Test Code for Dry-Type Oil-Immersed Smoothing Reactors 1277
链接地址:https://www.31doc.com/p-3658213.html