IEEE Std 1247-2006 IEEE Standard for Interrupter Switches for Alternating Current, Rated Above 1000 V.pdf
《IEEE Std 1247-2006 IEEE Standard for Interrupter Switches for Alternating Current, Rated Above 1000 V.pdf》由会员分享,可在线阅读,更多相关《IEEE Std 1247-2006 IEEE Standard for Interrupter Switches for Alternating Current, Rated Above 1000 V.pdf(72页珍藏版)》请在三一文库上搜索。
1、IEEE Std 1247-2005 (Revision of IEEE Std 1247-1998) IEEE Standard for Interrupter Switches for Alternating Current, Rated Above 1000 V I E E E 3 Park Avenue New York, NY 10016-5997, USA 6 June 2006 IEEE Power Engineering Society Sponsored by the Switchgear Committee Recognized as an American Nationa
2、l Standard (ANSI) IEEE Std 1247-2005 (Revision of IEEE Std 1247-1998) IEEE Standard for Interrupter Switches for Alternating Current, Rated Above 1000 Volts Sponsor Switchgear Committee of the IEEE Power Engineering Society Approved 28 March 2006 American National Standards Institute Approved 7 Dece
3、mber 2005 IEEE-SA Standards Board The Institute of Electrical and Electronics Engineers, Inc. 3 Park Avenue, New York, NY 10016-5997, USA Copyright 2006 by the Institute of Electrical and Electronics Engineers, Inc. All rights reserved. Published 6 June 2006. Printed in the United States of America.
4、 IEEE is a registered trademark in the U.S. Patent +1 978 750 8400. Permission to photocopy portions of any individual standard for educational classroom use can also be obtained through the Copyright Clearance Center. NOTEAttention is called to the possibility that implementation of this standard m
5、ay require use of subject matter covered by patent rights. By publication of this standard, no position is taken with respect to the existence or validity of any patent rights in connection therewith. The IEEE shall not be responsible for identifying patents for which a license may be required by an
6、 IEEE standard or for conducting inquiries into the legal validity or scope of those patents that are brought to its attention. iv Copyright 2006 IEEE. All rights reserved. Introduction Over many years, standards covering interrupter switches have been developed in subcommittees other than the High
7、Voltage Switch Subcommittee. As a result, different and sometimes conflicting requirements for interrupter switches have been developed. Where there is a clear need for different requirements in different applications, diverging standards are appropriate. However, where application requirements are
8、similar, the body of standards should treat the requirements uniformly. As a result of this philosophy, the Switchgear Administrative Subcommittee passed the following motion at the May 1991 meeting in Fort Lauderdale. In an effort to promote a uniform approach to standards, the following policy is
9、set: Future standards and revisions to standards that incorporate fuses, switches, circuit breakers, and/or reclosers and sectionalizers shall reference the basic fuse, switch, circuit breaker, and/or recloser and sectionalizer standard wherever possible and treat material differently only when ther
10、e are unique application requirements. This standard was written to provide the basic standard for interrupter switches. As such, an attempt was made to encompass as many different types of interrupter switches as practical. This standard has also provided the opportunity to update and revise the ge
11、neral treatment of interrupter switches, and address newer technologies that are being used to provide switching functions. Part of the heritage of this document comes from the treatment of interrupter switches in other IEEE C37 standards. It is anticipated that material relating to interrupter swit
12、ches, currently in the IEEE C37.30 series, will be removed from those documents when this document is published. Further, when this document is published, it is anticipated that other standards, not in the IEEE C37.30 series, will begin to reference this document, as outlined in the above AdsCom mot
13、ion. Although this standard does not apply to circuit-breakers, circuit-switchers, or reclosers, standards for circuit-breakers, circuit-switchers, and reclosers should reference this document for their load-interrupting requirements. A further intent of this document is to provide test circuits to
14、be used to establish ratings for common applications of switching devices not generally covered by standards. Although this document will be published before the work on IEEE Std C37.100.1 (Common Clauses) is finished, it is the intention of the Interrupter Switch Working Group to adopt or reference
15、 common clauses as they become available. Specifically the treatment of: Altitude correction factors, and Total temperature limits for contacts, connections, and insulation will conform to the Common Clauses Document. Conformance and field testing are not covered in this document. The user is referr
16、ed to apparatus-specific test documents such as IEEE Std C37.41, ANSI C37.57, and ANSI C37.58. This standard has adopted the approach of many other standards in avoiding asymmetrical current ratings. For example, the traditional momentary (asymmetrical) current rating is now covered in the peak curr
17、ent withstand. Because of the lack of a need to calculate asymmetrical currents, and the common use of data This introduction is not part of IEEE Std 1247-2005, IEEE Standard for Interrupter Switches for Alternating Current, Rated Above 1000 Volts. 标准分享网 w w w .b z f x w .c o m 免费下载 v Copyright 2006
18、 IEEE. All rights reserved. acquisition systems (which automatically calculate rms currents), IEEE Std C37.09 is not referenced as a means to determine symmetrical or asymmetrical values. The actual revision is limited to the correction of technical errors that have been identified in subclauses 8.3
19、.1.3, 8.3.2.1, 8.3.2.2.1, 8.3.2.5 and 8.2.2.6, 8.3.2.3, and 8.3.2.6; Figures 1, 2, 3, 4, 7, 8, 9, 10, and 11; and Tables 6, 7, and 9. Notice to users Errata Errata, if any, for this and all other standards can be accessed at the following URL: http:/ standards.ieee.org/reading/ieee/updates/errata/in
20、dex.html. Users are encouraged to check this URL for errata periodically. Interpretations Current interpretations can be accessed at the following URL: http:/standards.ieee.org/reading/ieee/interp/ index.html. Patents Attention is called to the possibility that implementation of this standard may re
21、quire use of subject matter covered by patent rights. By publication of this standard, no position is taken with respect to the existence or validity of any patent rights in connection therewith. The IEEE shall not be responsible for identifying patents or patent applications for which a license may
22、 be required to implement an IEEE standard or for conducting inquiries into the legal validity or scope of those patents that are brought to its attention. vi Copyright 2006 IEEE. All rights reserved. Participants At the time this standard was completed, the working group had the following membershi
23、p: Lyne Brisson, Co-Chair Marcel Fortin, Co-Chair The following members of the individual balloting committee voted on this standard. Balloters may have voted for approval, disapproval, or abstention. John Angelis Charles Ball Frank DeCesaro Jim Domo Erik M. Guillot Ronald Lavorin Peter Meyer Radakr
24、ishna Ranjan David Stone Jan Zawadzki Roy Alexander Chris Ambrose Edwin Averill Charles Ball W. J. (Bill) Bergman Edward Bertolini Behdad Biglar Lyne Brisson Robert Brown Ted Burse Eldridge R. Byron Raymond Capra Tommy Cooper Ronald Daubert Alexander Dixon Randall Dotson Denis Dufournet Doug Edwards
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- IEEE Std 1247-2006 Standard for Interrupter Switches Alternating Current Rated Above 1000 1247 2006
链接地址:https://www.31doc.com/p-3659526.html