SAE J1865-1999 Dimensional Compatibility for Commercial Vehicles Fitment of Complete Wheels.pdf
《SAE J1865-1999 Dimensional Compatibility for Commercial Vehicles Fitment of Complete Wheels.pdf》由会员分享,可在线阅读,更多相关《SAE J1865-1999 Dimensional Compatibility for Commercial Vehicles Fitment of Complete Wheels.pdf(6页珍藏版)》请在三一文库上搜索。
1、SAE Technical Standards Board Rules provide that: “This report is published by SAE to advance the state of technical and engineering sciences. The use of this report is entirely voluntary, and its applicability and suitability for any particular use, including any patent infringement arising therefr
2、om, is the sole responsibility of the user.” SAE reviews each technical report at least every five years at which time it may be reaffirmed, revised, or cancelled. SAE invites your written comments and suggestions. QUESTIONS REGARDING THIS DOCUMENT: (724) 772-8512 FAX: (724) 776-0243 TO PLACE A DOCU
3、MENT ORDER: (724) 776-4970 FAX: (724) 776-0790 SAE WEB ADDRESS http:/www.sae.org Copyright 1999 Society of Automotive Engineers, Inc. All rights reserved.Printed in U.S.A. SURFACE VEHICLE 400 Commonwealth Drive, Warrendale, PA 15096-0001 RECOMMENDED PRACTICE Submitted for recognition as an American
4、National Standard J1865 ISSUED JUN1999 Issued1999-06 Dimensional Compatibility for Commercial Vehicles Fitment of Complete Wheels 1.Scope This SAE Recommended Practice defines a clearance line for establishing dimensional compatibility between drum brakes and wheels with 19.5 in, 22.5 in, and 24.5 i
5、n diameter rims. The clearance line establishes the maximum envelope for brakes and minimum envelope for complete wheels to allow for interchangeability. This document addresses the dimensional characteristics only, and makes no reference to the performance, operational dynamic deflections, or heat
6、dissipation of the system. Valve clearances have not been included in the fitment lines. Bent valves may be required to clear brake drums. Mounting systems as noted are referenced in SAE J694. 2.References 2.1Applicable Publications The following publications form a part of this specification to the
7、 extent specified herein. Unless otherwise specified, the latest issue of SAE publications shall apply. 2.1.1SAE PUBLICATIONS Available from SAE, 400 Commonwealth Drive, Warrendale, PA 15096-0001. SAE J393 Nomenclature Wheels, Hubs, and Rims for Commercial Vehicles SAE J694 Disc Wheel/Hub or Drum In
8、terface Dimensions Commercial Vehicles 2.2Related Publications The following publications are provided for information purposes only and are not a required part of this document. 2.2.1SAE PUBLICATION Available from SAE, 400 Commonwealth Drive, Warrendale, PA 15096-0001. SAE J2133 Disc Wheel Radial R
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- SAE J1865-1999 Dimensional Compatibility for Commercial Vehicles Fitment of Complete Wheels J1865 1999
链接地址:https://www.31doc.com/p-3678285.html