SAE J218-1981 PASSENGER CAR IDENTIFICATION TERMINOLOGY.pdf
《SAE J218-1981 PASSENGER CAR IDENTIFICATION TERMINOLOGY.pdf》由会员分享,可在线阅读,更多相关《SAE J218-1981 PASSENGER CAR IDENTIFICATION TERMINOLOGY.pdf(4页珍藏版)》请在三一文库上搜索。
1、SAE Technical Standards Board Rules provide that: “This report is published by SAE to advance the state of technical and engineering sciences. The use of this report is entirely voluntary, and its applicability and suitability for any particular use, including any patent infringement arising therefr
2、om, is the sole responsibility of the user.” SAE reviews each technical report at least every five years at which time it may be reaffirmed, revised, or cancelled. SAE invites your written comments and suggestions. QUESTIONS REGARDING THIS DOCUMENT: (412) 772-8512 FAX: (412) 776-0243 TO PLACE A DOCU
3、MENT ORDER; (412) 776-4970 FAX: (412) 776-0790 http:www.sae.org Copyright 1981 Society of Automotive Engineers, Inc. All rights reserved.Printed in U.S.A. SURFACE VEHICLE 400 Commonwealth Drive, Warrendale, PA 15096-0001 RECOMMENDED PRACTICE Submitted for recognition as an American National Standard
4、 J218 REV. DEC81 Issued1971-01 Revised1981-12 Superseding J218 JAN71 (R) PASSENGER CAR IDENTIFICATION TERMINOLOGY ForewordThis Document has not changed other than to put it into the new SAE Technical Standards Board Format. 1.ScopeThis recommended practice is intended to provide uniform nomenclature
5、 and definitions for the primary levels of vehicle identification, with particular application to passenger cars. 2.References 2.1Applicable PublicationsThe following publications form a part of the specification to the extent specified herein. Unless otherwise indicated the lastest revision of SAE
6、publications shall apply. 2.1.1SAE PUBLICATIONSAvailable from SAE, 400 Commonwealth Drive, Warrendale, PA 15096-0001. SAE J272cVehicle Identification Number Systems SAE J853aVehicle Identification Numbers 3.Definitions 3.1Passenger CarA motor vehicle with motive power, except a multipurpose vehicle,
7、 motorcycle, or trailer, designed for carrying 10 persons or less. 3.2ManufacturerAny person, firm, or corporation engaged in the production or assembly of passenger cars. 3.3MakeA distinctive name, applied to a group of vehicles from one manufacturer, which may be further subdivided, such as: car l
8、ine, body type, etc. (See Figures 1 and 2). Typical examples of hypothetical terminology in Figure 2 applied to four United States passenger car manufacturers: Manufacturer:GMFordChryslerAM Make:ChevroletMercuryDodgeRambler Car Line:Malibu Classicetc.Ariesetc. Series:Malibuetc.Aries SEetc. Body Type
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- SAE J218-1981 PASSENGER CAR IDENTIFICATION TERMINOLOGY J218 1981
链接地址:https://www.31doc.com/p-3678328.html