08-30143688-DC.pdf
《08-30143688-DC.pdf》由会员分享,可在线阅读,更多相关《08-30143688-DC.pdf(19页珍藏版)》请在三一文库上搜索。
1、a Date: 19 December 2008 Origin: International Latest date for receipt of comments: 31 March 2009 Project no.: 2005/03224 Responsible committee: IST/34 Automatic identification and data capture techniques Interested committees: Title: Draft ISO/IEC 15961-3 Information technology - Radio frequency id
2、entification (RFID) for item management: Data protocol Part 3 : Data protocol: RFID data constructs Supersession information: If this document is published as a standard, the UK implementation of it will supersede NONE and partially supersede. NONE If you are aware of a current national standard whi
3、ch may be affected, please notify the secretary (contact details below). WARNING: THIS IS A DRAFT AND MUST NOT BE REGARDED OR USED AS A BRITISH STANDARD. THIS DRAFT IS NOT CURRENT BEYOND 31 March 2009. This draft is issued to allow comments from interested parties; all comments will be given conside
4、ration prior to publication. No acknowledgement will normally be sent. See overleaf for information on commenting. No copying is allowed, in any form, without prior written permission from BSI except as permitted under the Copyright, Designs and Patent Act 1988 or for circulation within a nominating
5、 organization for briefing purposes. Electronic circulation is limited to dissemination by e-mail within such an organization by committee members. Further copies of this draft may be purchased from BSI Customer Services, Tel: +44(0) 20 8996 9001 or email . British, International and foreign standar
6、ds are also available from BSI Customer Services. Information on the co-operating organizations represented on the committees referenced above may be obtained from the responsible committee secretary. Cross-references The British Standards which implement International or European publications refer
7、red to in this draft may be found via the British Standards Online Service on the BSI web site http:/. Direct tel: 020 8996 7431 Responsible Committee Secretary: Mrs J M Stride (BSI) E-mail: Draft for Public Comment Head Office 389 Chiswick High Road London W4 4AL Telephone: +44(0)20 8996 9000 Fax:
8、 +44(0)20 8996 7001 Form 36 Version 8.0 DPC: 08/30143688 DC Licensed Copy: London South Bank University, South Bank University, 02/02/2009 03:55, Uncontrolled Copy, (c) BSI b Introduction This draft standard is based on international discussions in which the UK has taken an active part. Your comment
9、s on this draft are welcome and will assist in the preparation of the consequent standard. There is a high probability that this text could be adopted by CENELEC as a reference document for harmonization or as a European Standard. Recipients of this draft are requested to comment on the text bearing
10、 in mind this possibility. UK Vote Please indicate whether you consider the UK should submit a negative (with reasons) or positive vote on this draft. BSI Committee Responsibilities Whether or not the standard is published in its original (international) form, or as a formal British Standard Impleme
11、ntation, the BSI committees responsibilities are to: - aid enquirers to understand the text; - present to the responsible international committee any enquiries on interpretation, or proposals for change, and keep UK interests informed; - monitor related International and European developments and pr
12、omulgate them in the UK. Submission The guidance given below is intended to ensure that all comments receive efficient and appropriate attention by the responsible BSI committee. Annotated drafts are not acceptable and will be rejected. All comments must be submitted, preferably electronically, to t
13、he Responsible Committee Secretary at the address given on the front cover. Comments should be compatible with Version 6.0 or Version 97 of Microsoft Word for Windows, if possible; otherwise comments in ASCII text format are acceptable. Any comments not submitted electronically should still adhere t
14、o these format requirements. All comments submitted should be presented as given in the example below. Further information on submitting comments and how to obtain a blank electronic version of a comment form are available from the BSI web site at: http:/ Template for comments and secretariat observ
15、ations Date: xx/xx/200x Document: ISO/DIS xxxxx 1 2 (3) 4 5 (6) (7) MB Clause No./ Subclause No./ Annex (e.g. 3.1) Paragraph/ Figure/Table/ Note (e.g. Table 1) Type of com- ment Comment (justification for change) by the MB Proposed change by the MB Secretariat observations on each comment submitted
16、3.1 Definition 1 ed Definition is ambiguous and needs clarifying. Amend to read . so that the mains connector to which no connection . 6.4 Paragraph 2 te The use of the UV photometer as an alternative cannot be supported as serious problems have been encountered in its use in the UK. Delete referenc
17、e to UV photometer. Microsoft and MS-DOS are registered trademarks, and Windows is a trademark of Microsoft Corporation. Licensed Copy: London South Bank University, South Bank University, 02/02/2009 03:55, Uncontrolled Copy, (c) BSI All rights reserved C031-N-2691 - FCD Text Basic template BASICEN3
18、 2002-06-01 ISO 2002 Reference number of working document: ISO/IEC JTC1/SC 31 N 2691 Date: 2008-12-09 Reference number of document: ISO/IEC CD 15961-3 Committee identification: ISO/IEC JTC 1/SC 31/WG 4 Secretariat: ANSI Information technology Radio frequency identification (RFID) for item management
19、 Part 3: Data protocol: RFID data constructs Technologies de linformation Identification par radiofrquence (RFID) pour le gestion dobjets Partie 3: Protocole de donnes: construction de donnes Warning This document is not an ISO International Standard. It is distributed for review and comment. It is
20、subject to change without notice and may not be referred to as an International Standard. Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are aware and to provide supporting documentation. S Document type: International st
21、andard Document subtype: if applicable Document stage: (20) Preparation Document language: E Licensed Copy: London South Bank University, South Bank University, 02/02/2009 03:55, Uncontrolled Copy, (c) BSI ISO/IEC 15961-3 ISO 2005 All rights reservedii Copyright notice This ISO document is a working
22、 draft or committee draft and is copyright-protected by ISO. While the reproduction of working drafts or committee drafts in any form for use by participants in the ISO standards development process is permitted without prior permission from ISO, neither this document nor any extract from it may be
23、reproduced, stored or transmitted in any form for any other purpose without prior written permission from ISO. Requests for permission to reproduce this document for the purpose of selling it should be addressed as shown below or to ISOs member body in the country of the requester: Indicate : the fu
24、ll address telephone number fax number telex number and electronic mail address as appropriate, of the Copyright Manager of the ISO member body responsible for the secretariat of the TC or SC within the framework of which the draft has been prepared Reproduction for sales purposes may be subject to
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- 08 30143688 DC
链接地址:https://www.31doc.com/p-3726396.html