09-30193035-DC.pdf
《09-30193035-DC.pdf》由会员分享,可在线阅读,更多相关《09-30193035-DC.pdf(10页珍藏版)》请在三一文库上搜索。
1、a Date: 19 January 2009 Origin: International Latest date for receipt of comments: 30 April 2009 Project no.: 2008/03786 Responsible committee: GEL/20/17 Low voltage cables Interested committees: Title: Draft BS EN 60811-506 Electric and optical fibre cables Test methods for non-metallic materials -
2、 Part 506: Mechanical tests - Impact test at low temperature for insulations and sheaths Supersession information: If this document is published as a standard, the UK implementation of it will supersede NONE and partially supersede. BSEN60811-1-4 : 1995 If you are aware of a current national standar
3、d which may be affected, please notify the secretary (contact details below). WARNING: THIS IS A DRAFT AND MUST NOT BE REGARDED OR USED AS A BRITISH STANDARD. THIS DRAFT IS NOT CURRENT BEYOND 30 April 2009. This draft is issued to allow comments from interested parties; all comments will be given co
4、nsideration prior to publication. No acknowledgement will normally be sent. See overleaf for information on commenting. No copying is allowed, in any form, without prior written permission from BSI except as permitted under the Copyright, Designs and Patent Act 1988 or for circulation within a nomin
5、ating organization for briefing purposes. Electronic circulation is limited to dissemination by e-mail within such an organization by committee members. Further copies of this draft may be purchased from BSI Customer Services, Tel: +44(0) 20 8996 9001 or email . British, International and foreign st
6、andards are also available from BSI Customer Services. Information on the co-operating organizations represented on the committees referenced above may be obtained from the responsible committee secretary. Cross-references The British Standards which implement International or European publications
7、referred to in this draft may be found via the British Standards Online Service on the BSI web site http:/. Direct tel: 0208 996 7281 Responsible Committee Secretary: Mr S Bounds (BSI) E-mail: Draft for Public Comment Head Office 389 Chiswick High Road London W4 4AL Telephone: +44(0)20 8996 9000 Fa
8、x: +44(0)20 8996 7001 Form 36 Version 8.0 DPC: 09/30193035 DC Licensed Copy: London South Bank University, South Bank University, 02/02/2009 03:23, Uncontrolled Copy, (c) BSI b Introduction This draft standard is based on international discussions in which the UK has taken an active part. Your comme
9、nts on this draft are welcome and will assist in the preparation of the consequent standard. There is a high probability that this text could be adopted by CENELEC as a reference document for harmonization or as a European Standard. Recipients of this draft are requested to comment on the text beari
10、ng in mind this possibility. UK Vote Please indicate whether you consider the UK should submit a negative (with reasons) or positive vote on this draft. Submission The guidance given below is intended to ensure that all comments receive efficient and appropriate attention by the responsible BSI comm
11、ittee. Annotated drafts are not acceptable and will be rejected. All comments must be submitted, preferably electronically, to the Responsible Committee Secretary at the address given on the front cover. Comments should be compatible with Version 6.0 or Version 97 of Microsoft Word for Windows, if p
12、ossible; otherwise comments in ASCII text format are acceptable. Any comments not submitted electronically should still adhere to these format requirements. All comments submitted should be presented as given in the example below. Further information on submitting comments and how to obtain a blank
13、electronic version of a comment form are available from the BSI web site at: http:/ Template for comments and secretariat observations Date: xx/xx/200x Document: ISO/DIS xxxxx 1 2 (3) 4 5 (6) (7) MB Clause No./ Subclause No./ Annex (e.g. 3.1) Paragraph/ Figure/Table/ Note (e.g. Table 1) Type of com-
14、 ment Comment (justification for change) by the MB Proposed change by the MB Secretariat observations on each comment submitted 3.1 Definition 1 ed Definition is ambiguous and needs clarifying. Amend to read . so that the mains connector to which no connection . 6.4 Paragraph 2 te The use of the UV
15、photometer as an alternative cannot be supported as serious problems have been encountered in its use in the UK. Delete reference to UV photometer. Microsoft and MS-DOS are registered trademarks, and Windows is a trademark of Microsoft Corporation. Licensed Copy: London South Bank University, South
16、Bank University, 02/02/2009 03:23, Uncontrolled Copy, (c) BSI FORM CD (IEC) 2008-08-01 20/1033/CD COMMITTEE DRAFT (CD) IEC/TC or SC: TC 20 Project number IEC 60811-506 Ed. 1.0 Title of TC/SC: Electric cables Date of circulation 2009-01-16 Closing date for comments 2009-03-20* Also of interest to the
17、 following committees SC 18A, TC 46, SC 46A, SC 46C, SC 86A Supersedes document 20/998/MCR Proposed horizontal standard Other TC/SCs are requested to indicate their interest, if any, in this CD to the TC/SC secretary Functions concerned: Safety EMC Environment Quality assurance Secretary: H Myland (
18、DE) THIS DOCUMENT IS STILL UNDER STUDY AND SUBJECT TO CHANGE. IT SHOULD NOT BE USED FOR REFERENCE PURPOSES. RECIPIENTS OF THIS DOCUMENT ARE INVITED TO SUBMIT, WITH THEIR COMMENTS, NOTIFICATION OF ANY RELEVANT PATENT RIGHTS OF WHICH THEY ARE AWARE AND TO PROVIDE SUPPORTING DOCUMENTATION. Title: IEC 6
19、0811-506 Ed. 1.0: Electric and optical fibre cables Test methods for non-metallic materials - Part 506: Mechanical tests - Impact test at low temperature for insulations and sheaths (Titre) : Introductory note This CD has been developed by WG 17 of TC 20. It is circulated in accordance with the deci
20、sion of TC 20 at its meeting in Rome on 16/17 October 2008 (20/1000/RM minute 9.1) Note that, in conjunction with advice from Central Office, the original (provisional) title has been improved. *NOTE: In accordance with SMB decision 133/16 (Sao Paulo, 2008) the secretary of IEC TC 2O has requested a
21、 period for comments of two months for this particular CD. Copyright 2009 International Electrotechnical Commission, IEC. All rights reserved. It is permitted to download this electronic file, to make a copy and to print out the content for the sole purpose of preparing National Committee positions.
22、 You may not copy or “mirror“ the file or printed version of the document, or any part of it, for any other purpose without permission in writing from IEC. Licensed Copy: London South Bank University, South Bank University, 02/02/2009 03:23, Uncontrolled Copy, (c) BSI 60811-506 ED 1.0/CD IEC 2 20/10
23、33/CD CONTENTS FOREWORD.3 1 Scope.5 2 Normative References5 3 Terms and definitions .5 4 Test Method .5 4.1 General.5 4.2 Sampling and preparation of the test pieces5 4.3 Apparatus6 4.4 Test conditions6 4.5 Procedure .6 4.6 Expression of results.7 5 Test report7 Licensed Copy: London South Bank Univ
24、ersity, South Bank University, 02/02/2009 03:23, Uncontrolled Copy, (c) BSI 60811-506 ED 1.0/CD IEC 3 20/1033/CD INTERNATIONAL ELECTROTECHNICAL COMMISSION _ ELECTRIC AND OPTICAL FIBRE CABLES TEST METHODS FOR NON-METALLIC MATERIALS Part 506: Mechanical tests - Impact test at low temperature for insul
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- 09 30193035 DC
链接地址:https://www.31doc.com/p-3726774.html