08-30193639-DC.pdf
《08-30193639-DC.pdf》由会员分享,可在线阅读,更多相关《08-30193639-DC.pdf(15页珍藏版)》请在三一文库上搜索。
1、a Date: 17 November 2008 Origin: European Latest date for receipt of comments: 28 February 2009 Project no.: 2008/03935 Responsible committee: TCI/81 Colour fastness and colour measurement of textiles Interested committees: Title: Draft BS ENISO 105-C06 Textiles Tests for colour fastness Part C06: C
2、olour fastness to domestic and commercial laundering Supersession information: If this document is published as a standard, the UK implementation of it will supersede BSENISO105-C06 : 1997 and partially supersede. NONE If you are aware of a current national standard which may be affected, please not
3、ify the secretary (contact details below). WARNING: THIS IS A DRAFT AND MUST NOT BE REGARDED OR USED AS A BRITISH STANDARD. THIS DRAFT IS NOT CURRENT BEYOND 28 February 2009. This draft is issued to allow comments from interested parties; all comments will be given consideration prior to publication
4、. No acknowledgement will normally be sent. See overleaf for information on commenting. No copying is allowed, in any form, without prior written permission from BSI except as permitted under the Copyright, Designs and Patent Act 1988 or for circulation within a nominating organization for briefing
5、purposes. Electronic circulation is limited to dissemination by e-mail within such an organization by committee members. Further copies of this draft may be purchased from BSI Customer Services, Tel: +44(0) 20 8996 9001 or email . British, International and foreign standards are also available from
6、BSI Customer Services. Information on the co-operating organizations represented on the committees referenced above may be obtained from the responsible committee secretary. Cross-references The British Standards which implement International or European publications referred to in this draft may be
7、 found via the British Standards Online Service on the BSI web site http:/. Direct tel: 01274 725138 EXT 233 Responsible Committee Secretary: Mr A Filarowski (BSI) E-mail: techsdc.org.uk Draft for Public Comment Head Office 389 Chiswick High Road London W4 4AL Telephone: +44(0)20 8996 9000 Fax: +44(
8、0)20 8996 7001 Form 36 Version 8.0 DPC: 08/30193639 DC Licensed Copy: London South Bank University, South Bank University, 31/01/2009 04:23, Uncontrolled Copy, (c) BSI b Introduction This draft standard is based on European discussions in which the UK has taken an active part. Your comments on this
9、draft are welcome and will assist in the preparation of the consequent British Standard. Comment is particularly welcome on national, legislative or similar deviations that may be necessary. Even if this draft standard is not approved by the UK, if it receives the necessary support in Europe, the UK
10、 will be obliged to publish the official English Language text unchanged as a British Standard and to withdraw any conflicting standard. UK Vote Please indicate whether you consider the UK should submit a negative (with reasons) or positive vote on this draft. Submission The guidance given below is
11、intended to ensure that all comments receive efficient and appropriate attention by the responsible BSI committee. Annotated drafts are not acceptable and will be rejected. All comments must be submitted, preferably electronically, to the Responsible Committee Secretary at the address given on the f
12、ront cover. Comments should be compatible with Version 6.0 or Version 97 of Microsoft Word for Windows, if possible; otherwise comments in ASCII text format are acceptable. Any comments not submitted electronically should still adhere to these format requirements. All comments submitted should be pr
13、esented as given in the example below. Further information on submitting comments and how to obtain a blank electronic version of a comment form are available from the BSI web site at: http:/ Template for comments and secretariat observations Date: xx/xx/200x Document: ISO/DIS xxxxx 1 2 (3) 4 5 (6)
14、(7) MB Clause No./ Subclause No./ Annex (e.g. 3.1) Paragraph/ Figure/Table/ Note (e.g. Table 1) Type of com- ment Comment (justification for change) by the MB Proposed change by the MB Secretariat observations on each comment submitted 3.1 Definition 1 ed Definition is ambiguous and needs clarifying
15、. Amend to read . so that the mains connector to which no connection . 6.4 Paragraph 2 te The use of the UV photometer as an alternative cannot be supported as serious problems have been encountered in its use in the UK. Delete reference to UV photometer. Microsoft and MS-DOS are registered trademar
16、ks, and Windows is a trademark of Microsoft Corporation. Licensed Copy: London South Bank University, South Bank University, 31/01/2009 04:23, Uncontrolled Copy, (c) BSI THIS DOCUMENT IS A DRAFT CIRCULATED FOR COMMENT AND APPROVAL. IT IS THEREFORE SUBJECT TO CHANGE AND MAY NOT BE REFERRED TO AS AN I
17、NTERNATIONAL STANDARD UNTIL PUBLISHED AS SUCH. IN ADDITION TO THEIR EVALUATION AS BEING ACCEPTABLE FOR INDUSTRIAL, TECHNOLOGICAL, COMMERCIAL AND USER PURPOSES, DRAFT INTERNATIONAL STANDARDS MAY ON OCCASION HAVE TO BE CONSIDERED IN THE LIGHT OF THEIR POTENTIAL TO BECOME STANDARDS TO WHICH REFERENCE M
18、AY BE MADE IN NATIONAL REGULATIONS. RECIPIENTS OF THIS DRAFT ARE INVITED TO SUBMIT, WITH THEIR COMMENTS, NOTIFICATION OF ANY RELEVANT PATENT RIGHTS OF WHICH THEY ARE AWARE AND TO PROVIDE SUPPORTING DOCUMENTATION. DRAFT INTERNATIONAL STANDARD ISO/DIS 105-C06 International Organization for Standardiza
19、tion, 2008 INTERNATIONAL ORGANIZATION FOR STANDARDIZATION ORGANISATION INTERNATIONALE DE NORMALISATION ISO/TC 38/SC 1 Voting begins on: 2008-11-13 Secretariat: ANSI/BSI Voting terminates on: 2009-04-13 Textiles Tests for colour fastness Part C06: Colour fastness to domestic and commercial laundering
20、 Textiles Essais de solidit des teintures Partie C06: Solidit des teintures aux lavages domestiques et industriels (Revision of third edition ISO 105-C06:1994, ISO 105-C06:1994/Cor.1:2002 and ISO 105-C06:1994/Cor.2:2002) ICS 59.080.01 ISO/CEN PARALLEL ENQUIRY The CEN Secretary-General has advised th
21、e ISO Secretary-General that this ISO/DIS covers a subject of interest to European standardization. In accordance with the ISO-lead mode of collaboration as defined in the Vienna Agreement, consultation on this ISO/DIS has the same effect for CEN members as would a CEN enquiry on a draft European St
22、andard. Should this draft be accepted, a final draft, established on the basis of comments received, will be submitted to a parallel two-month FDIS vote in ISO and formal vote in CEN. To expedite distribution, this document is circulated as received from the committee secretariat. ISO Central Secret
23、ariat work of editing and text composition will be undertaken at publication stage. Pour acclrer la distribution, le prsent document est distribu tel quil est parvenu du secrtariat du comit. Le travail de rdaction et de composition de texte sera effectu au Secrtariat central de lISO au stade de publ
24、ication. Licensed Copy: London South Bank University, South Bank University, 31/01/2009 04:23, Uncontrolled Copy, (c) BSI ISO/DIS 105-C06 ii ISO 2008 All rights reserved PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be printed
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- 08 30193639 DC
链接地址:https://www.31doc.com/p-3726790.html