08-30149718-DC.pdf
《08-30149718-DC.pdf》由会员分享,可在线阅读,更多相关《08-30149718-DC.pdf(12页珍藏版)》请在三一文库上搜索。
1、a Date: 22 July 2008 Origin: International Latest date for receipt of comments: 31 October 2008 Project no.: 2006/01184 Responsible committee: PVE/3/1 Valve fittings for gas containers Interested committees: Title: Draft ISO 13341:1997 REV Transportable gas containers - Fitting of valves to gas cyli
2、nders Supersession information: If this document is published as a standard, the UK implementation of it will supersede BSISO13341:1997/AMD1 and partially supersede. NONE If you are aware of a current national standard which may be affected, please notify the secretary (contact details below). WARNI
3、NG: THIS IS A DRAFT AND MUST NOT BE REGARDED OR USED AS A BRITISH STANDARD. THIS DRAFT IS NOT CURRENT BEYOND 31 October 2008. This draft is issued to allow comments from interested parties; all comments will be given consideration prior to publication. No acknowledgement will normally be sent. See o
4、verleaf for information on commenting. No copying is allowed, in any form, without prior written permission from BSI except as permitted under the Copyright, Designs and Patent Act 1988 or for circulation within a nominating organization for briefing purposes. Electronic circulation is limited to di
5、ssemination by e-mail within such an organization by committee members. Further copies of this draft may be purchased from BSI Customer Services, Tel: +44(0) 20 8996 9001 or email . British, International and foreign standards are also available from BSI Customer Services. Information on the co-oper
6、ating organizations represented on the committees referenced above may be obtained from the responsible committee secretary. Cross-references The British Standards which implement International or European publications referred to in this draft may be found via the British Standards Online Service o
7、n the BSI web site http:/. Direct tel: 020 8996 7141 Responsible Committee Secretary: Mr C Duncombe (BSI) E-mail: Draft for Public Comment Head Office 389 Chiswick High Road London W4 4AL Telephone: +44(0)20 8996 9000 Fax: +44(0)20 8996 7001 Form 36 Version 8.0 DPC: 08/30149718 DC Licensed CopyChin
8、ese University of Hong Kong, 21/10/2008 04:16, Uncontrolled Copy, (c) BSI b Introduction This draft standard is based on international discussions in which the UK has taken an active part. Your comments on this draft are invited and will assist in the preparation of the consequent standard. Comments
9、 submitted will be reviewed by the relevant BSI committee before sending the consensus UK vote and comments to the international secretariat, which will then decide appropriate action on the draft and the comments received. If no comments are received to the contrary, then the UK will approve this d
10、raft. If the international standard is approved, it is possible the text will be published as an identical British Standard. UK Vote Please indicate whether you consider the UK should submit a negative (with reasons) or positive vote on this draft. Submission The guidance given below is intended to
11、ensure that all comments receive efficient and appropriate attention by the responsible BSI committee. Annotated drafts are not acceptable and will be rejected. All comments must be submitted, preferably electronically, to the Responsible Committee Secretary at the address given on the front cover.
12、Comments should be compatible with Version 6.0 or Version 97 of Microsoft Word for Windows, if possible; otherwise comments in ASCII text format are acceptable. Any comments not submitted electronically should still adhere to these format requirements. All comments submitted should be presented as g
13、iven in the example below. Further information on submitting comments and how to obtain a blank electronic version of a comment form are available from the BSI web site at: http:/ Template for comments and secretariat observations Date: xx/xx/200x Document: ISO/DIS xxxxx 1 2 (3) 4 5 (6) (7) MB Claus
14、e No./ Subclause No./ Annex (e.g. 3.1) Paragraph/ Figure/Table/ Note (e.g. Table 1) Type of com- ment Comment (justification for change) by the MB Proposed change by the MB Secretariat observations on each comment submitted 3.1 Definition 1 ed Definition is ambiguous and needs clarifying. Amend to r
15、ead . so that the mains connector to which no connection . 6.4 Paragraph 2 te The use of the UV photometer as an alternative cannot be supported as serious problems have been encountered in its use in the UK. Delete reference to UV photometer. Microsoft and MS-DOS are registered trademarks, and Wind
16、ows is a trademark of Microsoft Corporation. Licensed CopyChinese University of Hong Kong, 21/10/2008 04:16, Uncontrolled Copy, (c) BSI THIS DOCUMENT IS A DRAFT CIRCULATED FOR COMMENT AND APPROVAL. IT IS THEREFORE SUBJECT TO CHANGE AND MAY NOT BE REFERRED TO AS AN INTERNATIONAL STANDARD UNTIL PUBLIS
17、HED AS SUCH. IN ADDITION TO THEIR EVALUATION AS BEING ACCEPTABLE FOR INDUSTRIAL, TECHNOLOGICAL, COMMERCIAL AND USER PURPOSES, DRAFT INTERNATIONAL STANDARDS MAY ON OCCASION HAVE TO BE CONSIDERED IN THE LIGHT OF THEIR POTENTIAL TO BECOME STANDARDS TO WHICH REFERENCE MAY BE MADE IN NATIONAL REGULATIONS
18、. RECIPIENTS OF THIS DRAFT ARE INVITED TO SUBMIT, WITH THEIR COMMENTS, NOTIFICATION OF ANY RELEVANT PATENT RIGHTS OF WHICH THEY ARE AWARE AND TO PROVIDE SUPPORTING DOCUMENTATION. DRAFT INTERNATIONAL STANDARD ISO/DIS 13341 International Organization for Standardization, 2008 INTERNATIONAL ORGANIZATIO
19、N FOR STANDARDIZATION ORGANISATION INTERNATIONALE DE NORMALISATION ISO/TC 58 Voting begins on: 2008-07-17 Secretariat: BSI Voting terminates on: 2008-12-17 Transportable gas cylinders Fitting of valves to gas cylinders Bouteilles gaz transportables Montage des robinets sur les bouteilles gaz Revisio
20、n of first edition (ISO 13341:1997) ICS 23.020.30 ISO/CEN PARALLEL ENQUIRY The CEN Secretary-General has advised the ISO Secretary-General that this ISO/DIS covers a subject of interest to European standardization. In accordance with the ISO-lead mode of collaboration as defined in the Vienna Agreem
21、ent, consultation on this ISO/DIS has the same effect for CEN members as would a CEN enquiry on a draft European Standard. Should this draft be accepted, a final draft, established on the basis of comments received, will be submitted to a parallel two-month FDIS vote in ISO and formal vote in CEN. I
22、n accordance with the provisions of Council Resolution 15/1993 this document is circulated in the English language only. Conformment aux dispositions de la Rsolution du Conseil 15/1993, ce document est distribu en version anglaise seulement. To expedite distribution, this document is circulated as r
23、eceived from the committee secretariat. ISO Central Secretariat work of editing and text composition will be undertaken at publication stage. Pour acclrer la distribution, le prsent document est distribu tel quil est parvenu du secrtariat du comit. Le travail de rdaction et de composition de texte s
24、era effectu au Secrtariat central de lISO au stade de publication. Licensed CopyChinese University of Hong Kong, 21/10/2008 04:16, Uncontrolled Copy, (c) BSI ISO/DIS 13341 ii ISO 2008 All rights reserved PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- 08 30149718 DC
链接地址:https://www.31doc.com/p-3726925.html