09-30194969-DC.pdf
《09-30194969-DC.pdf》由会员分享,可在线阅读,更多相关《09-30194969-DC.pdf(18页珍藏版)》请在三一文库上搜索。
1、a Date: 8 January 2009 Origin: International Latest date for receipt of comments: 30 April 2009 Project no.: 2008/04188 Responsible committee: PRI/66/-/3 Hydraulic applications Interested committees: PRI/66/-/1, PRI/66 Title: Draft BS ISO 11237 Rubber hoses and hose assemblies Compact wire-braid rei
2、nforced hydraulic types for oil-based or water-based fluids Specification Supersession information: If this document is published as a standard, the UK implementation of it will supersede BS ISO 11237-1;BS ISO 11237-2 and partially supersede. NONE If you are aware of a current national standard whic
3、h may be affected, please notify the secretary (contact details below). WARNING: THIS IS A DRAFT AND MUST NOT BE REGARDED OR USED AS A BRITISH STANDARD. THIS DRAFT IS NOT CURRENT BEYOND 30 April 2009. This draft is issued to allow comments from interested parties; all comments will be given consider
4、ation prior to publication. No acknowledgement will normally be sent. See overleaf for information on commenting. No copying is allowed, in any form, without prior written permission from BSI except as permitted under the Copyright, Designs and Patent Act 1988 or for circulation within a nominating
5、organization for briefing purposes. Electronic circulation is limited to dissemination by e-mail within such an organization by committee members. Further copies of this draft may be purchased from BSI Customer Services, Tel: +44(0) 20 8996 9001 or email . British, International and foreign standard
6、s are also available from BSI Customer Services. Information on the co-operating organizations represented on the committees referenced above may be obtained from the responsible committee secretary. Cross-references The British Standards which implement International or European publications referr
7、ed to in this draft may be found via the British Standards Online Service on the BSI web site http:/. Direct tel: 020 8996 7773 Responsible Committee Secretary: Ms Sue Barden (BSI) E-mail: Draft for Public Comment Head Office 389 Chiswick High Road London W4 4AL Telephone: +44(0)20 8996 9000 Fax: +
8、44(0)20 8996 7001 Form 36 Version 8.0 DPC: 09/30194969 DC Licensed Copy: London South Bank University, South Bank University, 02/02/2009 04:32, Uncontrolled Copy, (c) BSI b Introduction This draft standard is based on international discussions in which the UK has taken an active part. Your comments
9、on this draft are invited and will assist in the preparation of the consequent standard. Comments submitted will be reviewed by the relevant BSI committee before sending the consensus UK vote and comments to the international secretariat, which will then decide appropriate action on the draft and th
10、e comments received. If the international standard is approved, it is possible the text will be published as an identical British Standard. UK Vote Please indicate whether you consider the UK should submit a negative (with reasons) or positive vote on this draft. Submission The guidance given below
11、is intended to ensure that all comments receive efficient and appropriate attention by the responsible BSI committee. Annotated drafts are not acceptable and will be rejected. All comments must be submitted, preferably electronically, to the Responsible Committee Secretary at the address given on th
12、e front cover. Comments should be compatible with Version 6.0 or Version 97 of Microsoft Word for Windows, if possible; otherwise comments in ASCII text format are acceptable. Any comments not submitted electronically should still adhere to these format requirements. All comments submitted should be
13、 presented as given in the example below. Further information on submitting comments and how to obtain a blank electronic version of a comment form are available from the BSI web site at: http:/ Template for comments and secretariat observations Date: xx/xx/200x Document: ISO/DIS xxxxx 1 2 (3) 4 5 (
14、6) (7) MB Clause No./ Subclause No./ Annex (e.g. 3.1) Paragraph/ Figure/Table/ Note (e.g. Table 1) Type of com- ment Comment (justification for change) by the MB Proposed change by the MB Secretariat observations on each comment submitted 3.1 Definition 1 ed Definition is ambiguous and needs clarify
15、ing. Amend to read . so that the mains connector to which no connection . 6.4 Paragraph 2 te The use of the UV photometer as an alternative cannot be supported as serious problems have been encountered in its use in the UK. Delete reference to UV photometer. Microsoft and MS-DOS are registered trade
16、marks, and Windows is a trademark of Microsoft Corporation. Licensed Copy: London South Bank University, South Bank University, 02/02/2009 04:32, Uncontrolled Copy, (c) BSI THIS DOCUMENT IS A DRAFT CIRCULATED FOR COMMENT AND APPROVAL. IT IS THEREFORE SUBJECT TO CHANGE AND MAY NOT BE REFERRED TO AS A
17、N INTERNATIONAL STANDARD UNTIL PUBLISHED AS SUCH. IN ADDITION TO THEIR EVALUATION AS BEING ACCEPTABLE FOR INDUSTRIAL, TECHNOLOGICAL, COMMERCIAL AND USER PURPOSES, DRAFT INTERNATIONAL STANDARDS MAY ON OCCASION HAVE TO BE CONSIDERED IN THE LIGHT OF THEIR POTENTIAL TO BECOME STANDARDS TO WHICH REFERENC
18、E MAY BE MADE IN NATIONAL REGULATIONS. RECIPIENTS OF THIS DRAFT ARE INVITED TO SUBMIT, WITH THEIR COMMENTS, NOTIFICATION OF ANY RELEVANT PATENT RIGHTS OF WHICH THEY ARE AWARE AND TO PROVIDE SUPPORTING DOCUMENTATION. DRAFT INTERNATIONAL STANDARD ISO/DIS 11237 International Organization for Standardiz
19、ation, 2008 INTERNATIONAL ORGANIZATION FOR STANDARDIZATION ORGANISATION INTERNATIONALE DE NORMALISATION ISO/TC 45/SC 1 Voting begins on: 2008-12-22 Secretariat: DSM Voting terminates on: 2009-05-22 Rubber hoses and hose assemblies Compact wire-braid- reinforced hydraulic types for oil-based or water
20、-based fluids Specification Tuyaux et flexibles en caoutchouc Types hydrauliques compacts avec armature de fils mtalliques tresss pour fluides base dhuile ou base deau Spcifications ICS 23.100.40; 83.140.40 In accordance with the provisions of Council Resolution 15/1993 this document is circulated i
21、n the English language only. Conformment aux dispositions de la Rsolution du Conseil 15/1993, ce document est distribu en version anglaise seulement. To expedite distribution, this document is circulated as received from the committee secretariat. ISO Central Secretariat work of editing and text com
22、position will be undertaken at publication stage. Pour acclrer la distribution, le prsent document est distribu tel quil est parvenu du secrtariat du comit. Le travail de rdaction et de composition de texte sera effectu au Secrtariat central de lISO au stade de publication. Licensed Copy: London Sou
23、th Bank University, South Bank University, 02/02/2009 04:32, Uncontrolled Copy, (c) BSI ISO/DIS 11237 ii ISO 2008 All rights reserved PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be printed or viewed but shall not be edited un
24、less the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobes licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a tradema
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- 09 30194969 DC
链接地址:https://www.31doc.com/p-3727329.html