AWWA-C302-2004.pdf
《AWWA-C302-2004.pdf》由会员分享,可在线阅读,更多相关《AWWA-C302-2004.pdf(40页珍藏版)》请在三一文库上搜索。
1、The Authoritative Resource for Safe Drinking WaterSM ANSI/AWWA C302-04 (Revision of ANSI/AWWA C302-95) AWWA Standard Effective date: May 1, 2004. First edition approved by AWWA Board of Directors Sept. 4, 1951. This edition approved Jan. 18, 2004. Approved by American National Standards Institute Ma
2、r 11, 2004. Reinforced Concrete Pressure Pipe, Noncylinder Type Advocacy Communications Conferences Education and Training ?Science and Technology Sections 6666 West Quincy Avenue Denver, CO 80235-3098 T 800.926.7337 www.awwa.org Copyright 2004 American Water Works Association, All Rights Reserved.
3、Approved by American National Standards Institute: May 21, 2002. Copyright American Water Works Association Provided by IHS under license with AWWA Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/21/2007 07:30:49 MDTNo reproduction or networking permitted without license from
4、 IHS -,-,- ii AWWA Standard This document is an American Water Works Association (AWWA) standard. It is not a specification. AWWA standards describe minimum requirements and do not contain all of the engineering and administrative information normally contained in specifications. The AWWA standards
5、usually contain options that must be evaluated by the user of the standard. Until each optional feature is specified by the user, the product or service is not fully defined. AWWA publication of a standard does not constitute endorsement of any product or product type, nor does AWWA test, certify, o
6、r approve any product. The use of AWWA standards is entirely voluntary. AWWA standards are intended to represent a consensus of the water supply industry that the product described will provide satisfactory service. When AWWA revises or withdraws this standard, an official notice of action will be p
7、laced on the first page of the classified advertising section of Journal AWWA. The action becomes effective on the first day of the month following the month of Journal AWWA publication of the official notice. American National Standard An American National Standard implies a consensus of those subs
8、tantially concerned with its scope and provisions. An American National Standard is intended as a guide to aid the manufacturer, the consumer, and the general public. The existence of an American National Standard does not in any respect preclude anyone, whether that person has approved the standard
9、 or not, from manufacturing, marketing, purchasing, or using products, processes, or procedures not conforming to the standard. American National Standards are subject to periodic review, and users are cautioned to obtain the latest editions. Producers of goods made in conformity with an American Na
10、tional Standard are encouraged to state on their own responsibility in advertising and promotional materials or on tags or labels that the goods are produced in conformity with particular American National Standards. CAUTION NOTICE:The American National Standards Institute (ANSI) approval date on th
11、e front cover of this standard indicates completion of the ANSI approval process. This American National Standard may be revised or withdrawn at any time. ANSI procedures require that action be taken to reaffirm, revise, or withdraw this standard no later than five years from the date of publication
12、. Purchasers of American National Standards may receive current information on all standards by calling or writing the American National Standards Institute, 25 W. 43rd St., Fourth Floor, New York, NY 10036; (212) 642-4900. Science and Technology AWWA unites the drinking water community by developin
13、g and distributing authoritative scientific and technological knowledge. Through its members, AWWA develops industry standards for products and processes that advance public health and safety. AWWA also provides quality improvement programs for water and wastewater utilities. All rights reserved. No
14、 part of this publication may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopy, recording, or any information or retrieval system, except in the form of brief excerpts or quotations for review purposes, without the written permission of the publ
15、isher. Copyright 2004 by American Water Works Association Printed in USA Copyright 2004 American Water Works Association, All Rights Reserved. Approved by American National Standards Institute: May 21, 2002. Copyright American Water Works Association Provided by IHS under license with AWWA Licensee=
16、IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/21/2007 07:30:49 MDTNo reproduction or networking permitted without license from IHS -,-,- iii Committee Personnel The AWWA Standards subcommittee that reviewed and developed this standard had the following personnel at the time: Wayne R
17、. Brunzell, Chair H.H. Bardakjian, Ameron Concrete a wall of concrete covering the reinforcing cage or cages inside and outside the steel cylinder; and a joint with a preformed rubber gasket(s) of circular Copyright 2004 American Water Works Association, All Rights Reserved. Approved by American Nat
18、ional Standards Institute: May 21, 2002. Copyright American Water Works Association Provided by IHS under license with AWWA Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/21/2007 07:30:49 MDTNo reproduction or networking permitted without license from IHS -,-,- 2AWWA C302-04
19、 cross section, designed so that the joint will be watertight under the conditions of service specified by the purchaser. Sec. 1.2Purpose The purpose of this standard is to provide purchasers, manufacturers, and constructors with the minimum requirements for reinforced concrete pressure pipe, noncyl
20、inder type, including fabrication and testing requirements. Sec. 1.3Application This standard can be referenced in specifications for purchasing and receiving reinforced concrete pressure pipe, noncylinder type. This standard can be used as a guide for manufacturing this type of concrete pressure pi
21、pe. The stipulations of this standard apply when this document has been referenced and then only to reinforced concrete pressure pipe, noncylinder type. SECTION 2:REFERENCES This standard references the following documents. In their latest editions, they form a part of this standard to the extent sp
22、ecified within the standard. In any case of conflict, the requirements of this standard shall prevail. ACI* 305Hot Weather Concreting. AISISteel Products Manual1010 through 1020 Steel Sheets and Coils and M1020 Steel Bars. ANSI/ASMEBoiler and Pressure Vessel Code, Sec. IX. ASTM* A27/A27MStandard Spe
23、cification for Steel Castings, Carbon, for General Application. ASTM A36/A36MStandard Specification for Carbon Structural Steel. *American Concrete Institute, P.O. Box 9094, Farmington Hills, MI 48333. American Iron and Steel Institute, 1101 17th St. N.W., Washington, DC 20036. American National Sta
24、ndards Institute, 25 W. 43rd St., 4th Floor, New York, NY 10036. American Society of Mechanical Engineers, Three Park Ave., #20, New York, NY 10016. *ASTM International, 100 Barr Harbor Dr., West Conshohocken, PA 19428. Copyright 2004 American Water Works Association, All Rights Reserved. Approved b
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- AWWA C302 2004
链接地址:https://www.31doc.com/p-3730359.html