《ANSI-ISO-IEC-15292-2001-R2007.pdf》由会员分享,可在线阅读,更多相关《ANSI-ISO-IEC-15292-2001-R2007.pdf(20页珍藏版)》请在三一文库上搜索。
1、 Reference number ISO/IEC 15292:2001(E) ISO/IEC 2001 INTERNATIONAL STANDARD ISO/IEC 15292 First edition 2001-12-15 Information technology Security techniques Protection Profile registration procedures Technologies de linformation Techniques de scurit Procdures denregistrement du profil de protection
2、 Adopted by INCITS (InterNational Committee for Information Technology Standards) as an American National Standard.Adopted by INCITS (InterNational Committee for Information Technology Standards) as an American National Standard. Date of ANSI Approval: 8/29/02 Published by American National Standard
3、s Institute, 25 West 43rd Street, New York, New York 10036 Copyright 2002 by Information Technology Industry Council (ITI). All rights reserved. These materials are subject to copyright claims of International Standardization Organization (ISO), International Electrotechnical Commission (IEC), Ameri
4、can National Standards Institute (ANSI), and Information Technology Industry Council (ITI). Not for resale. No part of this publication may be reproduced in any form, including an electronic retrieval system, without the prior written permission of ITI. All requests pertaining to this standard shoul
5、d be submitted to ITI, 1250 Eye Street NW, Washington, DC 20005. Printed in the United States of America Copyright American National Standards Institute Provided by IHS under license with ANSI Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 07/16/2007 00:58:49 MDTNo reproduction
6、 or networking permitted without license from IHS -,-,- ISO/IEC 15292:2001(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to an
7、d installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobes licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the softwar
8、e products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is f
9、ound, please inform the Central Secretariat at the address given below. ISO/IEC 2001 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permiss
10、ion in writing from either ISO at the address below or ISOs member body in the country of the requester. ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyrightiso.ch Web www.iso.ch Printed in Switzerland ii ISO/IEC 2001 All rights reserve
11、d Copyright American National Standards Institute Provided by IHS under license with ANSI Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 07/16/2007 00:58:49 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO/IEC 15292:2001(E) ISO/IEC 2001 All rights r
12、eserved iii Contents 1Scope1 2Normative references .1 3Terms and definitions.1 4Abbreviations 3 5Technical Specifications3 5.1Entry label 3 5.2Technical definition (within a register entry)3 6The JTC 1 Registration Authority for PPs and packages .4 6.1Appointment.4 6.2Qualifications.4 6.3Contract4 6
13、.4Duties4 7Criteria for eligibility of applicants for registration.5 8Information to be included within an application for registration .5 9Steps involved in review and response to an application7 9.1Initial processing.7 9.2Validation7 10Criteria for rejection of applications for registration 8 11Op
14、eration of the register8 11.1Notification of obsolescent entries .8 11.2Update of draft technical specifications.8 11.3Routine review of entries8 11.4Defect notification .9 11.5Other requests for update of entries.9 11.6Deletion of register entries.10 12Maintenance of the register .10 13Confidential
15、ity of information held within the register .10 14Publication of the register10 15Appeals procedure12 Annex A (informative) Benefits of registration.13 Annex B (informative) Lifecycle of a register entry14 Copyright American National Standards Institute Provided by IHS under license with ANSI Licens
16、ee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 07/16/2007 00:58:49 MDTNo reproduction or networking permitted without license from IHS -,-,- Foreword ISO (the International Organization for Standardization) and IEC (the International Electrotechnical Commission) form the specialized
17、system for worldwide standardization. National bodies that are members of ISO or IEC participate in the development of International Standards through technical committees established by the respective organization to deal with particular fields of technical activity. ISO and IEC technical committee
18、s collaborate in fields of mutual interest. Other international organizations, governmental and non-governmental, in liaison with ISO and IEC, also take part in the work. In the field of information technology, ISO and IEC have established a joint technical committee, ISO/IEC JTC 1. International St
19、andards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 3. The main task of the joint technical committee is to prepare International Standards. Draft International Standards adopted by the joint technical committee are circulated to national bodies for voting. Publica
20、tion as an International Standard requires approval by at least 75 % of the national bodies casting a vote. Attention is drawn to the possibility that some of the elements of this International Standard may be the subject of patent rights. ISO and IEC shall not be held responsible for identifying an
21、y or all such patent rights. ISO/IEC 15292 was prepared by Joint Technical Committee ISO/IEC JTC 1, Information technology, Subcommittee SC 27, Security techniques. Annexes A and B of this International Standard are for information only. ISO/IEC 15292:2001(E) iv ISO/IEC 2001 All rights reserved Copy
22、right American National Standards Institute Provided by IHS under license with ANSI Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 07/16/2007 00:58:49 MDTNo reproduction or networking permitted without license from IHS -,-,- INTERNATIONAL STANDARD ISO/IEC 15292:2001(E) Informat
23、ion technology Security techniques Protection Profile registration procedures 1 Scope This International Standard defines the procedures to be applied by the JTC 1 Registration Authority appointed by the ISO and IEC councils to maintain a register of Protection Profiles and packages for the purposes
24、 of IT security evaluation. These Protection Profiles and packages are specified in accordance with criteria given in ISO/IEC 15408. 2 Normative references The following normative documents contain provisions which, through reference in this text, constitute provisions of this International Standard
25、. For dated references, subsequent amendments to, or revisions of, any of these publications do not apply. However, parties to agreements based on this International Standard are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below
26、. For undated references, the latest edition of the normative document referred to applies. Members of ISO and IEC maintain registers of currently valid International Standards. ISO 15408-1, Information technology Security techniques Evaluation criteria for IT security Part 1: Introduction and gener
27、al model ISO 15408-2, Information technology Security techniques Evaluation criteria for IT security Part 2: Security functionality requirements ISO 15408-3, Information technology Security techniques Evaluation criteria for IT security Part 2: Security assurance requirements Procedures for the tech
28、nical work of ISO/IEC JTC 1 ISO/IEC/ITU ITSIG Guide for the use of IT in the development and delivery of standards 3 Terms and definitions For the purposes of this International Standard, the following terms and definitions apply. 3.1 applicant an entity (organisation, individual etc.) which request
29、s the assignment of a register entry and entry label ISO/IEC 2001 All rights reserved 1 Copyright American National Standards Institute Provided by IHS under license with ANSI Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 07/16/2007 00:58:49 MDTNo reproduction or networking pe
30、rmitted without license from IHS -,-,- 2 ISO/IEC 2001 All rights reserved 3.2 certificate a declaration by an independent authority operating in accordance with ISO Guide 58, Calibration and testing laboratory accreditation systems - General requirements for operation and recognition, confirming tha
31、t an evaluation pass statement is valid 3.3 entry label the naming information that identifies a registered PP or package uniquely 3.4 evaluation pass statement a statement issued by an organisation that performs evaluations against ISO/IEC 15408 confirming that a PP has successfully passed assessme
32、nt against the evaluation criteria given in clause 4 of Part 3 of that International Standard 3.5 JTC 1 Registration Authority an organisation appointed by the ISO and IEC councils to register objects in accordance with a JTC 1 procedural Standard 3.6 package a reusable set of either functional or a
33、ssurance components combined together to satisfy a set of identified security objectives (from ISO/IEC 15408-1) 3.7 Protection Profile an implementation-independent set of security requirements for a category of IT products or systems that meet specific consumer needs (adapted from ISO/IEC 15408-1)
34、3.8 register a set of files (electronic, or a combination of electronic and paper) containing entry labels and their associated definitions and related information 3.9 register entry the information within a register relating to a specific PP or package 3.10 registration the process of assigning a r
35、egister entry 3.11 Security Target a set of security requirements and specifications to be used as the basis for evaluation of an identified IT product or system (adapted from ISO/IEC 15408-1) 3.12 sponsor an entity (organisation, individual etc.) responsible for the content of a register entry ISO/
36、IEC 15292:2001(E) Copyright American National Standards Institute Provided by IHS under license with ANSI Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 07/16/2007 00:58:49 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO/IEC 2001 All rights reserve
37、d 3 4Abbreviations ITTFInformation Technology Task Force (of ISO/IEC) PPProtection Profile RARegistration Authority SCJTC 1 Subcommittee STSecurity Target 5Technical Specifications 5.1Entry label Every PP or package registered in accordance with this International Standard shall have an entry label
38、assigned by the JTC 1 RA that uniquely identifies that PP or package within the register. The entry label shall be made up of the following elements, separated by dashes: -Entry Type -Registration Year -Registration Number. The Entry Type shall be PP for a protection profile, AP for an assurance pac
39、kage or FP for a functional package. The Registration Year shall be the four digit representation of the year when the entry was registered. The Registration Number shall be a four digit sequentially assigned identification number, starting each year from 0001. EXAMPLEPP-2001-0001. 5.2Technical defi
40、nition (within a register entry) 5.2.1PPs Every application for registration of a PP submitted for registration in accordance with this International Standard shall include a technical definition of the PP in question. This technical definition shall conform to the content requirements for PPs conta
41、ined within Annex B to ISO/IEC 15408-1 and shall conform to the structural outline portrayed in Figure B.1 of ISO/IEC 15408-1. 5.2.2Packages Every application for registration of a functional or assurance package submitted for registration in accordance with this International Standard shall include
42、 a technical definition of the package. This definition shall contain: - a package overview that summarises the package in narrative form - a specification of a set of either functional or assurance components. The package overview should be sufficiently detailed for a potential user of the package
43、to determine whether the package is of interest. It should be understandable without reference to the component specifications. ISO/IEC 15292:2001(E) Copyright American National Standards Institute Provided by IHS under license with ANSI Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for R
44、esale, 07/16/2007 00:58:49 MDTNo reproduction or networking permitted without license from IHS -,-,- 4 ISO/IEC 2001 All rights reserved Components for functional packages shall be selected from ISO/IEC 15408-2 or shall be constructed and specified in accordance with the specification requirements fo
45、r functional components given within clause 2 of ISO/IEC 15408-2. Components for assurance packages shall be selected from ISO/IEC 15408-3 or shall be constructed and specified in accordance with the specification requirements for assurance components given within subclause 2.1 of ISO/IEC 15408-3. T
46、he technical definition of a package may contain other descriptive information that might be relevant to the author of a PP or ST wishing to use or reference the package. This information shall be presented in the form of one or more named PP or ST sections as defined within Annexes B and C of ISO/I
47、EC 15408-1. The information should be suitable for direct incorporation within PPs or STs that make use of the package. 6The JTC 1 Registration Authority for PPs and packages 6.1Appointment The JTC 1 RA for PPs and packages shall be appointed by the ISO and IEC councils in accordance with the procedure for the appointment of JTC 1 Registration Authorities defined in the JTC 1 Directives. 6.2Qualifications Any organisation seeking appointment as the JTC 1 RA for PPs and packages shall demonstrate that it meets the qualifications required of JTC 1 RAs as defined in the JTC 1
链接地址:https://www.31doc.com/p-3732534.html