BS-7455-9-1994 ISO-7530-9-1993.pdf
《BS-7455-9-1994 ISO-7530-9-1993.pdf》由会员分享,可在线阅读,更多相关《BS-7455-9-1994 ISO-7530-9-1993.pdf(8页珍藏版)》请在三一文库上搜索。
1、BRITISH STANDARD BS 7455-9: 1994 ISO 7530-9: 1993 Analysis of nickel alloys by flame atomic absorption spectrometry Part 9: Method for determination of vanadium UDC 669.245:543.422:546.881 Licensed Copy: London South Bank University, London South Bank University, Fri Dec 08 14:00:41 GMT+00:00 2006,
2、Uncontrolled Copy, (c) BSI BS 7455-9:1994 This British Standard, having been prepared under the direction of the Non-ferrous Metals Standards Policy Committee, was published under the authority of the Standards Board and comes into effect on 15 June 1994 BSI 11-1999 The following BSI references rela
3、te to the work on this standard: Committee reference NFM/10 Draft for comment 92/42776 DC ISBN 0 580 23365 0 Committees responsible for this British Standard The preparation of this British Standard was entrusted by the Non-ferrous Metals Standards Policy Committee (NFM/-) to Technical Committee NFM
4、/10, upon which the following bodies were represented: Association of Bronze and Brass Founders British Non-ferrous Metals Federation British Stainless Steel Association British Steel Industry Department of Trade and Industry (Laboratory of the Government Chemist) Engineering Equipment and Materials
5、 Users Association Institute of British Foundrymen London Metal Exchange Ministry of Defence Nickel Development Institute Non-ferrous Metal Stockists Steel Casting Research and Trade Association Coopted members Amendments issued since publication Amd. No.DateComments Licensed Copy: London South Bank
6、 University, London South Bank University, Fri Dec 08 14:00:41 GMT+00:00 2006, Uncontrolled Copy, (c) BSI BS 7455-9:1994 BSI 11-1999i Contents Page Committees responsibleInside front cover National forewordii 1Scope1 2Normative references1 3Principle1 4Reagents1 5Apparatus1 6Sampling and sample prep
7、aration1 7Procedure1 8Expression of results2 9Test report2 Table 1 Nominal composition of test samples % (m/m)2 Table 2 Results of statistical analysis2 List of referencesInside back cover Licensed Copy: London South Bank University, London South Bank University, Fri Dec 08 14:00:41 GMT+00:00 2006,
8、Uncontrolled Copy, (c) BSI BS 7455-9:1994 ii BSI 11-1999 National foreword This Part of BS 7455 has been prepared under the direction of the Non-ferrous Metals Standards Policy Committee. It is identical with ISO 7530-9:1993 Nickel alloys Flame atomic absorption spectrometric analysis Part 9: Determ
9、ination of vanadium content, published by the International Organization for Standardization (ISO). At present this British Standard consists of nine Parts all concerned with methods for flame spectrometric analysis of nickel alloys. Further International Standards are in preparation on the same sub
10、ject and when available, these will be published as further Parts of this British Standard. A British Standard does not purport to include all the necessary provisions of a contract. Users of British Standards are responsible for their correct application. Compliance with a British Standard does not
11、 of itself confer immunity from legal obligations. Cross-references International StandardCorresponding British Standard ISO 5725:1986BS 5497 Precision of test methods Part 1:1987 Guide for the determination of repeatability and reproducibility for a standard test method by inter-laboratory tests (I
12、dentical) ISO 7530-1:1990BS 7455 Analysis of nickel alloys by flame atomic absorption spectrometry Part 1:1991 General requirements and sample dissolution (Identical) Summary of pages This document comprises a front cover, an inside front cover, pages i and ii, pages 1 and 2, an inside back cover an
13、d a back cover. This standard has been updated (see copyright date) and may have had amendments incorporated. This will be indicated in the amendment table on the inside front cover. Licensed Copy: London South Bank University, London South Bank University, Fri Dec 08 14:00:41 GMT+00:00 2006, Uncont
14、rolled Copy, (c) BSI BS 7455-9:1994 BSI 11-19991 1 Scope This part of ISO 7530 specifies a flame atomic absorption spectrometric method for the determination of vanadium in the range of 0,05 % (m/m) to 1 % (m/m) in nickel alloys. Typical compositions of nickel alloys are given in Annex B of ISO 7530
15、-1:1990. The general requirements concerning the apparatus, sampling, dissolution of the test sample, atomic absorption measurements, calculations and test report are given in ISO 7530-1. 2 Normative references The following standards contain provisions which, through reference in this text, constit
16、ute provisions of this part of ISO 7530. At the time of publication, the editions indicated were valid. All standards are subject to revision, and parties to agreements based on this part of ISO 7530 are encouraged to investigate the possibility of applying the most recent editions of the standards
17、indicated below. Members of IEC and ISO maintain registers of currently valid International Standards. ISO 5725:1986, Precision of test methods Determination of repeatability and reproducibility for a standard test method by inter-laboratory tests. ISO 7530-1:1990, Nickel alloys Flame atomic absorpt
18、ion spectrometric analysis Part 1: General requirements and sample dissolution. 3 Principle Dissolution of a test portion in acid and aspiration of the test solution into a nitrous oxide-acetylene flame of an atomic absorption spectrometer. Measurement of the absorbance of the resonance line energy
19、from the spectrum of vanadium and comparison with that of calibration solutions at a wavelength of 318,4 nm. 4 Reagents In addition to the reagents listed in clause 4 of ISO 7530-1:1990, the following special reagents are required. 4.1 Ammonium metavanadate (NH4VO3), an alternative to pure vanadium
20、metal. 4.2 Strontium chloride, solution. Transfer 113,5 g of strontium chloride hexahydrate (SrCl2.6H2O) to a 600 ml beaker, dissolve in 400 ml of hot water (50 C to 60 C), cool and transfer to a 1 000 ml one-mark volumetric flask. Make up to the mark with water and mix. The strontium chloride shoul
21、d be free of heavy metals. 4.3 Vanadium, standard reference solution (1,000 g/l). 4.3.1 Preparation from vanadium metal Weigh, to the nearest 0,001 g, 1,000 g of vanadium metal of 99,9 % (m/m) minimum purity and transfer to a 400 ml beaker. Add 60 ml of hydrochloric acid (20= 1,18 g/ml) and 20 ml of
22、 nitric acid (20= 1,41 g/ml) and heat to complete dissolution. Cool and transfer to a 1 000 ml one-mark volumetric flask. Make up to the mark with water, mix and store in a polyethylene bottle. 4.3.2 Preparation from ammonium metavanadate Weigh 2,296 g of ammonium metavanadate (4.1) and transfer to
23、a 600 ml beaker. Add about 400 ml of water and heat to dissolve the salt. Transfer the warm solution to a 1 000 ml one-mark volumetric flask and dilute with 400 ml of cold water. Add 50 ml of hydrochloric acid (20= 1,18 g/ml) and 10 ml of nitric acid (20= 1,41 g/ml), and cool to ambient temperature.
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- BS-7455-9-1994 ISO-7530-9-1993 BS 7455 1994 ISO 7530 1993
链接地址:https://www.31doc.com/p-3735890.html