BS-7697-1993.pdf
《BS-7697-1993.pdf》由会员分享,可在线阅读,更多相关《BS-7697-1993.pdf(10页珍藏版)》请在三一文库上搜索。
1、BRITISH STANDARD BS 7697:1993 Incorporating Corrigendum No. 1 Nominal voltages for low voltage public electricity supply systems (Implementation of HD 472 S1) ICS 29.020; 29.240.01 ? BS 7697:1993 This British Standard, having been prepared under the direction of the General Electrotechnical Standard
2、s Policy Committee, was published under the authority of the Standards Board and comes into effect on 15 October 1993 BSI 7 January 2003 The following BSI references relate to the work on this standard: Committee reference GEL/- Draft announced in BSI News August 1993 ISBN 0 580 22571 2 Committees r
3、esponsible for this British Standard The preparation of this British Standard was under the direction of the General Electrotechnical Standards Policy Committee (GEL/-) upon which the following bodies were represented: Association of Control Manufacturers (TACMA) BEAMA Ltd. BEAMA Ltd. British Radio
4、nominal voltage English version Nominal voltages for low voltage public electricity supply systems (includes amendment A1:1995) Tensions nominales des rseaux lectriques de distribution publique basse tension (inclut lamendement A1:1995) Nennspannungen fr ffentliche Niederspannungs-Stromverteilungs-s
5、ysteme (enthlt nderung A1:1995) This Harmonization Document was approved by CENELEC on 1988-11-04. Amendement A1 was approved by CENELEC on 1995-03-24. CENELEC members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for implementation of this Harmonizatio
6、n Document on a national level. Up-to-date lists and bibliographical references concerning such national implementation may be obtained on application to the Central Secretariat or to any CENELEC member. This Harmonization Document exists in three official versions (English, French, German). CENELEC
7、 members are the national electrotechnical committees of Austria, Belgium, Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and United Kingdom. CEN European Committee for Standardization Comit Europen de Normali
8、sation Europisches Komitee fr Normung Central Secretariat: rue de Stassart 36, B-1050 Brussels 1988 Copyright reserved to CENELEC members Ref. No. HD 472 S1:1988 + A1:1995 E BS 7697:1993 BSI 7 January 2003 2 Foreword The Harmonization Document consists of: a text elaborated from the IEC Publication
9、38 (6th edition) in agreement with UNIPEDE (International Union of Procedures and Distributors of Electrical Energy). This Harmonization Document was approved by CENELEC on 1988-11-04. According to the CENELEC Internal Regulations the CENELEC member National Committees are bound: to announce the exi
10、stence of this Harmonization Document at national level by or before 1989-06-01; to publish their new harmonized national standard by or before 1989-12-01; to withdraw all conflicting national standards by or before 1989-12-01. Harmonized national standards are listed on the HD information sheet, wh
11、ich is available from the CENELEC National Committees or from the CENELEC Central Secretariat. Foreword to amendment A1 At the request of the British electrotechnical committee, a draft for an amendment to HD 472 S1:1988 was submitted to the CENELEC members for acceptance in January 1995. The text o
12、f the draft was accepted by CENELEC as amendment A1 to HD 472 S1:1988 on 1995-07-04. The following dates were fixed: Contents Page Foreword2 1Scope3 2Definitions3 3Standard values of nominal voltage3 Figure 1 Timescale for reduction of voltage in low-voltage public electricity supply in the UK4 late
13、st date by which the existence of the amendment has to be announced at national level (doa) 1995-10-15 latest date by which the amendment has to be implemented at national level by publication of harmonized national standard or by endorsement(dop) 1996-01-15 BS 7697:1993 BSI 7 January 2003 3 1 Scope
14、 This standard applies to a.c. three-phase, three-wire or four-wire, public supply systems, having a nominal voltage between 100 V and 1 000 V inclusive, and to the equipment connected to these systems. This standard is not applicable to standard voltages of components and parts used within electric
15、al devices or items of equipment. 2 Definitions NOTEThe voltages stated below are r.m.s, values. 2.1 nominal voltage voltage by which a system or equipment is designated and to which certain operating characteristics are referred 2.2 supply terminals the point of delivery of electricity from the dis
16、tribution system of the electricity supply authority to the consumer 3 Standard values of nominal voltage The standard values of nominal voltage are: 230 V between phases for three-wire three-phase systems; 230 V between phase and neutral, and 400 V between phases, for four-wire three-phase systems.
17、 Under normal system conditions it is recommended that the voltage at the supply terminals should not differ from the nominal voltage by more than 10 %. The nominal voltage of existing 220/380 V and 240/415 V systems shall evolve towards the standardized value of 230/400 V. The transition period sho
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- BS 7697 1993
链接地址:https://www.31doc.com/p-3736050.html