BS-8509-2008.pdf
《BS-8509-2008.pdf》由会员分享,可在线阅读,更多相关《BS-8509-2008.pdf(34页珍藏版)》请在三一文库上搜索。
1、BS 8509:2008 Childrens beds for domestic use Safety requirements and test methods ICS 97.140 NO COPYING WITHOUT BSI PERMISSION EXCEPT AS PERMITTED BY COPYRIGHT LAW BRITISH STANDARD Licensed CopyChinese University of Hong Kong, 21/10/2008 07:37, Uncontrolled Copy, (c) BSI Publishing and copyright inf
2、ormation The BSI copyright notice displayed in this document indicates when the document was last issued. BSI 2008 ISBN 978 0 580 59411 3 The following BSI references relate to the work on this standard: Committee reference CW/41 Draft for comment 08/30168262 DC Publication history First published A
3、ugust 2008 Amendments issued since publication Amd. no.DateText affected BS 8509:2008 Licensed CopyChinese University of Hong Kong, 21/10/2008 07:37, Uncontrolled Copy, (c) BSI BSI 2008i BS 8509:2008 Contents Foreword iii 1Scope 1 2Normative references 1 3Terms and definitions 1 4General requirement
4、s 2 5Chemical hazards 12 6Thermal hazards 12 7Mechanical hazards gaps and openings 13 8Mechanical hazards folding 16 9Mechanical hazards crushing and shearing 17 10Mechanical hazards protruding parts 17 11Mechanical hazards entanglement in cords, ribbons and similar parts 18 12Mechanical hazards sma
5、ll parts 18 13Mechanical hazards suffocation 19 14Mechanical hazards edges and protruding parts 20 15Mechanical hazards points and wires 20 16Mechanical hazards inadequate structural integrity materials and fastenings 20 17Mechanical hazards inadequate structural integrity vertical static strength o
6、f bed base edges 21 18Mechanical hazards inadequate structural integrity vertical impact strength of bed base 21 19Mechanical hazards inadequate structural integrity durability of bed base 22 20Mechanical hazards inadequate structural integrity durability of bed edge 23 21Mechanical hazards inadequa
7、te structural integrity strength of head and foot boards 24 22Mechanical hazards inadequate structural integrity strength of side guards and/or safety rails 24 23Mechanical hazards inadequate structural integrity strength of top rails for four poster features 25 24Product information 26 List of figu
8、res Figure 1 Hip probe 3 Figure 2 Head probe 4 Figure 3 V and irregular shaped openings template 4 Figure 4 Finger probe with hemispherical end 5 Figure 5 Finger probe with conical end 5 Figure 6 Conical probe 6 Figure 7 Loop and mass 7 Figure 8 Ball chain 7 Figure 9 Small parts cylinder 8 Figure 10
9、 Bed base impactor 9 Figure 11 Striking surface 10 Figure 12 Bed base loading pad 10 Figure 13 Naturalistically shaped loading pad geometry: moulded fibre glass construction 11 Figure 14 Method of insertion of portion B 14 Figure 15 Method of insertion of portion B 14 Figure 16 Method of insertion o
10、f portion A 15 Licensed CopyChinese University of Hong Kong, 21/10/2008 07:37, Uncontrolled Copy, (c) BSI BS 8509:2008 ii BSI 2008 Figure 17 Vertical static strength test of bed edge 21 Figure 18 Vertical impact points 22 Figure 19 Durability of bed base test positions 23 Figure 20 Loading of top si
11、de rail 25 Figure 21 Loading of top end rail 26 Summary of pages This document comprises a front cover, an inside front cover, pages i to iv, pages 1 to 27 and a back cover. Licensed CopyChinese University of Hong Kong, 21/10/2008 07:37, Uncontrolled Copy, (c) BSI BSI 2008iii BS 8509:2008 Foreword P
12、ublishing information This British Standard is published by BSI and came into effect on 29 August 2008. It was prepared by Technical Committee CW/41, Child use and care articles. A list of organizations represented on this committee can be obtained on request to its secretary. Information about this
13、 document This is a new standard, which has been written to cover childrens beds that fall outside the scope of BS EN 716. Use of this document It has been assumed in the preparation of this British Standard that the execution of its provisions will be entrusted to appropriately qualified and experi
14、enced people, for whose use it has been produced. Presentational conventions The provisions of this standard are presented in roman (i.e. upright) type. Its requirements are expressed in sentences in which the principal auxiliary verb is “shall”. Commentary, explanation and general informative mater
15、ial is presented in smaller italic type, and does not constitute a normative element. Contractual and legal considerations This publication does not purport to include all the necessary provisions of a contract. Users are responsible for its correct application. Compliance with a British Standard ca
16、nnot confer immunity from legal obligations. Licensed CopyChinese University of Hong Kong, 21/10/2008 07:37, Uncontrolled Copy, (c) BSI iv BSI 2008This page deliberately left blank BS 8509:2008 Licensed CopyChinese University of Hong Kong, 21/10/2008 07:37, Uncontrolled Copy, (c) BSI BSI 20081 BS 85
17、09:2008 1 Scope This British Standard specifies requirements for the safety of childrens beds for domestic use with a maximum internal width of 1 000 mm and a maximum height of bed base of 400 mm. The requirements apply to childrens beds that are fully assembled and ready for use. This British Stand
18、ard does not apply to foldaway beds, bunk and high beds, cabin/mid-height beds, childrens cots, bedside cots and childrens cots that allow free access for the child by means of a hinged opening or removal of some vertical bars/slats. This standard does not cover products that have been incorporated
19、into childrens beds, for example luminaires, tables or storage furniture. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenc
20、ed document (including any amendments) applies. BS EN 71-1, Safety of toys Part 1: Mechanical and physical properties BS EN 71-2:2006, Safety of toys Part 2: Flammability BS EN 71-3, Safety of toys Part 3: Specification for migration of certain elements BS EN 716 (all parts), Furniture Childrens cot
21、s and folding cots for domestic use BS EN 717-2, Wood-based panels Determination of formaldehyde release Part 2: Formaldehyde release by the gas analysis method BS EN 1084, Plywood Formaldehyde release classes determined by the gas analysis method BS EN 1103, Textiles Fabrics for apparel Detailed pr
22、ocedure to determine the burning behaviour BS EN ISO 2439:2001, Flexible cellular polymeric materials Determination of hardness (indentation technique) BS EN ISO 14184-1, Textiles Determination of formaldehyde Part 1: Free and hydrolyzed formaldehyde (water extraction method) 3 Terms and definitions
23、 3.1childs bed cot bed, toddler bed or junior bed 3.2cot bed bed converted from a cot for use by one child aged 18 months to 4 years Licensed CopyChinese University of Hong Kong, 21/10/2008 07:37, Uncontrolled Copy, (c) BSI BS 8509:2008 2 BSI 2008 3.3toddler bed bed for use by one child aged 18 mont
24、hs to 4 years with a maximum internal length of 1 500 mm NOTE This might include child appealing designs such as cars, castles and four poster beds. 3.4junior bed bed for use by one child aged over 4 years NOTE This might include child appealing designs such as cars, castles and four poster beds. 3.
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- BS 8509 2008
链接地址:https://www.31doc.com/p-3737791.html