BS-EN-12899-1-2007.pdf
《BS-EN-12899-1-2007.pdf》由会员分享,可在线阅读,更多相关《BS-EN-12899-1-2007.pdf(66页珍藏版)》请在三一文库上搜索。
1、BRITISH STANDARD BS EN 12899-1:2007 Incorporating corrigendum May 2008 Fixed, vertical road traffic signs Part 1: Fixed signs ICS 93.080.30 ? -,-,- BS EN 12899-1:2007 This British Standard was published under the authority of the Standards Policy and Strategy Committee on 30 April 2008 BSI 2008 ISBN
2、 978 0 580 63057 6 National foreword This British Standard is the UK implementation of EN 12899-1:2007. It supersedes BS EN 12899-1:2001 which is withdrawn. The UK participation in its preparation was entrusted by Technical Committee B/509, Road equipment, to Subcommittee B/509/3, Traffic signs. A l
3、ist of organizations represented on this committee can be obtained on request to its secretary. Additional information BS EN 12899-1:2007 fully takes into account the requirements of the European Commission Mandate M/111, Circulation fixtures, given under the EU Construction Products Directive (89/1
4、06/EEC). BS EN 12899-1:2007 is a standard which sets down performance values (classes) rather than a method of manufacture. It has, in most cases, several performance classes for each characteristic. Some of these classes have a range of values. A manufacturer can supply a product that has the lowes
5、t value and still meet that class. Purchasers need to be aware of this when specifying requirements. BS EN 12899-1:2007 gives guidance and background information to manufacturers of fixed vertical road traffic signs on the use of BS EN 12899-1:2007. In particular it provides guidance in relation to
6、the information that a manufacturer requires from purchasers. This would enable road traffic signs to be designed and manufactured on the basis of that information whilst conforming to BS EN 12899-1:2007. Information on visual and physical performance classes is also included. Recommended classes fo
7、r visual and physical performance properties considered most suitable for UK practice are given in the National Annex. This publication does not purport to include all the necessary provisions of a contract. Users are responsible for its correct application. Compliance with a British Standard cannot
8、 confer immunity from legal obligations. Amendments/corrigenda issued since publication DateComments 30 May 2008Correction to Table NA.2 EUROPEAN STANDARD NORME EUROPENNE EUROPISCHE NORM EN 12899-1 November 2007 ICS 93.080.30Supersedes EN 12899-1:2001 English Version Fixed, vertical road traffic sig
9、ns - Part 1: Fixed signs Signaux fixes de signalisation routire verticale - Partie 1 : Panneaux fixes Ortsfeste, vertikale Straenverkehrszeichen - Teil 1: Verkehrszeichen This European Standard was approved by CEN on 4 February 2007. CEN members are bound to comply with the CEN/CENELEC Internal Regu
10、lations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN Management Centre or to any CEN member. This
11、 European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same status as the official versions. CEN members are t
12、he national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerla
13、nd and United Kingdom. EUROPEAN COMMITTEE FOR STANDARDIZATION COMIT EUROPEN DE NORMALISATION EUROPISCHES KOMITEE FR NORMUNG Management Centre: rue de Stassart, 36 B-1050 Brussels 2007 CENAll rights of exploitation in any form and by any means reserved worldwide for CEN national Members. Ref. No. EN
14、12899-1:2007: E -,-,- EN 12899-1:2007 (E) 2 Contents Page Foreword. 4 Introduction 5 1 Scope 6 2 Normative references . 6 3 Terms, definitions, symbols and abbreviations 7 4 Retroreflective sign face material . 8 4.1 Glass bead material 8 4.2 Microprismatic material 12 5 Structural performance 12 5.
15、1 General. 12 5.2 Partial safety factors. 14 5.3 Loads 14 5.4 Deflections. 16 6 Supports 20 6.1 Tops 20 6.2 Base compartments 20 6.3 Performance under vehicle impact. 20 6.4 Corrosion resistance 21 6.5 Base plates 21 7 Sign plates, sign faces, transilluminated signs, externally illuminated signs and
16、 supports. 21 7.1 Design 21 7.2 Sign faces 24 7.3 Transilluminated signs. 25 7.4 Externally illuminated signs 28 8 Sign assemblies 30 9 Marking, labelling and product information.30 9.1 General. 30 9.2 Marking and labelling . 30 9.3 Product information 30 9.4 Luminaires. 31 10 Evaluation of conformi
17、ty 31 11 Dangerous substances. 31 Annex A (normative) Test points for horizontal and vertical loads. 32 A.1 Wind load. 32 A.2 Snow clearance, dynamic load, load combination 41 BS EN 12899-1:2007 -,-,- EN 12899-1:2007 (E) 3 Annex ZA (informative) Clauses of this European Standard addressing the provi
18、sions of the EU Construction Products Directive .44 ZA.1 Scope and relevant characteristics.44 ZA.2 Procedure for attestation of conformity of fixed vertical road traffic signs51 ZA.3 CE marking and labelling52 National Annex NA (informative) Recommendations for fixed vertical traffic signs.58 BS EN
19、 12899-1:2007 -,-,- EN 12899-1:2007 (E) 4 Foreword This document (EN 12899-1:2007) has been prepared by Technical Committee CEN/TC 226 Road equipment the secretariat of which is held by AFNOR. This European Standard shall be given the status of a national standard, either by publication of an identi
20、cal text or by endorsement, at the latest by May 2008, and conflicting national standards shall be withdrawn at the latest by August 2009. This document supersedes EN 12899-1:2001. This European Standard has been prepared under a Mandate given to CEN by the European Commission and the European Free
21、Trade Association and supports essential requirements of EU Directives. For relationships with EU Directives, see informative Annex ZA, which is an integral part of this standard. This European Standard consists of the following Parts under the general title: Fixed, vertical road traffic signs Part
22、1: (This part) Fixed signs Part 2: Transilluminated traffic bollards (TTB) Part 3: Delineator posts and retroreflectors Part 4: Factory production control Part 5: Initial type testing It is based on performance requirements and test methods published in CEN, CENELEC, CIE (International Commission on
23、 Illumination) and ISO documents together with standards of the CEN member organizations. According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Cyprus, Czech Republ
24、ic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom. BS EN 12899-1:2007 -,-,- EN 12899-1:2007 (E) 5 Introducti
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- BS EN 12899 2007
链接地址:https://www.31doc.com/p-3739448.html