BS-EN-15283-2-2008.pdf
《BS-EN-15283-2-2008.pdf》由会员分享,可在线阅读,更多相关《BS-EN-15283-2-2008.pdf(44页珍藏版)》请在三一文库上搜索。
1、BRITISH STANDARD BS EN 15283-2:2008 Gypsum boards with fibrous reinforcement Definitions, requirements and test methods Part 2: Gypsum fibre boards ICS 91.100.10 ? Copyright British Standards Institution Provided by IHS under license with BSI - Uncontrolled Copy Licensee=Boeing Co/5910770001 Not for
2、 Resale, 08/14/2008 20:56:00 MDTNo reproduction or networking permitted without license from IHS -,-,- BS EN 15283-2:2008 This British Standard was published under the authority of the Standards Policy and Strategy Committee on 30 April 2008 BSI 2008 ISBN 978 0 580 55525 1 National foreword This Bri
3、tish Standard is the UK implementation of EN 15283-2:2008. The UK participation in its preparation was entrusted to Technical Committee B/544, Plastering, rendering, dry lining. A list of organizations represented on this committee can be obtained on request to its secretary. This publication does n
4、ot purport to include all the necessary provisions of a contract. Users are responsible for its correct application. Compliance with a British Standard cannot confer immunity from legal obligations. Amendments/corrigenda issued since publication DateComments Copyright British Standards Institution P
5、rovided by IHS under license with BSI - Uncontrolled Copy Licensee=Boeing Co/5910770001 Not for Resale, 08/14/2008 20:56:00 MDTNo reproduction or networking permitted without license from IHS -,-,- EUROPEAN STANDARD NORME EUROPENNE EUROPISCHE NORM EN 15283-2 February 2008 ICS 91.100.10 English Versi
6、on Gypsum boards with fibrous reinforcement - Definitions, requirements and test methods - Part 2: Gypsum fibre boards Plaques de pltre armes de fibres - Dfinitions, spcifications et mthodes dessai - Partie 2: Plaques de pltre fibres Faserverstrkte Gipsplatten - Begriffe, Anforderungen und Prfverfah
7、ren - Teil 2: Gipsfaserplatten This European Standard was approved by CEN on 28 December 2007. CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-da
8、te lists and bibliographical references concerning such national standards may be obtained on application to the CEN Management Centre or to any CEN member. This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under t
9、he responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same status as the official versions. CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hun
10、gary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom. EUROPEAN COMMITTEE FOR STANDARDIZATION COMIT EUROPEN DE NORMALISATION EUROPISCHES KOMITEE FR NORMUNG Management Cent
11、re: rue de Stassart, 36 B-1050 Brussels 2008 CENAll rights of exploitation in any form and by any means reserved worldwide for CEN national Members. Ref. No. EN 15283-2:2008: E Copyright British Standards Institution Provided by IHS under license with BSI - Uncontrolled Copy Licensee=Boeing Co/59107
12、70001 Not for Resale, 08/14/2008 20:56:00 MDTNo reproduction or networking permitted without license from IHS -,-,- EN 15283-2:2008 (E) 2 Contents Page Foreword4 Introduction.7 1 Scope 8 2 Normative references8 3 Terms and definitions .9 4 Requirements.11 4.1 Mechanical characteristics.11 4.2 Fire b
13、ehaviour11 4.3 Acoustic properties.12 4.4 Water vapour permeability / water vapour resistance (expressed as water vapour resistance factor) question for the mandate.12 4.5 Thermal resistance (expressed as thermal conductivity) .12 4.6 Dangerous substances .12 4.7 Dimensions and tolerances12 4.8 Addi
14、tional requirements for gypsum fibre boards with reduced surface water absorption types GF-W1 and GF-W2.13 4.9 Additional requirements for gypsum fibre boards with reduced water absorption rate13 4.10 Additional requirements for gypsum fibre boards with enhanced density type GF-D.13 4.11 Additional
15、requirements for gypsum fibre boards with enhanced surface hardness type GF-I .13 4.12 Impact resistance.13 5 Test methods13 5.1 Sampling.13 5.2 Determination of width14 5.3 Determination of length 14 5.4 Determination of thickness.15 5.5 Determination of squareness .16 5.6 Determination of flexural
16、 strength (bending strength)18 5.7 Determination of deflection under load.20 5.8 Determination of surface water absorption 21 5.9 Determination of total water absorption .22 5.10 Determination of density.22 5.11 Determination of surface hardness of the board .23 5.12 Determination of shear strength
17、(strength of board/substructure connection) .25 6 Evaluation of conformity.27 6.1 General27 6.2 Initial type testing 27 6.3 Factory production control.27 7 Designation of gypsum fibre boards.28 8 Marking, labelling and packaging29 Annex A (informative) Sampling procedure for testing.30 A.1 General30
18、 A.2 Sampling procedure30 Annex B (normative) Mounting and fixing for testing according to EN 13823 (SBI)31 BS EN 15283-2:2008 Copyright British Standards Institution Provided by IHS under license with BSI - Uncontrolled Copy Licensee=Boeing Co/5910770001 Not for Resale, 08/14/2008 20:56:00 MDTNo re
19、production or networking permitted without license from IHS -,-,- EN 15283-2:2008 (E) 3 Annex ZA (informative) Clauses of this European Standard addressing the provisions of EU Construction Products Directive .33 ZA.1 Scope and relevant characteristics.33 ZA.2 Procedure of attestation of conformity
20、of gypsum fibre boards34 ZA.3 CE marking and labelling .37 Bibliography40 BS EN 15283-2:2008 Copyright British Standards Institution Provided by IHS under license with BSI - Uncontrolled Copy Licensee=Boeing Co/5910770001 Not for Resale, 08/14/2008 20:56:00 MDTNo reproduction or networking permitted
21、 without license from IHS -,-,- EN 15283-2:2008 (E) 4 Foreword This document (EN 15283-2:2008) has been prepared by Technical Committee CEN/TC 241 “Gypsum and gypsum based products”, the secretariat of which is held by AFNOR. This European Standard shall be given the status of a national standard, e
22、ither by publication of an identical text or by endorsement, at the latest by August 2008, and conflicting national standards shall be withdrawn at the latest by November 2009. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. CEN a
23、nd/or CENELEC shall not be held responsible for identifying any or all such patent rights. This standard includes two parts: Part 1: Gypsum boards with mat reinforcement Part 2: Gypsum fibre boards This document has been prepared under a mandate given to CEN by the European Commission and the Europe
24、an Free Trade Association and supports essential requirements of EU Directive 89/106. For relationship with EU Directive(s) see informative Annex ZA which is an integral part of this document. According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following co
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- BS EN 15283 2008
链接地址:https://www.31doc.com/p-3740000.html