BS-EN-13999-1-2006.pdf
《BS-EN-13999-1-2006.pdf》由会员分享,可在线阅读,更多相关《BS-EN-13999-1-2006.pdf(22页珍藏版)》请在三一文库上搜索。
1、BRITISH STANDARD BS EN 13999-1:2006 Incorporating corrigendum no. 1 Adhesives Short term method for measuring the emission properties of low-solvent or solvent-free adhesives after application Part 1: General procedure The European Standard EN 13999-1:2006 has the status of a British Standard ICS 83
2、.180 ? Licensed Copy: London South Bank University, London South Bank University, Fri Feb 15 07:07:18 GMT+00:00 2008, Uncontrolled Copy, (c) BSI BS EN 13999-1:2006 This British Standard was published under the authority of the Standards Policy and Strategy Committee on 29 September 2006 BSI 2007 ISB
3、N 978 0 580 60654 0 National foreword This British Standard is the UK implementation of EN 13999-1:2006, incorporating corrigendum October 2007. It supersedes DD ENV 13999-1:2001 which is withdrawn. The UK participation in its preparation was entrusted to Technical Committee PRI/52, Adhesives. A lis
4、t of organizations represented on this committee can be obtained on request to its secretary. This publication does not purport to include all the necessary provisions of a contract. Users are responsible for its correct application. Compliance with a British Standard cannot confer immunity from leg
5、al obligations. Amendments issued since publication Amd. No. DateComments 17516 Corrigendum No. 1 31 December 2007 In Annex B, Clause B.2, replacement of equation B7 Licensed Copy: London South Bank University, London South Bank University, Fri Feb 15 07:07:18 GMT+00:00 2008, Uncontrolled Copy, (c)
6、BSI EUROPEAN STANDARD NORME EUROPENNE EUROPISCHE NORM EN 13999-1 August 2006 ICS 83.180Supersedes ENV 13999-1:2001 English Version Adhesives - Short term method for measuring the emission properties of low-solvent or solvent-free adhesives after application - Part 1: General procedure Adhsifs - Mtho
7、de de mesurage rapide des caractristiques missives des adhsifs teneur faible ou nulle en solvant aprs application - Partie 1 : Mode opratoire gnral Klebstoffe - Kurzzeit-Verfahren zum Messen der Emissionseigenschaften von lsemittelarmen oder lsemittelfreien Klebstoffen nach der Applikation - Teil 1:
8、 Allgemeines Verfahren This European Standard was approved by CEN on 1 August 2006. CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists an
9、d bibliographical references concerning such national standards may be obtained on application to the Central Secretariat or to any CEN member. This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibi
10、lity of a CEN member into its own language and notified to the Central Secretariat has the same status as the official versions. CEN members are the national standards bodies of Austria, Belgium, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, I
11、taly, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom. EUROPEAN COMMITTEE FOR STANDARDIZATION COMIT EUROPEN DE NORMALISATION EUROPISCHES KOMITEE FR NORMUNG Management Centre: rue de Stassart, 36 B
12、-1050 Brussels 2006 CENAll rights of exploitation in any form and by any means reserved worldwide for CEN national Members. Ref. No. EN 13999-1:2006: E Incorporating corrigendum October 2007 Licensed Copy: London South Bank University, London South Bank University, Fri Feb 15 07:07:18 GMT+00:00 2008
13、, Uncontrolled Copy, (c) BSI EN 13999-1:2006 (E) 2 Contents Page Foreword3 Introduction.4 1 Scope 5 2 Normative references5 3 Terms and definitions .6 4 Principle6 5 Apparatus .6 5.1 Support .6 5.2 Adhesive coating device.7 5.3 Emission test chamber .7 5.4 Air supply and mixing facilities7 5.5 Air s
14、ampling devices.8 5.6 Devices for desorption and analysis.8 6 Adhesive sample8 6.1 General8 6.2 Pre-conditioning 8 6.3 Preparation of a test specimen 8 7 Procedure .9 7.1 Number of determinations9 7.2 Preconditioning of the test chamber.9 7.3 Operation of the test chamber9 7.4 Starting of the test.9
15、 7.5 Sampling and analysis of emitted substances.9 8 Expression of results 10 8.1 Calculations10 8.2 Carcinogenic and sensitising compounds concentration 10 8.3 Volatile organic compounds.10 8.3.1 General10 8.3.2 Determination of the specific emission rate at the sampling times.11 8.3.3 Determinatio
16、n of the specific cumulative emission in the 24 h to 240 h interval .11 8.3.4 Determination of the empirical parameters a and b.12 9 Test report13 Annex A (normative) Carcinogenic and sensitising substances 14 Annex B (informative) Theoretical background of the calculation method15 B.1 Determination
17、 of the specific emission rate .15 B.2 Determination of the specific cumulative emission in the 24 h to 240 h interval15 Bibliography18 Licensed Copy: London South Bank University, London South Bank University, Fri Feb 15 07:07:18 GMT+00:00 2008, Uncontrolled Copy, (c) BSI EN 13999-1:2006 (E) 3 Fore
18、word This document (EN 13999-1:2006) has been prepared by Technical Committee CEN/TC 193 “Adhesives”, the secretariat of which is held by AENOR. This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by Feb
19、ruary 2007, and conflicting national standards shall be withdrawn at the latest by February 2007. This document supersedes ENV 13999-1:2001. EN 13999, under the general title “Adhesives Short term method for measuring the emission properties of low-solvent or solvent-free adhesives after application
20、”, consists of the following parts: - Part 1: General procedure - Part 2: Determination of volatile organic compounds - Part 3: Determination of volatile aldehydes - Part 4: Determination of volatile diisocyanates Safety statement Persons using this document should be familiar with the principles of
21、 normal laboratory. This document does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user to establish appropriate safety and health practices and ensure compliance with any regulatory conditions. According to the CEN/CENELEC Inte
22、rnal Regulations, the national standards organizations of the following countries are bound to implement this European Standard: Austria, Belgium, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Nethe
23、rlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom. Licensed Copy: London South Bank University, London South Bank University, Fri Feb 15 07:07:18 GMT+00:00 2008, Uncontrolled Copy, (c) BSI EN 13999-1:2006 (E) 4 Introduction Solvent-free and
24、low-solvent adhesives may release considerable long-term emissions of volatile chemical compounds. Any documentation of emission characteristics requires a test method which includes all relevant and potentially hazardous substances. The test shall: be reliable and reproducible; give results in a sh
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- BS EN 13999 2006
链接地址:https://www.31doc.com/p-3740188.html