BS-EN-60371-3-1-1995 IEC-60371-3-1-1984.pdf
《BS-EN-60371-3-1-1995 IEC-60371-3-1-1984.pdf》由会员分享,可在线阅读,更多相关《BS-EN-60371-3-1-1995 IEC-60371-3-1-1984.pdf(12页珍藏版)》请在三一文库上搜索。
1、BRITISH STANDARD BS EN 60371-3-1:1995 IEC 371-3-1: 1984 Specification for insulating materials based on mica Part 3: Specifications for individual materials Sheet 1: Commutator separators and materials The European Standard EN 60371-3-1:1995 has the status of a British Standard ICS 29.040.20 UDC 621
2、.315.613.1 Licensed Copy: sheffieldun sheffieldun, na, Thu Nov 09 15:14:22 GMT+00:00 2006, Uncontrolled Copy, (c) BSI BS EN 60371-3-1:1995 This British Standard, having been prepared under the direction of the Electrotechnical Sector Board, was published under the authority of the Standards Board an
3、d comes into effect on 15 December 1995 BSI 11-1999 The following BSI references relate to the work on this standard: Committee reference GEL/15 Draft announced in BSI News September 1995 ISBN 0 580 24977 8 Committees responsible for this British Standard The preparation of this British Standard was
4、 entrusted to Technical Committee GEL/15, Insulating materials, upon which the following bodies were represented: British Ceramic Research Ltd. British Industrial Ceramic Manufacturers Association British Telecommunications plc Department of Trade and Industry (National Physical Laboratory) Electric
5、al and Electronic Insulation Association (BEAMA Ltd.) Electricity Association Federation of the Electronics Industry Ministry of Defence Rotating Electrical Machines Association (BEAMA Ltd.) Transmission and Distribution Association (BEAMA Ltd.) The following bodies were also represented in the draf
6、ting of the standard, through subcommittees and panels: ERA Technology Ltd. Mica Trade Club Amendments issued since publication Amd. No.DateComments Licensed Copy: sheffieldun sheffieldun, na, Thu Nov 09 15:14:22 GMT+00:00 2006, Uncontrolled Copy, (c) BSI BS EN 60371-3-1:1995 BSI 11-1999i Contents P
7、age Committees responsibleInside front cover National forewordii Foreword2 Introduction3 1Scope3 2General requirements3 3Thickness3 4Dimensions, other than thickness4 5Detection of defects and conducting particles in sheets4 6Characteristics4 7Form4 8Marking4 Table I Thickness tolerances for sheets,
8、 strips and separators having a surface k 10 cm23 Table II Thickness tolerances for separators having a surface area greater than 10 cm24 Table III Requirements for materials based on mica splittings5 Table IV Requirements for materials based on mica paper6 List of referencesInside back cover Licens
9、ed Copy: sheffieldun sheffieldun, na, Thu Nov 09 15:14:22 GMT+00:00 2006, Uncontrolled Copy, (c) BSI BS EN 60371-3-1:1995 ii BSI 11-1999 National foreword This British Standard has been prepared by Technical Committee GEL/15 and is the English language version of EN 60371-3-1:1995 Specification for
10、insulating materials based on mica Part 3: Specifications for individual materials Sheet 1: Commutator separators and materials, published by the European Committee for Electrotechnical Standardization (CENELEC). It is identical with IEC 371-3-1:1984 published by the International Electrotechnical C
11、ommission (IEC). A British Standard does not purport to include all the necessary provisions of a contract. Users of British Standards are responsible for their correct application. Compliance with a British Standard does not of itself confer immunity from legal obligations. Cross-reference Publicat
12、ion referred toCorresponding British Standard IEC 371-2:1973BS 6236 Electrical insulating materials based on mica Part 2:1988 Methods of test Summary of pages This document comprises a front cover, an inside front cover, pages i and ii, the EN title page, pages 2 to 6, an inside back cover and a bac
13、k cover. This standard has been updated (see copyright date) and may have had amendments incorporated. This will be indicated in the amendment table on the inside front cover. Licensed Copy: sheffieldun sheffieldun, na, Thu Nov 09 15:14:22 GMT+00:00 2006, Uncontrolled Copy, (c) BSI EUROPEAN STANDARD
14、 NORME EUROPENNE EUROPISCHE NORM EN 60371-3-1 June 1995 UDC 621.315.613.1 ICS 29.040.20 Supersedes HD 352.3.1 S2:1987 Descriptors: Specifications, insulating materials, insulating materials based on mica, commutator separators and materials English version Specification for insulating materials base
15、d on mica Part 3: Specifications for individual materials Sheet 1: Commutator separators and materials (IEC 371-3-1:1984) Spcification pour les matriaux isolants base de mica Partie 3: Spcifications pour matriaux particuliers Feuille 1: Matriaux pour entrelames de collecteurs (CEI 371-3-1:1984) Best
16、immung fr Glimmererzeugnisse fr elektrotechnische Zwecke Teil 3: Bestimmungen fr einzelne Materialien Blatt 1: Kommutator-Isolierlamellen und -Materialien (IEC 371-3-1:1984) This European Standard was approved by CENELEC on 1995-05-15. CENELEC members are bound to comply with the CEN/CENELEC Interna
17、l Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the Central Secretariat or to any CENELEC memb
18、er. This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CENELEC member into its own language and notified to the Central Secretariat has the same status as the official versions. CENELEC
19、 members are the national electrotechnical committees of Austria, Belgium, Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and United Kingdom. CENELEC European Committee for Electrotechnical Standardization Com
20、it Europen de Normalisation Electrotechnique Europisches Komitee fr Elektrotechnische Normung Central Secretariat: rue de Stassart 35, B-1050 Brussels 1995 Copyright reserved to CENELEC members Ref. No. EN 60371-3-1:1995 E Licensed Copy: sheffieldun sheffieldun, na, Thu Nov 09 15:14:22 GMT+00:00 200
21、6, Uncontrolled Copy, (c) BSI EN 60371-3-1:1995 BSI 11-1999 2 Foreword The text of the International Standard IEC 371-3-1:1984, prepared by SC 15C, Specifications, of IEC TC 15, Insulating materials, was approved by CENELEC as HD 352.3.1 S2 on 1986-09-10. This Harmonization Document was submitted to
22、 the formal vote for conversion into a European Standard and was approved by CENELEC as EN 60371-3-1 on 1995-05-15. The following date was fixed: latest date by which the EN has to be implemented at national level by publication of an identical national standard or by endorsement(dop) 1996-07-01 Lic
23、ensed Copy: sheffieldun sheffieldun, na, Thu Nov 09 15:14:22 GMT+00:00 2006, Uncontrolled Copy, (c) BSI EN 60371-3-1:1995 BSI 11-19993 Introduction This standard is one of a series which deals with insulating materials for use in electrical equipment built up from mica splittings or mica paper, with
24、 or without reinforcement, and with mica paper in its pure state. The series consists of the three following parts: Part 1: Definitions and General Requirements; Part 2: Methods of Test; Part 3: Specifications for Individual Materials. 1 Scope This sheet of the standard applies to several types of r
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- BS-EN-60371-3-1-1995 IEC-60371-3-1-1984 BS EN 60371 1995 IEC 1984
链接地址:https://www.31doc.com/p-3745002.html