BS-EN-ISO-787-11-1995.pdf
《BS-EN-ISO-787-11-1995.pdf》由会员分享,可在线阅读,更多相关《BS-EN-ISO-787-11-1995.pdf(10页珍藏版)》请在三一文库上搜索。
1、BRITISH STANDARD BS EN ISO 787-11:1995 Incorporating Amendment No. 1 General methods of test for pigments and extenders Part 11: Determination of tamped volume and apparent density after tamping The European Standard EN ISO 787-11:1995 has the status of a British Standard Licensed Copy: sheffieldun
2、sheffieldun, na, Mon Nov 20 02:56:52 GMT+00:00 2006, Uncontrolled Copy, (c) BSI BS EN ISO 787-11:1995 This British Standard, having been prepared under the direction of the Pigments, Paints and Varnishes Standards Committee, was published under the authority of the Board of BSI and comes into effect
3、 on 30 November 1982 BSI 03-2000 First published March 1974 First revision November 1982 The following BSI references relate to the work on this standard: Committee reference PVC/1 Draft for comment 80/50595 DC ISBN 0 580 12939 X Amendments issued since publication Amd. No.Date of issueComments 8685
4、December 1995 Indicated by a sideline in the margin Licensed Copy: sheffieldun sheffieldun, na, Mon Nov 20 02:56:52 GMT+00:00 2006, Uncontrolled Copy, (c) BSI BS EN ISO 787-11:1995 BSI 03-2000i Contents Page National forewordii Foreword2 0Introduction3 1Scope and field of application3 2References3 3
5、Apparatus3 4Sampling3 5Procedure3 6Expression of results4 7Test report4 Figure Tamping volumeter4 Publications referred toInside back cover Licensed Copy: sheffieldun sheffieldun, na, Mon Nov 20 02:56:52 GMT+00:00 2006, Uncontrolled Copy, (c) BSI BS EN ISO 787-11:1995 ii BSI 03-2000 National forewor
6、d This revision of Part B10 of BS 3483 has been prepared under the direction of the Pigments, Paints and Varnishes Standards Committee. It is identical with ISO 787-11 “General methods of test for pigments and extenders Part 11: Determination of tamped volume and apparent density after tamping” publ
7、ished in 1981 by the International Organization for Standardization (ISO). In 1995 the European Committee for Standardization (CEN) accepted ISO 787-11:1981 as European Standard EN ISO 787-11:1995. As a consequence of implementing the European Standard this British Standard is renumbered as BS EN IS
8、O 787-11 and any reference to BS 3483-B10 should be read as a reference to BS EN ISO 787-11. This Part of BS 3483 supersedes BS 3483-B10:1974 which is withdrawn. Terminology and conventions. The text of the International Standard has been approved as suitable for publication as a British Standard wi
9、thout deviation. Some terminology and certain conventions are not identical with those used in British Standards; attention is especially drawn to the following. The comma has been used throughout as a decimal marker. In British Standards it is current practice to use a full point on the baseline as
10、 the decimal marker. Wherever the words “This part of ISO 787” and “International Standard” appear, referring to this standard, they should be read as “This Part of BS 3483” and “British Standard” respectively. The Technical Committee has reviewed the provisions of ISO 565, to which reference is mad
11、e in the text and has decided that they are acceptable for use in conjunction with this standard. A related British Standard for ISO 565:1972 is BS 410:1976 “Specification for test sieves”. Additional information. In the last paragraph of 5.2 of ISO 787-11:1981, it is stated that the whole procedure
12、 (clause 5) is to be repeated if the duplicate determinations differ by more than 10 ml. In implementing this standard in the United Kingdom, it is recommended that, if repeat determinations are necessary, wherever possible both the sampling (clause 4) and the procedure (clause 5) should be repeated
13、.1) A British Standard does not purport to include all the necessary provisions of a contract. Users of British Standards are responsible for their correct application. Compliance with a British Standard does not of itself confer immunity from legal obligations. Summary of pages This document compri
14、ses a front cover, an inside front cover, pages i and ii, the EN ISO title page, pages 2 to 4, an inside back cover and a back cover. This standard has been updated (see copyright date) and may have had amendments incorporated. This will be indicated in the amendment table on the inside front cover.
15、 Cross-references International StandardCorresponding British Standard ISO 842:1974BS 4726:1971 Methods for sampling raw materials for paints and varnishes (Technically equivalent) ISO 4788:1980BS 604:1982 Specification for graduated glass measuring cylinders (Identical) 1) This change has been repo
16、rted to the ISO in a proposal to amend the text of the International Standard. Licensed Copy: sheffieldun sheffieldun, na, Mon Nov 20 02:56:52 GMT+00:00 2006, Uncontrolled Copy, (c) BSI EUROPEAN STANDARD NORME EUROPENNE EUROPISCHE NORM EN ISO 787-11 August 1995 ICS 87.060.10; 87.060.30 Descriptors:
17、Paints, pigments, tests, chemical analysis, determination, density measurement, volume, volumeters English version General methods of test for pigments and extenders Part 11: Determination of tamped volume and apparent density after tamping (ISO 787-11:1981) Mthodes gnrales dessai des pigments et ma
18、tires de charge Partie 11: Dtermination du masse volumique apparent et de la masse apparente aprs tassement (ISO 787-11:1981) Allgemeine Prfverfahren fr Pigmente und Fllstoffe Teil 11: Bestimmung des Stampfvolumens und der Stampfdichte (ISO 787-11:1981) This European Standard was approved by CEN on
19、1995-03-23. CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be o
20、btained on application to the Central Secretariat or to any CEN member. This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the Central S
21、ecretariat has the same status as the official versions. CEN members are the national standards bodies of Austria, Belgium, Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and United Kingdom. CEN European Commi
22、ttee for Standardization Comit Europen de Normalisation Europisches Komitee fr Normung Central Secretariat: rue de Stassart 36, B-1050 Brussels 1995 All rights of reproduction and communication in any form and by any means reserved in all countries to CEN and its members Ref. No. EN ISO 787-11:1995
23、E Licensed Copy: sheffieldun sheffieldun, na, Mon Nov 20 02:56:52 GMT+00:00 2006, Uncontrolled Copy, (c) BSI EN ISO 787-11:1995 BSI 03-2000 2 Foreword The text of the International Standard from ISO/TC 35, Paints and varnishes, of the International Organization for Standardization (ISO) has been tak
24、en over as a European Standard by the Technical Committee CEN/TC 298, Pigments and extenders. This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by February 1996, and conflicting national standards shal
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- BS EN ISO 787 11 1995
链接地址:https://www.31doc.com/p-3746989.html