BS-ISO-25639-1-2008.pdf
《BS-ISO-25639-1-2008.pdf》由会员分享,可在线阅读,更多相关《BS-ISO-25639-1-2008.pdf(26页珍藏版)》请在三一文库上搜索。
1、BS ISO 25639-1:2008 ICS 01.020 NO COPYING WITHOUT BSI PERMISSION EXCEPT AS PERMITTED BY COPYRIGHT LAW BRITISH STANDARD Exhibitions, shows, fairs and conventions Part 1: Vocabulary Licensed Copy: London South Bank University, South Bank University, 31/01/2009 03:26, Uncontrolled Copy, (c) BSI This Br
2、itish Standard was published under the authority of the Standards Policy and Strategy Committee on 31 December 2008 BSI 2008 ISBN 978 0 580 58687 3 Amendments/corrigenda issued since publication DateComments BS ISO 25639-1:2008 National foreword This British Standard is the UK implementation of BS I
3、SO 25639-1:2008. The UK participation in its preparation was entrusted to Technical Committee SVS/1/2, Exhibitions and Trade Fairs. A list of organizations represented on this committee can be obtained on request to its secretary. This publication does not purport to include all the necessary provis
4、ions of a contract. Users are responsible for its correct application. Compliance with a British Standard cannot confer immunity from legal obligations. Licensed Copy: London South Bank University, South Bank University, 31/01/2009 03:26, Uncontrolled Copy, (c) BSI BS ISO 25639-1:2008BS ISO 25639-1:
5、2008 Reference number Numro de rfrence ISO 25639-1:2008(E/F) ISO 2008 INTERNATIONAL STANDARD NORME INTERNATIONALE ISO 25639-1 First edition Premire dition 2008-11-15 Exhibitions, shows, fairs and conventions Part 1: Vocabulary Terminologie du secteur des foires, salons et congrs ou manifestations co
6、mmerciales Partie 1: Vocabulaire Licensed Copy: London South Bank University, South Bank University, 31/01/2009 03:26, Uncontrolled Copy, (c) BSI BS ISO 25639-1:2008BS ISO 25639-1:2008 ISO 25639-1:2008(E/F) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licens
7、ing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobes licensing policy. The ISO
8、Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been
9、 taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. PDF Exonration de responsabilit Le prsent fichier PDF peut contenir des polices de caractres intgre
10、s. Conformment aux conditions de licence dAdobe, ce fichier peut tre imprim ou visualis, mais ne doit pas tre modifi moins que lordinateur employ cet effet ne bnficie dune licence autorisant lutilisation de ces polices et que celles-ci y soient installes. Lors du tlchargement de ce fichier, les part
11、ies concernes acceptent de fait la responsabilit de ne pas enfreindre les conditions de licence dAdobe. Le Secrtariat central de lISO dcline toute responsabilit en la matire. Adobe est une marque dpose dAdobe Systems Incorporated. Les dtails relatifs aux produits logiciels utiliss pour la cration du
12、 prsent fichier PDF sont disponibles dans la rubrique General Info du fichier; les paramtres de cration PDF ont t optimiss pour limpression. Toutes les mesures ont t prises pour garantir lexploitation de ce fichier par les comits membres de lISO. Dans le cas peu probable o surviendrait un problme du
13、tilisation, veuillez en informer le Secrtariat central ladresse donne ci-dessous. COPYRIGHT PROTECTED DOCUMENT DOCUMENT PROTG PAR COPYRIGHT ISO 2008 The reproduction of the terms and definitions contained in this International Standard is permitted in teaching manuals, instruction booklets, technica
14、l publications and journals for strictly educational or implementation purposes. The conditions for such reproduction are: that no modifications are made to the terms and definitions; that such reproduction is not permitted for dictionaries or similar publications offered for sale; and that this Int
15、ernational Standard is referenced as the source document. With the sole exceptions noted above, no other part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO a
16、t the address below or ISOs member body in the country of the requester. La reproduction des termes et des dfinitions contenus dans la prsente Norme internationale est autorise dans les manuels denseignement, les modes demploi, les publications et revues techniques destins exclusivement lenseignemen
17、t ou la mise en application. Les conditions dune telle reproduction sont les suivantes: aucune modification nest apporte aux termes et dfinitions; la reproduction nest pas autorise dans des dictionnaires ou publications similaires destins la vente; la prsente Norme internationale est cite comme docu
18、ment source. la seule exception mentionne ci-dessus, aucune partie de cette publication ne peut tre reproduite ni utilise sous quelque forme que ce soit et par aucun procd, lectronique ou mcanique, y compris la photocopie et les microfilms, sans laccord crit de lISO ladresse ci-aprs ou du comit memb
19、re de lISO dans le pays du demandeur. ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyrightiso.org Web www.iso.org Published in Switzerland/Publi en Suisse ii ISO 2008 All rights reserved/Tous droits rservs Licensed Copy: London South Ba
20、nk University, South Bank University, 31/01/2009 03:26, Uncontrolled Copy, (c) BSI BS ISO 25639-1:2008BS ISO 25639-1:2008 ISO 25639-1:2008(E/F) ISO 2008 All rights reserved/Tous droits rservs iii Foreword ISO (the International Organization for Standardization) is a worldwide federation of national
21、standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International
22、 organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules g
23、iven in the ISO/IEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at leas
24、t 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. ISO 25639-1 was prepared by Project Committee ISO/PC 237,
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- BS ISO 25639 2008
链接地址:https://www.31doc.com/p-3748331.html