DD-CEN-TS-15436-3-2009.pdf
《DD-CEN-TS-15436-3-2009.pdf》由会员分享,可在线阅读,更多相关《DD-CEN-TS-15436-3-2009.pdf(10页珍藏版)》请在三一文库上搜索。
1、DD CEN/TS 15436-3:2009 ICS 43.160 NO COPYING WITHOUT BSI PERMISSION EXCEPT AS PERMITTED BY COPYRIGHT LAW DRAFT FOR DEVELOPMENT Road service area maintenance equipment Part 3: Classification Licensed CopyChinese University of Hong Kong, 13/06/2009 08:46, Uncontrolled Copy, (c) BSI This Draft for Deve
2、lopment was published under the authority of the Standards Policy and Strategy Committee on 30 April 2009 BSI 2009 ISBN 978 0 580 63640 0 Amendments/corrigenda issued since publication DateComments DD CEN/TS 15436-3:2009 National foreword This Draft for Development is the UK implementation of CEN/TS
3、 15436-3:2009. This publication is not to be regarded as a British Standard. It is being issued in the Draft for Development series of publications and is of a provisional nature. It should be applied on this provisional basis, so that information and experience of its practical application can be o
4、btained. Comments arising from the use of this Draft for Development are requested so that UK experience can be reported to the international organization responsible for its conversion to an international standard. A review of this publication will be initiated not later than 3 years after its publ
5、ication by the international organization so that a decision can be taken on its status. Notification of the start of the review period will be made in an announcement in the appropriate issue of Update Standards. According to the replies received by the end of the review period, the responsible BSI
6、 Committee will decide whether to support the conversion into an international Standard, to extend the life of the Technical Specification or to withdraw it. Comments should be sent to the Secretary of the responsible BSI Technical Committee at British Standards House, 389 Chiswick High Road, London
7、 W4 4AL. The UK participation in its preparation was entrusted to Technical Committee B/513, Construction equipment and plant and site safety. A list of organizations represented on this committee can be obtained on request to its secretary. This publication does not purport to include all the neces
8、sary provisions of a contract. Users are responsible for its correct application. Compliance with a British Standard cannot confer immunity from legal obligations. Licensed CopyChinese University of Hong Kong, 13/06/2009 08:46, Uncontrolled Copy, (c) BSI DD CEN/TS 15436-3:2009 TECHNICAL SPECIFICATIO
9、N SPCIFICATION TECHNIQUE TECHNISCHE SPEZIFIKATION CEN/TS 15436-3 February 2009 ICS 43.160 English Version Road service area maintenance equipment - Part 3: Classification Matriel dentretien des dpendances routires - Partie 3: Classification Straenbetriebsdienstausstattung - Teil 3: Klassifikation Th
10、is Technical Specification (CEN/TS) was approved by CEN on 22 December 2008 for provisional application. The period of validity of this CEN/TS is limited initially to three years. After two years the members of CEN will be requested to submit their comments, particularly on the question whether the
11、CEN/TS can be converted into a European Standard. CEN members are required to announce the existence of this CEN/TS in the same way as for an EN and to make the CEN/TS available promptly at national level in an appropriate form. It is permissible to keep conflicting national standards in force (in p
12、arallel to the CEN/TS) until the final decision about the possible conversion of the CEN/TS into an EN is reached. CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy
13、, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom. EUROPEAN COMMITTEE FOR STANDARDIZATION COMIT EUROPEN DE NORMALISATION EUROPISCHES KOMITEE FR NORMUNG Management Centre: Avenue Marnix 17, B-1000
14、Brussels 2009 CENAll rights of exploitation in any form and by any means reserved worldwide for CEN national Members. Ref. No. CEN/TS 15436-3:2009: E Licensed CopyChinese University of Hong Kong, 13/06/2009 08:46, Uncontrolled Copy, (c) BSI DD CEN/TS 15436-3:2009 CEN/TS 15436-3:2009 (E) 2 Contents P
15、age Foreword 3? Introduction .4? 1?Scope 5? 2?Normative references 5? 3?Terms and definitions .5? 4?Definition of machine classes 5? 4.1?Machine class .5? 4.2?Tolerances on characteristics for machine construction .7? Licensed CopyChinese University of Hong Kong, 13/06/2009 08:46, Uncontrolled Copy,
16、 (c) BSI DD CEN/TS 15436-3:2009 CEN/TS 15436-3:2009 (E) 3 Foreword This document (CEN/TS 15436-3:2009) has been prepared by Technical Committee CEN/TC 337 “Winter maintenance and road service area maintenance equipment”, the secretariat of which is held by AFNOR. Attention is drawn to the possibilit
17、y that some of the elements of this document may be the subject of patent rights. CEN and/or CENELEC shall not be held responsible for identifying any or all such patent rights. This Technical Specification was prepared with the aim of having a 3-year lifetime. This European standard comprises four
18、parts: EN 15436-1, Road service area maintenance equipment Part 1: Terminology; EN 15436-2, Road service area maintenance equipment Part 2: Performance assessment; CEN/TS 15436-3, Road service area maintenance equipment Part 3: Classification; prEN 15436-4, Road service area maintenance equipment Pa
19、rt 4: Delivery acceptance of the machines by the users. According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following countries are bound to announce this Technical Specification: Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland
20、, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and the United Kingdom. Licensed CopyChinese University of Hong Kong, 13/06/2009 08:46, Uncontrolled Copy,
21、 (c) BSI DD CEN/TS 15436-3:2009 CEN/TS 15436-3:2009 (E) 4 Introduction Road service area grass cutting, brushcutting and mechanical plant cutting operations require special equipment that meets clearly defined technical criteria. This Technical Specification defines and describes the classification
22、criteria of the machines with respect to their kinematic and power performances. The performance evaluation is described in part 2 of this European standard. Licensed CopyChinese University of Hong Kong, 13/06/2009 08:46, Uncontrolled Copy, (c) BSI DD CEN/TS 15436-3:2009 CEN/TS 15436-3:2009 (E) 5 1
23、Scope This Technical Specification defines the classification criteria of the road service area maintenance equipment described in the scope of EN 15436-1 and used for: grass cutting and brushcutting; mechanical plant cutting. This equipment is mounted on self-propelled carrying vehicles and is inte
24、nded, on the one hand, for cutting and shredding grass and brushwood, and, on the other hand, for trimming trees, saplings and bushes in road service areas. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only th
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- DD CEN TS 15436 2009
链接地址:https://www.31doc.com/p-3752763.html