DD-IEC-TS-61968-2-2003.pdf
《DD-IEC-TS-61968-2-2003.pdf》由会员分享,可在线阅读,更多相关《DD-IEC-TS-61968-2-2003.pdf(26页珍藏版)》请在三一文库上搜索。
1、DRAFT FOR DEVELOPMENT DD IEC TS 61968-2:2003 Application integration at electric utilities System interfaces for distribution management Part 2: Glossary ICS 33.200 ? Licensed Copy: London South Bank University, London South Bank University, Tue Dec 12 04:23:03 GMT+00:00 2006, Uncontrolled Copy, (c)
2、 BSI DD IEC TS 61968-2:2003 This Draft for Development was published under the authority of the Standards Policy and Strategy Committee on 8 March 2004 BSI 8 March 2004 ISBN 0 580 43535 0 National foreword This Draft for Development reproduces verbatim IEC TS 61968-2:2003. This publication is not to
3、 be regarded as a British Standard. It is being issued in the Draft for Development series of publications and is of a provisional nature because the source document is an IEC Technical Specification which is not an International Standard. It should be applied on this provisional basis, so that info
4、rmation and experience of its practical application may be obtained. Comments arising for the use of this Draft for Development are requested so that UK experience can be reported to the International organization responsible for the Technical Specification. A review of this publication will be init
5、iated not later than 3 years after its publication by the International organization so that a decision can be taken on its status at the end of its 3-year life. Notification of the start of the review period will be made in an announcement in the appropriate issue of Update Standards. According to
6、the replies received by the end of the review period, the responsible BSI Committee will decide whether to support the conversion into an International Standard, to extend the life of the Technical Specification for another 3 years or to withdraw it. Comments should be sent in writing to the Secreta
7、ry of BSI Technical Committee PEL/57, Power system control and associated communications, at British Standards House, 389 Chiswick High Road, London W4 4AL, giving the document reference and clause number and proposing, where possible, an appropriate revision of the text. A list of organizations rep
8、resented on this committee can be obtained on request to its secretary. Cross-references The British Standards which implement international publications referred to in this document may be found in the BSI Catalogue under the section entitled “International Standards Correspondence Index”, or by us
9、ing the “Search” facility of the BSI Electronic Catalogue or of British Standards Online. Summary of pages This document comprises a front cover, an inside front cover, the IEC TS title page, pages 2 to 23 and a back cover. The BSI copyright date displayed in this document indicates when the documen
10、t was last issued. Amendments issued since publication Amd. No. DateComments Licensed Copy: London South Bank University, London South Bank University, Tue Dec 12 04:23:03 GMT+00:00 2006, Uncontrolled Copy, (c) BSI TECHNICAL SPECIFICATION IEC TS 61968-2 First edition 2003-11 Application integration
11、at electric utilities System interfaces for distribution management Part 2: Glossary Reference number IEC/TS 61968-2:2003(E) 3002:286916 ST CEIDD IEC TS 619682:2003 Licensed Copy: London South Bank University, London South Bank University, Tue Dec 12 04:23:03 GMT+00:00 2006, Uncontrolled Copy, (c) B
12、SI 2 TS 91686-2 CEI:0230(E) CONTENTS FOREWORD.3 INTRODUCTION.5 1 Scope.6 2 Terms and definitions .6 3 Glossary of abbreviations in the IEC 61968 series20 Bibliography23 3002:286916 ST CEI 2 DD IEC TS 619682:2003 2 Licensed Copy: London South Bank University, London South Bank University, Tue Dec 12
13、04:23:03 GMT+00:00 2006, Uncontrolled Copy, (c) BSI TS 91686-2 IE:C2003(E) 3 INTERNATIONAL ELECTROTECHNICAL COMMISSION _ APPLICATION INTEGRATION AT ELECTRIC UTILITIES SYSTEM INTERFACES FOR DISTRIBUTION MANAGEMENT Part 2: Glossary FOREWORD 1) The International Electrotechnical Commission (IEC) is a w
14、orldwide organization for standardization comprising all national electrotechnical committees (IEC National Committees). The object of IEC is to promote international co-operation on all questions concerning standardization in the electrical and electronic fields. To this end and in addition to othe
15、r activities, IEC publishes International Standards, Technical Specifications, Technical Reports, Publicly Available Specifications (PAS) and Guides (hereafter referred to as “IEC Publication(s)”). Their preparation is entrusted to technical committees; any IEC National Committee interested in the s
16、ubject dealt with may participate in this preparatory work. International, governmental and non- governmental organizations liaising with the IEC also participate in this preparation. IEC collaborates closely with the International Organization for Standardization (ISO) in accordance with conditions
17、 determined by agreement between the two organizations. 2) The formal decisions or agreements of IEC on technical matters express, as nearly as possible, an international consensus of opinion on the relevant subjects since each technical committee has representation from all interested IEC National
18、Committees. 3) IEC Publications have the form of recommendations for international use and are accepted by IEC National Committees in that sense. While all reasonable efforts are made to ensure that the technical content of IEC Publications is accurate, IEC cannot be held responsible for the way in
19、which they are used or for any misinterpretation by any end user. 4) In order to promote international uniformity, IEC National Committees undertake to apply IEC Publications transparently to the maximum extent possible in their national and regional publications. Any divergence between any IEC Publ
20、ication and the corresponding national or regional publication shall be clearly indicated in the latter. 5) IEC provides no marking procedure to indicate its approval and cannot be rendered responsible for any equipment declared to be in conformity with an IEC Publication. 6) All users should ensure
21、 that they have the latest edition of this publication. 7) No liability shall attach to IEC or its directors, employees, servants or agents including individual experts and members of its technical committees and IEC National Committees for any personal injury, property damage or other damage of any
22、 nature whatsoever, whether direct or indirect, or for costs (including legal fees) and expenses arising out of the publication, use of, or reliance upon, this IEC Publication or any other IEC Publications. 8) Attention is drawn to the Normative references cited in this publication. Use of the refer
23、enced publications is indispensable for the correct application of this publication. 9) Attention is drawn to the possibility that some of the elements of this IEC Publication may be the subject of patent rights. IEC shall not be held responsible for identifying any or all such patent rights. The ma
24、in task of IEC technical committees is to prepare International Standards. In exceptional circumstances, a technical committee may propose the publication of a technical specification when the required support cannot be obtained for the publication of an International Standard, despite repeated effo
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- DD IEC TS 61968 2003
链接地址:https://www.31doc.com/p-3752986.html