ECA-535BAAC-A-1998.pdf
《ECA-535BAAC-A-1998.pdf》由会员分享,可在线阅读,更多相关《ECA-535BAAC-A-1998.pdf(23页珍藏版)》请在三一文库上搜索。
1、a a a m I o u3 (3 v) I w a . I S T D - E I A 535BAAC-A-ENGL 1998 3234b00 Ob15177 T5L I I EIA SPECIFICATION ANS WU-535BAAC-A-1998 Approved: October 28,1998 Fixed Tantalum Chip Capacitor Style 1 Protected (molded) EIA-53SBAAC-A (Revision of EIA-535BAAC) NOVEMBER 1998 ELECTRONIC INDUSTRIES ALLIANCE Ele
2、ctronic Components, Assemblies, Equipment “ H Suax in case size indicates high profile W, = texmination widths, H, = termination heights; H, = solderability inspection heights A notch in the anode and/or cathode side metaiiization is at the option of the component manufacturer. The termination width
3、 metaiization applies oniy to the portion of the termination where contact is made to the PWB. The terminations may neck down on the height dimension to the tennination width (W,) at the mounting level on the PWB. Copyright Electronic Components, Assemblies see NOTE 2 Standard range Extended range a
4、nd high profile Low profile Tolerance on rated capacitance Rated voltage (UR); see NOTE 1 Category voltage (Uc) Climatic category Rated temperature Variation of capacitance with temperature Leakage current; see NOTE 3 Tangent of loss angle (dissipation factor); see NOTE 2 Insulation resistance Equiv
5、alent series resistance (ESR); see NOTE 2 Ripple current ratings Power dissipation Impedance Surge voltage Terminations NOTES 0.1 pF to 470 pF Table 2 Table 3 Table 4 i 10 % and f 20 % 4 V - 50 V (See tables 2 to 4.) See tables 2 to 4. -551125156 85 “C See table 5a-h. See table 5a-h. 4% to 8% ; see
6、table 5a-h Not applicable 0.5 ohm to 25.0 ohms 100 kHz; see table 5a-h See table 5a-h See table 7 Not applicable See table 8 Solderable 1 Rated voltages (d are minimum. Capacitors with DC voltage ratings (Ud higher than that ordered (within the same case size) may be supplied at manufacturers option
7、. Voltage substitutions w i l l be marked w i t h the higher DC voltage rating (U equivalent series resistance shall be measured at 100 kHz. Unless othenvise specified, a l l elechical measurements shall be made at or referred to 25 “C f 5 “C w i t h a relative humiity of 45 % - 75% at atmospheric p
8、ressure 101.325 H a (760 dg). Copyright Electronic Components, Assemblies jl . . . . . . . . . . . . . . . . . . . . . . . . . . I u I I Copyright Electronic Components, Assemblies AmendmentsNo. 2 (1987), No. 3 (1989) andNo. 4 (1992). Sectional specification:IEC Publication 384-3 (1 989), Fixed Capa
9、citors For Use In Electronic Equipment, Part 3 : Sectional specification: Fixed tantalum chip capacitors. 5 Marking (all cases) 5.1 Component marking (all cases) As a minimum, shall consist of coded capacitance value and voltage rating, manufacturers ID and polarity designators. Orientation and date
10、 code marking at manufacturers option. 5 . 1 . 1 6 . 3 volt product Capacitors rated at 6.3 volts (Ud, may be marked with 6 or 6.3, or equivalent letter code, to idente voltage rating (Ud, at manufacturers option. 5.1.2 Voltage substitutions Higher voltage substitutions within the ordered case size
11、wili be marked with the higher DC voltage rating Wd 5.2 Reel marking BatchAoddate code identification for traceability purposes shall be marked on reel. Bar coding is permitted per EIA 556. 6 Ordering information Orders for capacitors covered by this specification shail contain, in clear or coded fo
12、rm, the following minimum information: a) rated capacitance (Cd; b) tolerance on rated capacitance; c) rated DC voltage; d) case size in E L A format; e) number and issue reference of the Detail Specification and Style Reference. 7 Certified records of released lots Not required. Copyright Electroni
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ECA 535 BAAC 1998
链接地址:https://www.31doc.com/p-3755736.html