FORD-ESA-M4D281-A-2006.pdf
《FORD-ESA-M4D281-A-2006.pdf》由会员分享,可在线阅读,更多相关《FORD-ESA-M4D281-A-2006.pdf(2页珍藏版)》请在三一文库上搜索。
1、 ENGINEERING MATERIAL SPECIFICATION Date Action Revisions 2006 10 12 N-STATUS Replaced by ESB-M4D308-A R. Lord 2005 01 14 Revised Inserted 3.0; Deleted 3.4 & 4 1969 01 08 Released CAX2-917090 Printed copies are uncontrolled Copyright 2006, Ford Global Technologies, LLC Page 1 of 2 POLYPROPYLENE, GEN
2、ERAL PURPOSE - EXTRUSION GRADE ESA-M4D281-A NOT TO BE USED FOR NEW DESIGN 1. SCOPE The material defined by this specification is a polypropylene polymer or copolymer molding compound suitable for extrusion. 2. APPLICATION This specification was released originally for materials used for extruded ite
3、ms such as jacketing in cable assemblies. 3. REQUIREMENTS 3.0 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.1 MOLDED TEST SPECIMENS - BASE MATERIAL (Specimens prepar
4、ed per ASTM D 2146) 3.1.1 Specific Gravity 0.890 - 0.920 (ASTM D 792) 3.1.2 Flow Rate, max 2.5 g/10 min (ASTM D 1238, Condition “L“) 3.1.3 Melting Point, min 160 C (FLTM BO 021-02) 3.1.4 Tensile Strength, at yield, min 3,500 psi (24.2 MPa) (ASTM D 638, Speed “C“) Elongation, at max load, min 8.0% 3.
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- FORD ESA M4D281 2006
链接地址:https://www.31doc.com/p-3756144.html