ETSI EN-300-019-1-2-2003.pdf
《ETSI EN-300-019-1-2-2003.pdf》由会员分享,可在线阅读,更多相关《ETSI EN-300-019-1-2-2003.pdf(11页珍藏版)》请在三一文库上搜索。
1、 ETSI EN 300 019-1-2 V2.1.4 (2003-04) European Standard (Telecommunications series) Environmental Engineering (EE); Environmental conditions and environmental tests for telecommunications equipment; Part 1-2: Classification of environmental conditions; Transportation ETSI ETSI EN 300 019-1-2 V2.1.4
2、(2003-04) 2 Reference REN/EE-01027-1-22 Keywords environment, testing, equipment practice ETSI 650 Route des Lucioles F-06921 Sophia Antipolis Cedex - FRANCE Tel.: +33 4 92 94 42 00 Fax: +33 4 93 65 47 16 Siret N 348 623 562 00017 - NAF 742 C Association but non lucratif enregistre la Sous-Prfecture
3、 de Grasse (06) N 7803/88 Important notice Individual copies of the present document can be downloaded from: http:/www.etsi.org The present document may be made available in more than one electronic version or in print. In any case of existing or perceived difference in contents between such version
4、s, the reference version is the Portable Document Format (PDF). In case of dispute, the reference shall be the printing on ETSI printers of the PDF version kept on a specific network drive within ETSI Secretariat. Users of the present document should be aware that the document may be subject to revi
5、sion or change of status. Information on the current status of this and other ETSI documents is available at http:/portal.etsi.org/tb/status/status.asp If you find errors in the present document, send your comment to: editoretsi.org Copyright Notification No part may be reproduced except as authoriz
6、ed by written permission. The copyright and the foregoing restriction extend to reproduction in all media. European Telecommunications Standards Institute 2003. All rights reserved. DECTTM, PLUGTESTSTM and UMTSTM are Trade Marks of ETSI registered for the benefit of its Members. TIPHONTM and the TIP
7、HON logo are Trade Marks currently being registered by ETSI for the benefit of its Members. 3GPPTM is a Trade Mark of ETSI registered for the benefit of its Members and of the 3GPP Organizational Partners. ETSI ETSI EN 300 019-1-2 V2.1.4 (2003-04) 3 Contents Intellectual Property Rights4 Foreword.4
8、1 Scope5 2 References5 3 Definitions5 4 Environmental classes6 4.1 Class 2.1: Very careful transportation6 4.2 Class 2.2: Careful transportation6 4.3 Class 2.3: Public transportation7 5 Environmental conditions.7 5.1 Climatic conditions.7 5.2 Biological conditions8 5.3 Chemically active substances.8
9、 5.4 Mechanically active substances8 5.5 Mechanical conditions9 Annex A (normative): Summary of applications of classes 2.1, 2.2 and 2.3 applied to the climatic conditions for different areas as defined in IEC 60721-2-1.10 History11 ETSI ETSI EN 300 019-1-2 V2.1.4 (2003-04) 4 Intellectual Property R
10、ights IPRs essential or potentially essential to the present document may have been declared to ETSI. The information pertaining to these essential IPRs, if any, is publicly available for ETSI members and non-members, and can be found in ETSI SR 000 314: “Intellectual Property Rights (IPRs); Essenti
11、al, or potentially Essential, IPRs notified to ETSI in respect of ETSI standards“, which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web server (http:/webapp.etsi.org/IPR/home.asp). All published ETSI deliverables shall include information which directs the reade
12、r to the above source of information. Foreword This European Standard (Telecommunications series) has been produced by ETSI Technical Committee Environmental Engineering (EE). The present document is part 1, sub-part 2 of a multi-part deliverable covering the classification of environmental conditio
13、ns and environmental tests for telecommunications equipment, as identified below: Part 1: “Classification of environmental conditions“; Sub-part 0: “Introduction“; Sub-part 1: “Storage“; Sub-part 2: “Transportation“; Sub-part 3: “Stationary use at weatherprotected locations“; Sub-part 4: “Stationary
14、 use at non-weatherprotected locations“; Sub-part 5: “Ground vehicle installations“; Sub-part 6: “Ship environments“; Sub-part 7: “Portable and non-stationary use“; Sub-part 8: “Stationary use at underground locations“; Part 2: “Specification of environmental tests“. Part 1 specifies different stand
15、ardized environmental classes covering climatic and biological conditions, chemically and mechanically active substances and mechanical conditions during storage, transportation and in use. Part 1-0 forms a general overview of part 1. Part 2 specifies the recommended test severities and test methods
16、 for the different environmental classes. National transposition dates Date of latest announcement of this EN (doa): 31 July 2003 Date of latest publication of new National Standard or endorsement of this EN (dop/e): 31 January 2004 Date of withdrawal of any conflicting National Standard (dow): 31 J
17、anuary 2004 ETSI ETSI EN 300 019-1-2 V2.1.4 (2003-04) 5 1 Scope The present document defines classes of environmental conditions and their severities to which telecommunication equipment may be exposed. The severities specified are those which will have a low probability of being exceeded; generally
18、 less than 1 %. The present document applies to equipment being transported from one place to another after being made ready for dispatch from the manufacturers works. The most commonly used methods of transportation have been taken into account, i.e. ground, water and air transport. Loading and unl
19、oading as well as temporary storage, have been included. Where the equipment is packaged the environmental conditions apply to the packaged equipment. NOTE: Normal transportation time is considered to be 30 days or less. Where the total transportation time exceeds 30 days then additional storage or
20、packaging precautions must be considered. 2 References The following documents contain provisions which, through reference in this text, constitute provisions of the present document. References are either specific (identified by date of publication and/or edition number or version number) or non-sp
21、ecific. For a specific reference, subsequent revisions do not apply. For a non-specific reference, the latest version applies. Referenced documents which are not found to be publicly available in the expected location might be found at http:/docbox.etsi.org/Reference. 1 ETSI ETR 035: “Equipment Engi
22、neering (EE); Environmental engineering; Guidance and terminology“. 2 IEC 60721-3-2: “Classification of environmental conditions - Part 3: Classification of groups of environmental parameters and their severities - Section 2: Transportation“. 3 IEC 60721-2-1: “Classification of environmental conditi
23、ons. Part 2: Environmental conditions appearing in nature. Temperature and humidity“. 4 IEC 60068-2-27: “Environmental testing. Part 2: Tests. Test Ea and guidance: Shock“. 5 ETSI EN 300 019-2-2: “Equipment Engineering (EE); Environmental conditions and environmental tests for telecommunications equ
24、ipment; Part 2-2: Specification of environmental tests; Transportation“. 3 Definitions For the purposes of the present document, the following terms and definitions apply: absolute humidity: mass of water vapour in grammes which is associated with one cubic metre of dry air in an air/water vapour mi
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ETSI EN-300-019-1-2-2003 EN 300 019 2003
链接地址:https://www.31doc.com/p-3756172.html