FORD-FLTM-BN-106-02-2001.pdf
《FORD-FLTM-BN-106-02-2001.pdf》由会员分享,可在线阅读,更多相关《FORD-FLTM-BN-106-02-2001.pdf(5页珍藏版)》请在三一文库上搜索。
1、FORD LABORATORY TEST METHOD BN 106-02 Date Action 2001 10 31 Revised 1995 O 9 29 SEAM FATIGUE TESTING Revisions Editorial - no technical change R. Moore Application This test method is used to determine the ability of fabric or vinyl/polymeric film coated seating fabric to resist tearing or needle h
2、ole elongation of a sewn seam under cyclic loading when evaluated per this test procedure. Apparatus and Materials Required Sewing Machine Capable of producing a lock stitched seam as described under Procedure, Para. 2. Singer 21 1 U566 or Juki lock stitch industrial type Source: Singer Sewing Machi
3、ne Co. Ltd. 41 5 Bonhill Street London E.C.2 Source: M. J. Foley Company 16580 Eastland Roseville, MI 48066 Phone (31 3) 779-5050 Fax (31 3) 776-1 278 Needle Type 180/24 (1.8 mm dia, set R (round point) - unless otherwise specified in the Engineering Material Specification. Source: Singer Sewing Mac
4、hine Co. Ltd or See above M. J. Foley Company or Eurosew Ltd. 7 Stafford Place Moulton Park Ind. Estate Northampton Northamptons hire NN3 INN Copynght02001, Ford Global Technologies, Inc -,-,- FORD LABORATORY TEST METHOD BN 106-02 or Ferd. Schmetz GmbH 51 2 Herzogenrath, Merkensteinerstrasse 53 Germ
5、any or Approved alternative Thread WSD-Ml5H51 D and E respectively or equivalent, for top and bottom, unless otherwise specified in the Engineering Material Specification. Seam Fatigue Tester Model ATD-2 Source: Ogawa Seiki Co. LTD Tokyo Central P.O. Box 1618 Tel. Tokyo 03-3367-821 1 Fax. Tokyo 03-3
6、367-8581.8582 Conditioning and Test Conditions All sst values indicated herein are based on material conditioned in a con “olled atmosphere of 23 +/- 2 O C and 50 +/- 5 % relative humidity for not less than 24 h prior to testing and tested under the same conditions unless otherwise specified. Proced
7、ure 1. Evaluate 5 warp and 5 fill test specimens for source approval (the warp specimen is sewn on the fill edge and the fill specimen is sewn on the warp edge). For in process testing, evaluate the worse case direction only. 2. Cut out 2 pieces 1 O0 x 1 O0 mm for each test specimen, and sew 1 O mm
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- FORD FLTM BN 106 02 2001
链接地址:https://www.31doc.com/p-3756296.html