GMNA-9981802-1991.pdf
《GMNA-9981802-1991.pdf》由会员分享,可在线阅读,更多相关《GMNA-9981802-1991.pdf(2页珍藏版)》请在三一文库上搜索。
1、I GENERAL MOTORS ENGINEERING STANDARDS IMaterlals and Processes - Fuels it shall not be perfumed and shall not become rancid or show component separation for a minimum of 6 months. The p a s e must not be toxic or injurious to per- sonnel engaged in its handling or use. 3.1 Fhysicai Properties. See
2、Table 1. 3.2 Functional Requirements. Material must perform satisfao torily in its specified automotive hardware applications between the temperahue of S O T and -3oC. 3.3 Chemical Requirements. See Table 2. 4 INITIAL SOURCE APPROVAL. No shipment shaii be made by any supplier until representative in
3、itial production samples have been approved by engineering as meeting the requirements of this specification. 4.1 Completed copies of the GM Material Safety Data Sheet and Critical Material Register (available from the engineering department or laboratory), or equivalent, must be submitted with any
4、new submissions or where a composition change has occurred. 5 INSPECTION AND REJECTION. Ail shipments of material or parts under contract or purchase order manufac- tured to this specification shaii be equivalent in every respect to the initial samples approved by engineering. There shall be no chan
5、ges in either formulation or manufactwing processes permitted without prior notification and approval by engineer- ing. Lack of notification by the supplier constitutes grounds for rejection of any shipment. While samples may be taken from incoming shipments and checked for conformance to this speci
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- GMNA 9981802 1991
链接地址:https://www.31doc.com/p-3764967.html