GMNA-GMP.E-P.121-2003.pdf
《GMNA-GMP.E-P.121-2003.pdf》由会员分享,可在线阅读,更多相关《GMNA-GMP.E-P.121-2003.pdf(2页珍藏版)》请在三一文库上搜索。
1、 ENGINEERING STANDARDS Material Specification Plastics GMP.E/P.121 Polyolefin Alloy 1300 MPa Flexural Modulus, 20% Mineral Filled, High Flow 1 Scope 1.1 Material Description. This specification covers the properties of a high melt flow rate, 20% nominal mineral filled, 1300 MPa nominal flexural modu
2、lus polyolefin alloy, pellet form, injection molding compound. For the purpose of this specification, polyolefin alloy is defined as an alloy of polypropylene plastic and EP or EPDM rubber. 1.1.1 Paintability. Approved paint systems that can be used on this material are listed in the GM Approved Pai
3、nt on Parts Systems (GM APOPS) database. 1.2 Symbol. The material abbreviation according to ISO 11469 is E/P. 1.3 Typical Application. Typical applications include the following: body side moldings, claddings, rockers, and wheel flares 2 References Note: Only the latest approved standards are applic
4、able unless otherwise specified. 2.1External Standards/Specifications. ASTM E228 ISO 1133 ASTM D3763 ISO 1183 ISO 178 ISO 3451/1 ISO 294 ISO 11469 ISO 527 2.2 GM Standards/Specifications. GMW3001 GMW3221 GMW3059 3 Requirements Important physical, mechanical and thermal properties that characterize t
5、he material are summarized in charts. The color shall be specified on drawings, in material specifications and otherwise. 3.1 Requirements on Test Specimens. Unless otherwise specified, test specimens shall be injection molded according to ISO 294. Test shall be conducted 40 hours minimum after mold
6、ing and immediately following a conditioning period of 24 hours minimum at conditions per GMW3221, Code A. All tests shall be performed on unannealed specimens. Tests shall be conducted using the latest issue of the test methods indicated. Suitable precautions should be taken to ensure that applicab
7、le safe limits are not exceeded when conducting test procedures, processes, and/or handling the materials required by this specification. Requirements on Parts Copyright 2003 General Motors Corporation All Rights Reserved December 2003 Originating Department: North American Engineering Standards Pag
8、e 1 of 2 Copyright General Motors North America Provided by IHS under license with GM Licensee=IHS Employees/1111111001, User=Japan, IHS Not for Resale, 06/23/2008 21:07:47 MDTNo reproduction or networking permitted without license from IHS -,-,- GMP.E/P.121 GM ENGINEERING STANDARDS 3.2 Compound Pro
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- GMNA GMP 121 2003
链接地址:https://www.31doc.com/p-3765060.html