GMW-15078-2006.pdf
《GMW-15078-2006.pdf》由会员分享,可在线阅读,更多相关《GMW-15078-2006.pdf(3页珍藏版)》请在三一文库上搜索。
1、 WORLDWIDE ENGINEERING STANDARDS Test Procedure Body Closures GMW15078 Structural Integrity of Window Regulator Components Copyright 2006 General Motors Corporation All Rights Reserved August 2006 Originating Department: North American Engineering Standards Page 1 of 3 1 Scope Note: Nothing in the s
2、pecification supersedes applicable laws and regulations unless specific exemption has been obtained. Note: In the event of conflict between the English and domestic language, the English language shall take precedence. 1.1 Purpose. The purpose of this procedure is to evaluate the structural integrit
3、y of window regulator components. This procedure covers the creep behavior of regulator. 1.2 Foreword. Not applicable. 1.3 Applicability. This procedure applies to all cable-drive regulator systems. 2 References Note: Only the latest approved standards are applicable unless otherwise specified. 2.1
4、External Standards/Specifications. None 2.2 GM Standards/Specifications. None 2.3 Additional References. Applicable CTS 3 Resources 3.1 Facilities. The regulator supplier is responsible for this test, which should be performed at suppliers facilities. 3.2 Equipment. Testing should be performed using
5、 a test fixture as shown in Appendix A Figure A1. 3.3 Test Vehicle/Test Piece. One (1) sample. 3.4 Test Time. Calendar time: 13 to 15 working days Test hours: 300 hours Coordination hours 40 to 60 hours 3.5 Test Required Information. Not applicable. 3.6 Personnel/Skills. Not applicable. 4 Procedure
6、4.1 Preparation. Not applicable. 4.2 Conditions. 4.2.1 Environmental Conditions. Not applicable. 4.2.2 Test Conditions. Deviations from the requirements of the procedure shall have been agreed upon. Such requirements shall be specified on component drawings, test certificates, reports, etc. 4.3 Inst
7、ructions. 4.3.1 Mount the regulator in a fixed rigid fixture as shown in Appendix A Figure A1. Attach the rigid rod to the carriers. Attach the rigid stop to the rigid fixture. Set the carrier blocks at the glass-fully-up positions. Mount the regulator so all of the components, including pulleys, sl
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- GMW 15078 2006
链接地址:https://www.31doc.com/p-3767594.html