GMB-EMS.AI.0564-1996.pdf
《GMB-EMS.AI.0564-1996.pdf》由会员分享,可在线阅读,更多相关《GMB-EMS.AI.0564-1996.pdf(3页珍藏版)》请在三一文库上搜索。
1、ENGINEERING MATERIAL SPECIFICATION BRASIL PRODUCT ENGINEERING spacer NUMBER: DATE: 4 PAGE EMSAI 0919 I 1 O f 3 - Zspaador I Description This specification covers a polyurethane agglomerated foam flaker, with a self adhesive in one side protected by an anti adherent paper, used as spacer. 2 Requireme
2、nts 2.1 Density Without adhesive - according to GME60283 part 1 at 23C - + 5% relative humidity: 0.160 g/cm3 5 0.010 g/cm3. 2c and 65% 1 Descrio Esta especificao cobre flocos de espuma de poliuretano aglomerado, com auto adesivo em um lado protegido por papel anti aderente, usado como espaador. 2 Re
3、quisitos 2.1 Densidade Sem adesivo - conforme GME60283 parL2 1 a 23C 2 2c e 65% 5 5% de umidade relativa: 0,160 g/cm3 5 0,010 g/cm3. 2.2 Adeso 2.2 Adhesion The part shall be adhered on electrocoated primer EMS.9309738 panel with a manual pressure, according to production line assembling for two situ
4、ation described below without drop down. A pea deve ser aderida em painel com “prim e r ” e I et ro I it i co E M S. 9 3 O 9 7 3 8 com presso manual, conforme a montagem na linha de produo em duas situaes descritas abaixo sem queda. 2.2.1 Adeso a baixa temperatura 2.2.1 Low temperature adhesion The
5、electrocoated primer panel shall be placed in a freezer operating at +SC during 30 minutes. The part shall be adhered without remove the panel of the freezer and conditioned at the same temperature during 24 hours in upside down position. O painel com “primer” eletroltico deve ser colocado em um fre
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- GMB EMS AI 0564 1996
链接地址:https://www.31doc.com/p-3767686.html