GMW-15045-2006.pdf
《GMW-15045-2006.pdf》由会员分享,可在线阅读,更多相关《GMW-15045-2006.pdf(3页珍藏版)》请在三一文库上搜索。
1、 WORLDWIDE ENGINEERING STANDARDS Test Procedure Body Closures GMW15045 Window Regulator Efficiency Copyright 2006 General Motors Corporation All Rights Reserved August 2006 Originating Department: North American Engineering Standards Page 1 of 3 1 Scope Note: Nothing in the specification supersedes
2、applicable laws and regulations unless specific exemption has been obtained. Note: In the event of conflict between the English and domestic language, the English language shall take precedence. 1.1 Purpose. To determine the window regulator efficiency. 1.2 Foreword. Not applicable. 1.3 Applicabilit
3、y. This procedure applies to all cable-drive regulator system. 2 References Note: Only the latest approved standards are applicable unless otherwise specified. 2.1 External Standards/Specifications. None 2.2 GM Standards/Specifications. None 3 Resources 3.1 Facilities. The regulator supplier is resp
4、onsible for this test, which should be performed at suppliers facilities. 3.2 Equipment. Window Regulator mounting fixture used for regulator durability testing. 3.3 Test Vehicle/Test Piece. Prototype regulator which meets design intent. 3.4 Test Time. Calendar time: 1 day Test hours: 1 hour Coordin
5、ation hours: 2 hours 3.5 Test Required Information. Not applicable. 3.6 Personnel/Skills. Not applicable. 4 Procedure 4.1 Preparation. Remove motor from window regulator to expose the gear inside the cable drum. 4.2 Conditions. 4.2.1 Environmental Conditions. Test to be done at ambient at normal hum
6、idity. 4.2.2 Test Conditions. Deviations from the requirements of the procedure shall have been agreed upon. Such requirements shall be specified on component drawings, test certificates, reports, etc. Figure A: Regulator Diagram with Points A, B, and C noted Note: Loading Positions A: Near Front Ca
7、rrier, B: Middle between Front and Rear Carriers and C: Near Rear Carrier. 4.3 Instructions. 4.3.1. Mount the regulator in a fixed rigid fixture. 4.3.2 Measure the length of AC. B is the middle point of AC. 4.3.3 Place various weights at position A (W). 4.3.4 Use a torque wrench to move the weight u
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- GMW 15045 2006
链接地址:https://www.31doc.com/p-3768608.html