《IEC-TR-61010-3-041-1999.pdf》由会员分享,可在线阅读,更多相关《IEC-TR-61010-3-041-1999.pdf(72页珍藏版)》请在三一文库上搜索。
1、TECHNICAL REPORT IEC TR 61010-3-041 First edition 1999-10 Safety requirements for electrical equipment for measurement, control, and laboratory use Part 3-041: Conformity verification report for IEC 61010-2-041:1995, Particular requirements for autoclaves using steam for the treatment of medical mat
2、erials, and for laboratory processes Rgles de scurit pour appareils lectriques de mesurage, de rgulation et de laboratoire Partie 3-041: Rapport de vrification de la conformit de la CEI 61010-2-041:1995, Prescriptions particulires pour autoclaves utilisant de la vapeur pour le traitement des matriel
3、s usage mdical et durant les procds de traitement de laboratoire Reference number IEC/TR 61010-3-041:1999(E) Copyright International Electrotechnical Commission Provided by IHS under license with IECLicensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/09/2007 00:10:16 MSTNo reprod
4、uction or networking permitted without license from IHS -,-,- Numbering As from 1 January 1997 all IEC publications are issued with a designation in the 60000 series. Consolidated publications Consolidated versions of some IEC publications including amendments are available. For example, edition num
5、bers 1.0, 1.1 and 1.2 refer, respectively, to the base publication, the base publication incorporating amendment 1 and the base publication incorporating amendments 1 and 2. Validity of this publication The technical content of IEC publications is kept under constant review by the IEC, thus ensuring
6、 that the content reflects current technology. Information relating to the date of the reconfirmation of the publication is available in the IEC catalogue. Information on the subjects under consideration and work in progress undertaken by the technical committee which has prepared this publication,
7、as well as the list of publications issued, is to be found at the following IEC sources: IEC web site* Catalogue of IEC publications Published yearly with regular updates (On-line catalogue)* IEC Bulletin Available both at the IEC web site* and as a printed periodical Terminology, graphical and lett
8、er symbols For general terminology, readers are referred to IEC 60050: International Electrotechnical Vocabulary (IEV). For graphical symbols, and letter symbols and signs approved by the IEC for general use, readers are referred to publications IEC 60027: Letter symbols to be used in electrical tec
9、hnology, IEC 60417: Graphical symbols for use on equipment. Index, survey and compilation of the single sheets and IEC 60617: Graphical symbols for diagrams. * See web site address on title page. Copyright International Electrotechnical Commission Provided by IHS under license with IECLicensee=IHS E
10、mployees/1111111001, User=Wing, Bernie Not for Resale, 03/09/2007 00:10:16 MSTNo reproduction or networking permitted without license from IHS -,-,- TECHNICAL REPORT IEC TR 61010-3-041 First edition 1999-10 Safety requirements for electrical equipment for measurement, control, and laboratory use Par
11、t 3-041: Conformity verification report for IEC 61010-2-041:1995, Particular requirements for autoclaves using steam for the treatment of medical materials, and for laboratory processes Rgles de scurit pour appareils lectriques de mesurage, de rgulation et de laboratoire Partie 3-041: Rapport de vri
12、fication de la conformit de la CEI 61010-2-041:1995, Prescriptions particulires pour autoclaves utilisant de la vapeur pour le traitement des matriels usage mdical et durant les procds de traitement de laboratoire PRICE CODE IEC 1999 Copyright - all rights reserved No part of this publication may be
13、 reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from the publisher. International Electrotechnical Commission3, rue de Varemb Geneva, Switzerland Telefax: +41 22 919 0300e-mail: inmailiec.ch IEC web si
14、te http:/www.iec.ch V For price, see current catalogue Commission Electrotechnique Internationale International Electrotechnical Commission Copyright International Electrotechnical Commission Provided by IHS under license with IECLicensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 0
15、3/09/2007 00:10:16 MSTNo reproduction or networking permitted without license from IHS -,-,- 2 TR 61010-3-041 IEC:1999(E) CONTENTS Page FOREWORD 3 Conformity verification report IEC 61010-3-041. 5 Clause 5Marking and documentation 10 6Protection against electric shock 16 7Protection against mechanic
16、al hazards. 23 8Mechanical resistance to shock, vibration and impact . 26 Mechanical resistance to shock and impact (AM 2) 9Equipment temperature limits and protection against the spread of fire . 27 10Resistance to heat . 28 11Resistance to moisture and liquids . 29 Protection against hazards from
17、fluids (AM 2) 12Protection against radiation, including laser sources, and against sonic and ultrasonic pressure. 31 13Protection against liberated gases, explosion and implosion . 31 14Components. 32 15Protection by interlocks 35 16Measuring circuits (AM 2). 35 Annex K (AM 2) 35 Table 1 Documents a
18、ttached to this report . 7 Table 2 Test equipment list 8 Table 3 List of components relied on for safety 9 Form A.1 to Form A.30 .36 to 65 Copyright International Electrotechnical Commission Provided by IHS under license with IECLicensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03
19、/09/2007 00:10:16 MSTNo reproduction or networking permitted without license from IHS -,-,- TR 61010-3-041 IEC:1999(E) 3 INTERNATIONAL ELECTROTECHNICAL COMMISSION _ SAFETY REQUIREMENTS FOR ELECTRICAL EQUIPMENT FOR MEASUREMENT, CONTROL, AND LABORATORY USE Part 3-041: Conformity verification report fo
20、r IEC 61010-2-041:1995, Particular requirements for autoclaves using steam for the treatment of medical materials, and for laboratory processes FOREWORD 1)The IEC (International Electrotechnical Commission) is a worldwide organization for standardization comprising all national electrotechnical comm
21、ittees (IEC National Committees). The object of the IEC is to promote international co-operation on all questions concerning standardization in the electrical and electronic fields. To this end and in addition to other activities, the IEC publishes International Standards. Their preparation is entru
22、sted to technical committees; any IEC National Committee interested in the subject dealt with may participate in this preparatory work. International, governmental and non-governmental organizations liaising with the IEC also participate in this preparation. The IEC collaborates closely with the Int
23、ernational Organization for Standardization (ISO) in accordance with conditions determined by agreement between the two organizations. 2)The formal decisions or agreements of the IEC on technical matters express, as nearly as possible, an international consensus of opinion on the relevant subjects s
24、ince each technical committee has representation from all interested National Committees. 3)The documents produced have the form of recommendations for international use and are published in the form of standards, technical specifications, technical reports or guides and they are accepted by the Nat
25、ional Committees in that sense. 4)In order to promote international unification, IEC National Committees undertake to apply IEC International Standards transparently to the maximum extent possible in their national and regional standards. Any divergence between the IEC Standard and the corresponding
26、 national or regional standard shall be clearly indicated in the latter. 5)The IEC provides no marking procedure to indicate its approval and cannot be rendered responsible for any equipment declared to be in conformity with one of its standards. 6)Attention is drawn to the possibility that some of
27、the elements of this technical report may be the subject of patent rights. The IEC shall not be held responsible for identifying any or all such patent rights. The main task of IEC technical committees is to prepare International Standards. However, a technical committee may propose the publication
28、of a technical report when it has collected data of a different kind from that which is normally published as an International Standard, for example “state of the art“. Technical reports do not necessarily have to be reviewed until the data they provide are considered to be no longer valid or useful
29、. IEC 61010-3-041, which is a technical report, has been prepared by IEC technical committee 66: Safety of measuring, control, and laboratory equipment. The text of this technical report is based on the following documents: Enquiry draftReport on voting 66/193/CDV66/217/RVC Full information on the v
30、oting for the approval of this technical report can be found in the report on voting indicated in the above table. Copyright International Electrotechnical Commission Provided by IHS under license with IECLicensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/09/2007 00:10:16 MSTNo
31、reproduction or networking permitted without license from IHS -,-,- 4 TR 61010-3-041 IEC:1999(E) This publication has been drafted in accordance with the ISO/IEC Directives, Part 3. This report is a Technical Report and is of a purely informative nature and is therefore by itself not to be regarded
32、as an International Standard. It is for use by testhouses and other users to assist them with determining and recording verification of conformity of the equipment under test with the requirements of IEC 61010-2-041: 1997, and IEC 61010-1: 1990 + amendment 1: 1992 or IEC 61010-1: 1990 + amendment 1:
33、 1992 + amendment 2: 1995 The protocol for completion of this report is contained in publication IEC 61010-3:1997. Requirements which apply only to amendment 2 to IEC 61010-1 are indicated by “(AM 2)“ in the first column. Requirements deleted by amendment 2 to IEC 61010-1 are indicated by “(AM 1 onl
34、y)“ in the second column. The IEC sells read-only PDF files as a general rule. In the present instance, and quite exceptionally, to enable the user to fill in the forms, a revisable file is included in a pocket affixed to the back cover of this publication. This publication can be downloaded from th
35、e Web as a PDF file. There is, however, at the end of the document, a revisable file containing the forms. Please use the zip/unzip function. A bilingual version will not be issued. A French version may be issued. Copyright International Electrotechnical Commission Provided by IHS under license with
36、 IECLicensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/09/2007 00:10:16 MSTNo reproduction or networking permitted without license from IHS -,-,- TR 61010-3-041 IEC:1999(E) 5 Conformity Verification Report IEC 61010-2-041 Safety requirements for electrical equipment for measurem
37、ent, control, and laboratory use: Part 2-041: Particular requirements for autoclaves using steam for the treatment of medical materials, and for laboratory processes Report reference No : Compiled by (+ signature): Approved by (+ signature): Date of issue: Testing organization.: Address: Testing loc
38、ation: Applicant: Address: Standard :IEC 61010-2-041:1995 and IEC 61010-1:1990 + amendment 1:1992 or IEC 61010-1:1990 + amendment 1:1992+ amendment 2:1995 Copyright blank test report.:This report has been prepared by IEC/TC 66, which retains responsibility for any changes or corrections required. Te
39、st procedure.: Procedure deviation.: Non-standard test method .: Type of item tested :? Laboratory Trademark: Model/type rfrence .: Manufacturer: Rating.: Copy of rating plate: Copyright International Electrotechnical Commission Provided by IHS under license with IECLicensee=IHS Employees/1111111001
40、, User=Wing, Bernie Not for Resale, 03/09/2007 00:10:16 MSTNo reproduction or networking permitted without license from IHS -,-,- 6 TR 61010-3-041 IEC:1999(E) Description of equipment function: INSTALLATION/OVERVOLTAGE CATEGORY: POLLUTION DEGREE: Environmental rating:? Standard? Other (specify): Equ
41、ipment mobility:? Portable? Hand-held? Floorstanding? Fixed ? Built in? Benchmounted? Other (specify): Connection to mains supply:? Permanent? Detachable ? Non-detachable? None Operating conditions:? Continuous? Short-time? Intermittent Overall size of the equipment (Length Width Height): Mass of th
42、e equipment (kg): Marked degree of protection to IEC 60529: IP_ _ Accessories and detachable parts included in the evaluation: Options: NOTE “(see Form A.X)“ refers to a form appended to the report. Copyright International Electrotechnical Commission Provided by IHS under license with IECLicensee=IH
43、S Employees/1111111001, User=Wing, Bernie Not for Resale, 03/09/2007 00:10:16 MSTNo reproduction or networking permitted without license from IHS -,-,- TR 61010-3-041 IEC:1999(E) 7 Table 1 Documents attached to this report Document No.Document description Number of pages Copyright International Elec
44、trotechnical Commission Provided by IHS under license with IECLicensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/09/2007 00:10:16 MSTNo reproduction or networking permitted without license from IHS -,-,- 8 TR 61010-3-041 IEC:1999(E) Table 2 Test equipment list Equipment Calibrat
45、ion date No. Last1)Due 1) or interval between calibrations. CommentsTypeItem Copyright International Electrotechnical Commission Provided by IHS under license with IECLicensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/09/2007 00:10:16 MSTNo reproduction or networking permitted w
46、ithout license from IHS -,-,- Table 3 List of components relied on for safety Unique component reference or location (including drawing reference if required) Application/Function Manufacturer and part number (note 1) RATING (note 2) Licence number, file number or other documentary evidence of accep
47、tance NOTE 1 List all manufacturers concerned. NOTE 2 Electrical, mechanical, flammability, etc. TR 61010-3-041 IEC:1999(E) 9 Copyright International Electrotechnical Commission Provided by IHS under license with IECLicensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/09/2007 00:10:16 MSTNo reproduction or networking permitted without license from IHS -,-,- 10 TR 61010-3-041 IEC:1999(E) Result: P = Pass F = Fail NA = Not Applicable Clause Subclause RequirementResultComments 5Marking and documentation 5.1.1General Required equipment markings are: a) visible: from the
链接地址:https://www.31doc.com/p-3769118.html