《IEC-TR-61010-3-010-1999.pdf》由会员分享,可在线阅读,更多相关《IEC-TR-61010-3-010-1999.pdf(68页珍藏版)》请在三一文库上搜索。
1、TECHNICAL REPORT IEC 61010-3-010 First edition 1999-02 Safety requirements for electrical equipment for measurement, control, and laboratory use Part 3-010: Conformity verification report for IEC 61010-2-010, Particular requirements for laboratory equipment for the heating of materials Rgles de scur
2、it pour appareils lectriques de mesurage, de rgulation et de laboratoire Partie 3-010: Rapport de vrification de la conformit de la CEI 61010-2-010, Prescriptions particulires pour appareils de laboratoire utiliss pour lchauffement des matires Reference number IEC 61010-3-010:1999(E) Copyright Inter
3、national Electrotechnical Commission Provided by IHS under license with IECLicensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/09/2007 03:01:45 MSTNo reproduction or networking permitted without license from IHS -,-,- Numbering As from 1 January 1997 all IEC publications are issu
4、ed with a designation in the 60000 series. Consolidated publications Consolidated versions of some IEC publications including amendments are available. For example, edition numbers 1.0, 1.1 and 1.2 refer, respectively, to the base publication, the base publication incorporating amendment 1 and the b
5、ase publication incorporating amendments 1 and 2. Validity of this publication The technical content of IEC publications is kept under constant review by the IEC, thus ensuring that the content reflects current technology. Information relating to the date of the reconfirmation of the publication is
6、available in the IEC catalogue. Information on the subjects under consideration and work in progress undertaken by the technical committee which has prepared this publication, as well as the list of publications issued, is to be found at the following IEC sources: IEC web site* Catalogue of IEC publ
7、ications Published yearly with regular updates (On-line catalogue)* IEC Bulletin Available both at the IEC web site* and as a printed periodical Terminology, graphical and letter symbols For general terminology, readers are referred to IEC 60050: International Electrotechnical Vocabulary (IEV). For
8、graphical symbols, and letter symbols and signs approved by the IEC for general use, readers are referred to publications IEC 60027: Letter symbols to be used in electrical technology, IEC 60417: Graphical symbols for use on equipment. Index, survey and compilation of the single sheets and IEC 60617
9、: Graphical symbols for diagrams. * See web site address on title page. Copyright International Electrotechnical Commission Provided by IHS under license with IECLicensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/09/2007 03:01:45 MSTNo reproduction or networking permitted withou
10、t license from IHS -,-,- TECHNICAL REPORT IEC 61010-3-010 First edition 1999-02 Safety requirements for electrical equipment for measurement, control, and laboratory use Part 3-010: Conformity verification report for IEC 61010-2-010, Particular requirements for laboratory equipment for the heating o
11、f materials Rgles de scurit pour appareils lectriques de mesurage, de rgulation et de laboratoire Partie 3-010: Rapport de vrification de la conformit de la CEI 61010-2-010, Prescriptions particulires pour appareils de laboratoire utiliss pour lchauffement des matires Commission Electrotechnique Int
12、ernationale International Electrotechnical Commission PRICE CODE IEC 1999 Copyright - all rights reserved No part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from the publ
13、isher. International Electrotechnical Commission3, rue de Varemb Geneva, Switzerland Telefax: +41 22 919 0300e-mail: inmailiec.ch IEC web site http: /www.iec.ch V For price, see current catalogue Copyright International Electrotechnical Commission Provided by IHS under license with IECLicensee=IHS E
14、mployees/1111111001, User=Wing, Bernie Not for Resale, 03/09/2007 03:01:45 MSTNo reproduction or networking permitted without license from IHS -,-,- 2 61010-3-010 IEC:1999(E) CONTENTS Page FOREWORD .3 Conformity verification report for IEC 61010-2-010.5 Clause 5Marking and documentation 10 6Protecti
15、on against electric shock.16 7Protection against mechanical hazards .25 8Mechanical resistance to shock and impact.25 9Equipment temperature limits and protection against the spread of fire26 10Resistance to heat28 11Protection against hazards from fluids.28 12Protection against radiation, including
16、 laser sources, and against sonic and ultrasonic pressure.29 13Protection against liberated gases, explosion and implosion30 14Components .31 15Protection by interlocks.32 16Measuring circuits.32 Annex K Routine tests .32 Tables 1Documents attached to this report.7 2Test equipment list .8 3List of c
17、omponents relied on for safety9 Form A.1 to Form A.29 33 to 61 Copyright International Electrotechnical Commission Provided by IHS under license with IECLicensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/09/2007 03:01:45 MSTNo reproduction or networking permitted without license
18、 from IHS -,-,- 61010-3-010 IEC:1999(E) 3 INTERNATIONAL ELECTROTECHNICAL COMMISSION _ SAFETY REQUIREMENTS FOR ELECTRICAL EQUIPMENT FOR MEASUREMENT, CONTROL, AND LABORATORY USE Part 3-010: Conformity verification report for IEC 61010-2-010, Particular requirements for laboratory equipment for the hea
19、ting of material FOREWORD 1)The IEC (International Electrotechnical Commission) is a worldwide organization for standardization comprising all national electrotechnical committees (IEC National Committees). The object of the IEC is to promote international co-operation on all questions concerning st
20、andardization in the electrical and electronic fields. To this end and in addition to other activities, the IEC publishes International Standards. Their preparation is entrusted to technical committees; any IEC National Committee interested in the subject dealt with may participate in this preparato
21、ry work. International, governmental and non-governmental organizations liaising with the IEC also participate in this preparation. The IEC collaborates closely with the International Organization for Standardization (ISO) in accordance with conditions determined by agreement between the two organiz
22、ations. 2)The formal decisions or agreements of the IEC on technical matters express, as nearly as possible, an international consensus of opinion on the relevant subjects since each technical committee has representation from all interested National Committees. 3)The documents produced have the for
23、m of recommendations for international use and are published in the form of standards, technical reports or guides and they are accepted by the National Committees in that sense. 4)In order to promote international unification, IEC National Committees undertake to apply IEC International Standards t
24、ransparently to the maximum extent possible in their national and regional standards. Any divergence between the IEC Standard and the corresponding national or regional standard shall be clearly indicated in the latter. 5)The IEC provides no marking procedure to indicate its approval and cannot be r
25、endered responsible for any equipment declared to be in conformity with one of its standards. 6)Attention is drawn to the possibility that some of the elements of this International Standard may be the subject of patent rights. The IEC shall not be held responsible for identifying any or all such pa
26、tent rights. The main task of IEC technical committees is to prepare International Standards. However, a technical committee may propose the publication of a technical report when it has collected data of a different kind from that which is normally published as an International Standard, for exampl
27、e “state of the art“. Technical reports do not necessarily have to be reviewed until the data they provide are considered to be no longer valid or useful. IEC 61010-3-010, which is a technical report, has been prepared by IEC technical committee 66: Safety of measuring, control, and laboratory equip
28、ment. The text of this technical report is based on the following documents: Enquiry draftReport on voting 66/178/CDV66/202/RVC Full information on the voting for the approval of this technical report can be found in the report on voting indicated in the above table. Copyright International Electrot
29、echnical Commission Provided by IHS under license with IECLicensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/09/2007 03:01:45 MSTNo reproduction or networking permitted without license from IHS -,-,- 4 61010-3-010 IEC:1999(E) This report is a Technical Report and is of a purely
30、informative nature and is therefore by itself not to be regarded as an International Standard. It is for use by testhouses and other users to assist them with determining and recording verification of conformity of the equipment under test with the requirements of: IEC 61010-2-010:1992 + amendment 1
31、:1996 The protocol for completion of this report is contained in publication IEC 61010-3:1997. The IEC sells read-only PDF files as a general rule. In the present instance, and quite exceptionally, to enable the user to fill in the forms, a revisable file is included in a pocket affixed to the back
32、cover of this publication. This publication can also be downloaded from the Web as a PDF file. There is, however, at the end of the document, a revisable file containing the forms. Please use the zip/unzip function. Copyright International Electrotechnical Commission Provided by IHS under license wi
33、th IECLicensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/09/2007 03:01:45 MSTNo reproduction or networking permitted without license from IHS -,-,- 61010-3-010 IEC:1999(E) 5 Conformity Verification Report IEC 61010-2-010: Safety requirements for electrical equipment for measurem
34、ent, control, and laboratory use Part 2-010:1992, Particular requirements for laboratory equipment for the heating of materials (including amendment 1:1996) Report reference No .: Compiled by (+ signature).: Approved by (+ signature) : Date of issue.: Testing organization .: Address.: Testing locati
35、on .: Applicant.: Address.: Standard.:IEC 61010-1:1990 + A1:1992 + A2:1995 IEC 61010-2-010:1992 + A1:1996 Copyright blank test report .:This report has been prepared by IEC TC 66, which retains responsibility for any changes or corrections required. Test procedure .: Procedure deviation .: Non-stand
36、ard test method: Type of item tested .:? Measurement? Control? Laboratory Trade mark: Model/type reference: Manufacturer : Rating .: Copy of rating plate: Copyright International Electrotechnical Commission Provided by IHS under license with IECLicensee=IHS Employees/1111111001, User=Wing, Bernie No
37、t for Resale, 03/09/2007 03:01:45 MSTNo reproduction or networking permitted without license from IHS -,-,- 6 61010-3-010 IEC:1999(E) Description of equipment function.: INSTALLATION/OVERVOLTAGE CATEGORY.: POLLUTION DEGREE: Environmental rating:? Standard? Other (specify): Equipment mobility:? Porta
38、ble? Hand-held? Floorstanding? Fixed ? Built in? Benchmounted? Other (specify): Connection to mains supply:? Permanent? Detachable ? Non detachable? None Operating conditions:? Continuous? Short-time? Intermittent Overall size of the equipment (length width height): Mass of the equipment (kg): Marke
39、d degree of protection to IEC 60529: IP_ _ Accessories and detachable parts included in the evaluation: Options: NOTE “(see Form A.X)“ refers to a form appended to the report. Copyright International Electrotechnical Commission Provided by IHS under license with IECLicensee=IHS Employees/1111111001,
40、 User=Wing, Bernie Not for Resale, 03/09/2007 03:01:45 MSTNo reproduction or networking permitted without license from IHS -,-,- 61010-3-010 IEC:1999(E) 7 Table 1 Documents attached to this report Document No.Document descriptionNumber of pages Copyright International Electrotechnical Commission Pro
41、vided by IHS under license with IECLicensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/09/2007 03:01:45 MSTNo reproduction or networking permitted without license from IHS -,-,- 8 61010-3-010 IEC:1999(E) Table 2 Test equipment list EquipmentCalibration date No.Last1)Due 1) Or int
42、erval between calibrations. Comments Item Type Copyright International Electrotechnical Commission Provided by IHS under license with IECLicensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/09/2007 03:01:45 MSTNo reproduction or networking permitted without license from IHS -,-,-
43、Table 3 List of components relied on for safety Unique component reference or location (including drawing reference if required) Application/Function Manufacturer and part number (note 1) RATING (note 2) Licence number, file number or other documentary evidence of acceptance NOTE 1 List all manufact
44、urers concerned. NOTE 2 Electrical, mechanical, flammability, etc. Copyright International Electrotechnical Commission Provided by IHS under license with IECLicensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/09/2007 03:01:45 MSTNo reproduction or networking permitted without lic
45、ense from IHS -,-,- 10 61010-3-010 IEC:1999(E) Result: P = Pass F = Fail NA = Not Applicable Clause Subclause RequirementResultComments 5Marking and documentation 5.1.1General Required equipment markings are: a) visible: from the exterior or after removing a cover or opening a door or after removal
46、from a rack or panel b) not put on parts which can be removed by an OPERATOR c) Letter symbols (IEC 60027) used d) Graphic symbols (IEC 61010-1: table 1) used 5.1.2Identification Equipment is identified by: manufacturers name or registered trademark model number, name or other means the degree of pr
47、otection, if any, according to IEC 60529 5.1.3Mains supply Equipment is marked as follows: a) nature of supply: a.c. RATED mains frequency or range of frequencies d.c. with symbol 1 b)RATED supply voltage(s) or range c) maximum RATED power (W or VA) or input current If more than one voltage range: separate values marked or F values differ by less than 20 % (see Form A.3) Copyright International Electrotechnical Commission Provided by IHS under license with IECLicensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/09/2007 03:01:45 MSTNo reproduction or networking permitt
链接地址:https://www.31doc.com/p-3769134.html