IEEE-739-1995.pdf
《IEEE-739-1995.pdf》由会员分享,可在线阅读,更多相关《IEEE-739-1995.pdf(297页珍藏版)》请在三一文库上搜索。
1、Recognized as an American National Standard (ANSI)IEEE Std 739-1995 (Revision of IEEE Std 739-1984) IEEE Recommended Practice for Energy Management in Industrial and Commercial Facilities Sponsor Energy Systems Committee of the Industrial and Commercial Power Systems Department of the IEEE Industry
2、Applications Society Approved 12 December 1995 IEEE Standards Board Approved 16 July 1996 American National Standards Institute Abstract: This recommended practice serves as an engineering guide for use in electrical design for energy conservation. It provides a standard design practice to assist en
3、gineers in evaluating electrical options from an energy standpoint. It establishes engineering techniques and procedures to allow efficiency optimization in the design and operation of an electrical system considering all aspects (safety, costs, environment, those occupying the facility, management
4、needs, etc.). Keywords: break-even analysis; cogeneration; demand control; electrical energy; electric rate structure; energy audit; energy balance; energy conservation program; energy monitoring; energy-rate method; energy savings; heating, ventilating, and air conditioning (HVAC); levelized cost a
5、nalysis; life cycle costing (LCC); lighting; load management; load type; loss evaluation; marginal cost analysis; metering; power bill; process energy; process modification; product energy rate; space conditioning; utility rate structure Copyright The Institute of Electrical and Electronics Engineer
6、s, Inc. Provided by IHS under license with IEEELicensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/20/2007 09:56:04 MDTNo reproduction or networking permitted without license from IHS -,-,- Grateful acknowledgment is made to the following organizations for having granted permission to
7、reprint material in this document as listed below: ABB Power T and for table 5-18 from the 1993 ASHRAE HandbookFundamentals. Butterworth Heinemann Publishers, Oxford, England, for data used in 5.4.5 from the J for tables 5-8 and 5-9 from EPRI TR-102639, “Drivers of Electricity Growth and the Role of
8、 Utility Demand-Side Management,” 1993; and for annex Annex 5A from EPRI TR-101021, “Electrotechnology Reference Guide,” Revision 2, Aug. 1992. National Electrical Contractors Association (NECA), Inc., Bethesda, MD, for data from Electrical Design Library publications used in 5.2.1. General Electric
9、 Co., Fort Wayne, IN, for figure 5-7 from “GE Motors: AC Motor Selection and Application Guide,” GET-6812B; for data used in 5.3.8.12 from “How to Maximize the Return on Energy Efficient Motors,” GEA-10951C; and for data used in table 5-23 from GEP-500J, “GE Motors Stock Catalog.” Ingersoll-Rand Com
10、pany, Washington, NJ, for figure 5-1 from Compressed Air and Gas Handbook, 3rd edition, 1969. Kato Engineering, Mankato, MN, Division of Reliance Electric Company, for tables 5-27 and data used in 5.5.5 from AC Synchronous Condenser Bulletin SC 8-92; and for table 5-28 and data used in 5.5.5 from AC
11、 Synchronous Motor Bulletins SM 1-94 and SM 2-93. National Electrical Manufacturers Association (NEMA), Washington, DC, for tables 5-10, 5-11, 5-12, and figure 5-9 from NEMA MG 1-1993, Motors and Generators; for table 5-13, figures 5-5, 5-10, 5-11, 5-12, and annex Annex 5F from NEMA MG 10-1994, Ener
12、gy Management Guide for Selection and Use of Fixed-Frequency Medium AC Squirrel-Cage Polyphase Induction Motors; and for annex Annex 5E from NEMA MG 11-1992, Energy Management Guide for Selection and Use of Single-Phase Motors. Reliance Electric Co., Cleveland, OH, for figure 5-3, table 5-14, and da
13、ta used in 5.3.7.6.1 from “Adjustable Speed Drives as Applied to Centrifugal Pumps,” Technical Paper D-7100-1, Oct. 1981; for figure 5-4 and data used in 5.3.7.6.2 from “Fan Control for the Glass Industry Using Static Induction Motor Drives,” Technical Paper D-7102, Oct. 1981; for figure 5-8 from “M
14、otor Application,” Bulletin B-2615; and for annexes Annex 5G and Annex 5H. Schindler Elevator Corp., Morristown, NJ, for data used in 5.2.2.2. SEW-Eurodrive, Inc., Troy, OH, for figure 5-6 and data used in 5.3.8.3.1. Copyright The Institute of Electrical and Electronics Engineers, Inc. Provided by I
15、HS under license with IEEELicensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/20/2007 09:56:04 MDTNo reproduction or networking permitted without license from IHS -,-,- iii Square D Company, Lexington, KY, for material reprinted in 5.5.3 from Bulletin D-412D, “Power Factor Correction C
16、apacitorApplications.” State Electricity Commission (SEC) of Victoria, Energy Business Centre, Victoria, Australia, for data used in 5.2.3 from “Electricity for Materials Handling”; for data used in 5.2.4 from “Ultra-Violet Heating at Work in Industry”; for data used in 5.2.5 from “Infrared Heating
17、at Work in Industry”; for data used in 5.2.6 from “Resistance Heating at Work in Industry”; for data used in 5.2.7 from “Radio Frequency Heating of Dielectric Materials”; for data used in 5.2.8 from “Tungsten Halogen Heating”; for data used in 5.2.9 from “Induction Heating and Melting for Industry”;
18、 for data used in 5.2.10 from “Induction Metal Joining, Productivity and Energy Efficiency”; for data used in 5.2.11.1 from “Electric Steam Raising”; for data used in 5.2.14, for figure 2, and for annex Annex 5C from the “Compressed Air Savings Manual.” Trans-Coil, Inc., Milwaukee, WI, for the table
19、 in 5.5.1.2 from a “Guide to Power Quality.” Most of Chapter Chapter 6, including figures and tables, was originally published in a different form in The Dranetz Field Handbook for Electrical Energy Management, copyright 1992, Dranetz Technologies, Inc., and is reprinted with permission from Dranetz
20、 Technologies. All rights reserved. First Printing November 1996 SH94387 The Institute of Electrical and Electronics Engineers, Inc. 345 East 47th Street, New York, NY 10017-2394, USA Copyright 1996 by the Institute of Electrical and Electronics Engineers, Inc. All rights reserved. Published 1996. P
21、rinted in the United States of America. ISBN 1-55937-696-1 No part of this publication may be reproduced in any form, in an electronic retrieval system or otherwise, without the prior written permission of the publisher. Copyright The Institute of Electrical and Electronics Engineers, Inc. Provided
22、by IHS under license with IEEELicensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/20/2007 09:56:04 MDTNo reproduction or networking permitted without license from IHS -,-,- iv IEEE Standards documents are developed within the IEEE Societies and the Standards Coordinating Committees of
23、the IEEE Standards Board. Members of the committees serve voluntarily and without compensation. They are not necessarily members of the Institute. The standards developed within IEEE represent a consensus of the broad expertise on the subject within the Institute as well as those activities outside
24、of IEEE that have expressed an interest in participating in the development of the standard. Use of an IEEE Standard is wholly voluntary. The existence of an IEEE Standard does not imply that there are no other ways to produce, test, measure, purchase, market, or provide other goods and services rel
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- IEEE 739 1995
链接地址:https://www.31doc.com/p-3769854.html