IEEE standard for AC High-Voltage generator circuit breakers rated on a symmetrical current basis.pdf
《IEEE standard for AC High-Voltage generator circuit breakers rated on a symmetrical current basis.pdf》由会员分享,可在线阅读,更多相关《IEEE standard for AC High-Voltage generator circuit breakers rated on a symmetrical current basis.pdf(87页珍藏版)》请在三一文库上搜索。
1、Copyright 1998 IEEE All Rights Reserved1 IEEE Std C37.013-1997 (R2008) (Revision of IEEE Std C37.013-1993) IEEE Standard for AC High-Voltage Generator Circuit Breakers Rated on a Symmetrical Current Basis Sponsor Switchgear Committee of the IEEE Power Engineering Society Reaffirmed 25 September 2008
2、 Approved 20 March 1997 IEEE Standards Board Abstract: Ratings, performance requirements, and compliance test methods are provided for ac high- voltage generator circuit breakers rated on a symmetrical current basis that are installed between the generator and the transformer terminals. Guidance for
3、 applying generator circuit breakers is given. Pumped storage installations are considered a special application, and their requirements are not completely covered by this standard. Keywords: ac high-voltage generator, application guidance, generator circuit breakers, symmetrical current-rating stru
4、cture, terminals of large generators, testing procedures The Institute of Electrical and Electronics Engineers, Inc. 345 East 47th Street, New York, NY 10017-2394, USA Copyright 1997 by the Institute of Electrical and Electronics Engineers, Inc. All rights reserved. Published 1997. Printed in the Un
5、ited States of America ISBN 1-55937-916-2 No part of this publication may be reproduced in any form, in an electronic retrieval system or otherwise, without the prior written permission of the publisher. Authorized licensed use limited to: IHS Stephanie Dejesus. Downloaded on March 17, 2009 at 16:11
6、 from IEEE Xplore. Restrictions apply. Copyright The Institute of Electrical and Electronics Engineers, Inc. Provided by IHS under license with IEEELicensee=HP Monitoring/1111111164 Not for Resale, 04/06/2009 04:08:31 MDTNo reproduction or networking permitted without license from IHS -,-,- ii IEEE
7、Standards documents are developed within the IEEE Societies and the Standards Coordinating Committees of the IEEE Standards Board. Members of the committees serve voluntarily and without compensation. They are not necessarily members of the Institute. The standards developed within IEEE represent a
8、consensus of the broad expertise on the subject within the Institute as well as those activities outside of IEEE that have expressed an interest in participating in the development of the standard. Use of an IEEE Standard is wholly voluntary. The existence of an IEEE Standard does not imply that the
9、re are no other ways to produce, test, measure, purchase, market, or provide other goods and services related to the scope of the IEEE Standard. Furthermore, the viewpoint expressed at the time a standard is approved and issued is subject to change brought about through developments in the state of
10、the art and comments received from users of the standard. Every IEEE Standard is subjected to review at least every five years for revision or reaffirmation. When a document is more than five years old and has not been reaffirmed, it is reasonable to conclude that its contents, although still of som
11、e value, do not wholly reflect the present state of the art. Users are cautioned to check to determine that they have the latest edition of any IEEE Standard. Comments for revision of IEEE Standards are welcome from any interested party, regardless of membership affiliation with IEEE. Suggestions fo
12、r changes in documents should be in the form of a proposed change of text, together with appropriate supporting comments. Interpretations: Occasionally questions may arise regarding the meaning of portions of standards as they relate to specific applications. When the need for interpretations is bro
13、ught to the attention of IEEE, the Institute will initiate action to prepare appropriate responses. Since IEEE Standards represent a consensus of all concerned interests, it is important to ensure that any interpretation has also received the concurrence of a balance of interests. For this reason, I
14、EEE and the members of its societies and Standards Coordinating Committees are not able to provide an instant response to interpretation requests except in those cases where the matter has previously received formal consideration. Comments on standards and requests for interpretations should be addr
15、essed to: Secretary, IEEE Standards Board 445 Hoes Lane P.O. Box 1331 Piscataway, NJ 08855-1331 USA Authorization to photocopy portions of any individual standard for internal or personal use is granted by the Institute of Electrical and Electronics Engineers, Inc., provided that the appropriate fee
16、 is paid to Copyright Clearance Center. To arrange for payment of licensing fee, please contact Copyright Clearance Center, Customer Service, 222 Rosewood Drive, Danvers, MA 01923 USA; (508) 750-8400. Permission to photocopy portions of any individual standard for educational classroom use can also
17、be obtained through the Copyright Clearance Center. Note: Attention is called to the possibility that implementation of this standard may require use of subject matter covered by patent rights. By publication of this standard, no position is taken with respect to the existence or validity of any pat
18、ent rights in connection therewith. The IEEE shall not be responsible for identifying patents for which a license may be required by an IEEE standard or for conducting inquiries into the legal validity or scope of those patents that are brought to its attention. Authorized licensed use limited to: I
19、HS Stephanie Dejesus. Downloaded on March 17, 2009 at 16:11 from IEEE Xplore. Restrictions apply. Copyright The Institute of Electrical and Electronics Engineers, Inc. Provided by IHS under license with IEEELicensee=HP Monitoring/1111111164 Not for Resale, 04/06/2009 04:08:31 MDTNo reproduction or n
20、etworking permitted without license from IHS -,-,- iii Introduction (This introduction is not a part of IEEE Std C37.013-1997, IEEE Standard for AC High-Voltage Generator Circuit Breakers Rated on a Symmetrical Current Basis.) This standard has been revised to clarify the meaning of rated maximum vo
21、ltage as used in this standard and covers the requirements for ac high-voltage generator circuit breakers as applied directly to the outgoing terminals of generators. The rating, testing, and application requirements of these specialized circuit breakers are not adequately covered by the existing st
22、andards IEEE Std C37.04-1979, ANSI C37.06-1987, IEEE Std C37.09-1979, and IEEE Std C37.010-1979 series for ac high-voltage circuit breakers rated on a symmetrical current basis. In order to avoid the detailed integration and possible confusion by introducing the specialized requirements into the exi
23、sting standards, it was determined that a separate standard was the most effective method for covering these devices. A working group of the High-Voltage Circuit Breaker Subcommittee of the IEEE Switchgear Committee has revised this standard with input from various sources on all requirements for th
24、ese specialized devices. The Working Group has developed an Application Guide, which is contained in Clause 6. of this standard. The guide is intended to assist the engineer applying a generator circuit breaker on an electric power system. These efforts have contributed valuable standards to the ind
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- IEEE standard for AC High-Voltage generator circuit breakers rated on symmetrical current basis High
链接地址:https://www.31doc.com/p-3770048.html