IEEE-1313.2-1999-R2005.pdf
《IEEE-1313.2-1999-R2005.pdf》由会员分享,可在线阅读,更多相关《IEEE-1313.2-1999-R2005.pdf(66页珍藏版)》请在三一文库上搜索。
1、The Institute of Electrical and Electronics Engineers, Inc. 3 Park Avenue, New York, NY 10016-5997, USA Copyright 1999 by the Institute of Electrical and Electronics Engineers, Inc. All rights reserved. Published 27 October 1999. Printed in the United States of America. Print: ISBN 0-7381-1761-7 SH9
2、4764 PDF: ISBN 0-7381-1762-5SS94764 No part of this publication may be reproduced in any form, in an electronic retrieval system or otherwise, without the prior written permission of the publisher. IEEE Std 1313.2-1999 (R2005) IEEE Guide for the Application of Insulation Coordination Sponsor Technic
3、al Council of the IEEE Power Engineering Society Reaffirmed 9 June 2005 Approved 26 June 1999 IEEE-SA Standards Board Abstract: The calculation method for selection of phase-to-ground and phase-to-phase insulation withstand votlages for equipment is presented. This guide gives methods for insulation
4、 coordination of different air-insulated systems like transmission lines and substations. The methods of analysis are illustrated by practical examples. Keywords: atmospheric correction factor, backflash, basic lightning impulse level (BIL), basic switching impulse insulation level (BSL), clearances
5、, crest value, ground fault factor, insulation coordination, insulation design, overvoltage, phase-to-ground insulation configuration, phase-to- phase insulation configuration, protective margin, protective radio, shielding failures, standard withstand voltages, voltage stress Copyright The Institut
6、e of Electrical and Electronics Engineers, Inc. Provided by IHS under license with IEEELicensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/21/2007 12:11:58 MDTNo reproduction or networking permitted without license from IHS -,-,- IEEE Standards documents are developed within the IEEE S
7、ocieties and the Standards Coordinating Com- mittees of the IEEE Standards Association (IEEE-SA) Standards Board. Members of the committees serve voluntarily and without compensation. They are not necessarily members of the Institute. The standards developed within IEEE represent a consensus of the
8、broad expertise on the subject within the Institute as well as those activities outside of IEEE that have expressed an interest in participating in the development of the standard. Use of an IEEE Standard is wholly voluntary. The existence of an IEEE Standard does not imply that there are no other w
9、ays to produce, test, measure, purchase, market, or provide other goods and services related to the scope of the IEEE Standard. Furthermore, the viewpoint expressed at the time a standard is approved and issued is subject to change brought about through developments in the state of the art and comme
10、nts received from users of the standard. Every IEEE Standard is subjected to review at least every fi ve years for revision or reaffi rmation. When a document is more than fi ve years old and has not been reaffi rmed, it is rea- sonable to conclude that its contents, although still of some value, do
11、 not wholly refl ect the present state of the art. Users are cautioned to check to determine that they have the latest edition of any IEEE Standard. Comments for revision of IEEE Standards are welcome from any interested party, regardless of membership affi liation with IEEE. Suggestions for changes
12、 in documents should be in the form of a proposed change of text, together with appropriate supporting comments. Interpretations: Occasionally questions may arise regarding the meaning of portions of standards as they relate to specifi c applications. When the need for interpretations is brought to
13、the attention of IEEE, the Institute will initiate action to prepare appropriate responses. Since IEEE Standards represent a consensus of all concerned interests, it is important to ensure that any interpretation has also received the concurrence of a balance of interests. For this reason, IEEE and
14、the members of its societies and Standards Coordinating Committees are not able to provide an instant response to interpretation requests except in those cases where the matter has previously received formal consideration. Comments on standards and requests for interpretations should be addressed to
15、: Secretary, IEEE-SA Standards Board 445 Hoes Lane P.O. Box 1331 Piscataway, NJ 08855-1331 USA Authorization to photocopy portions of any individual standard for internal or personal use is granted by the Institute of Electrical and Electronics Engineers, Inc., provided that the appropriate fee is p
16、aid to Copyright Clearance Center. To arrange for payment of licensing fee, please contact Copyright Clearance Center, Cus- tomer Service, 222 Rosewood Drive, Danvers, MA 01923 USA; (978) 750-8400. Permission to photocopy portions of any individual standard for educational classroom use can also be
17、obtained through the Copy- right Clearance Center. Note: Attention is called to the possibility that implementation of this standard may require use of subject matter covered by patent rights. By publication of this standard, no position is taken with respect to the existence or validity of any pate
18、nt rights in connection therewith. The IEEE shall not be responsible for identifying patents for which a license may be required by an IEEE standard or for conducting inquiries into the legal validity or scope of those patents that are brought to its attention. Copyright The Institute of Electrical
19、and Electronics Engineers, Inc. Provided by IHS under license with IEEELicensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/21/2007 12:11:58 MDTNo reproduction or networking permitted without license from IHS -,-,- Copyright 1999 IEEE. All rights reserved. iii Introduction (This introdu
20、ction is not a part of IEEE Std 1313.2-1999, IEEE Guide for the Application of Insulation Coordination.) This guide is the second part of a major revision of ANSI C92.1-1982. The guide is divided into two parts: IEEE Std 1313.1-1996 (Part 1) presents the defi nitions and the procedure for insulation
21、 coordination. IEEE Std 1313.2-1999 (Part 2) is an application guide, which presents practical examples. The technical content of Part 2, particularly 6.2 and 6.3, is taken with permission from the book Insulation Coordination for Power System by Andrew R. Hileman, published by Marcel Dekker Inc., N
22、ew York, NY. New additions to this guide include the concepts of phase-phase insulation coordination and longitudinal insulation coordination, which considers switching surges and the power frequency voltage across an open switch. The introduction of the very fast front short-duration overvoltages i
23、s an acknowledgment of the problems observed when a disconnect switch operates in a gas insulated substation (GIS). The basic concept of insulation coordination remains the same as in ANSI C92.1-1982. The fi rst step is the determination of voltage stresses using digital computer simulation, transie
24、nt analyzer, or mathematical methods such as those presented in this guide. These analyses result in nonstandard overvoltage waveforms, which are converted to equivalent standard wave shapes. The second step is the selection of insulation strength to achieve the desired level of probability of failu
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- IEEE 1313.2 1999 R2005
链接地址:https://www.31doc.com/p-3770158.html