IEC-PAS-61169-39-2008.pdf
《IEC-PAS-61169-39-2008.pdf》由会员分享,可在线阅读,更多相关《IEC-PAS-61169-39-2008.pdf(28页珍藏版)》请在三一文库上搜索。
1、 IEC/PAS 61169-39 Edition 1.0 2008-05 PUBLICLY AVAILABLE SPECIFICATION PRE-STANDARD Radio-frequency connectors Part 39: Sectional specification for CQM series quick lock RF connectors IEC/PAS 61169-39:2008(E) Copyright International Electrotechnical Commission Provided by IHS under license with IECL
2、icensee=Boeing Co/5910770001 Not for Resale, 07/25/2008 01:57:51 MDTNo reproduction or networking permitted without license from IHS -,-,- THIS PUBLICATION IS COPYRIGHT PROTECTED Copyright 2008 IEC, Geneva, Switzerland All rights reserved. Unless otherwise specified, no part of this publication may
3、be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either IEC or IECs member National Committee in the country of the requester. If you have any questions about IEC copyright or have an enquiry abo
4、ut obtaining additional rights to this publication, please contact the address below or your local IEC member National Committee for further information. IEC Central Office 3, rue de Varemb CH-1211 Geneva 20 Switzerland Email: inmailiec.ch Web: www.iec.ch About the IEC The International Electrotechn
5、ical Commission (IEC) is the leading global organization that prepares and publishes International Standards for all electrical, electronic and related technologies. About IEC publications The technical content of IEC publications is kept under constant review by the IEC. Please make sure that you h
6、ave the latest edition, a corrigenda or an amendment might have been published. ? Catalogue of IEC publications: www.iec.ch/searchpub The IEC on-line Catalogue enables you to search by a variety of criteria (reference number, text, technical committee,). It also gives information on projects, withdr
7、awn and replaced publications. ? IEC Just Published: www.iec.ch/online_news/justpub Stay up to date on all new IEC publications. Just Published details twice a month all new publications released. Available on-line and also by email. ? Electropedia: www.electropedia.org The worlds leading online dic
8、tionary of electronic and electrical terms containing more than 20 000 terms and definitions in English and French, with equivalent terms in additional languages. Also known as the International Electrotechnical Vocabulary online. ? Customer Service Centre: www.iec.ch/webstore/custserv If you wish t
9、o give us your feedback on this publication or need further assistance, please visit the Customer Service Centre FAQ or contact us: Email: csciec.ch Tel.: +41 22 919 02 11 Fax: +41 22 919 03 00 Copyright International Electrotechnical Commission Provided by IHS under license with IECLicensee=Boeing
10、Co/5910770001 Not for Resale, 07/25/2008 01:57:51 MDTNo reproduction or networking permitted without license from IHS -,-,- IEC/PAS 61169-39 Edition 1.0 2008-05 PUBLICLY AVAILABLE SPECIFICATION PRE-STANDARD Radio-frequency connectors Part 39: Sectional specification for CQM series quick lock RF conn
11、ectors INTERNATIONAL ELECTROTECHNICAL COMMISSION T ICS 31.120.30 PRICE CODE ISBN 2-8318-9774-2 Copyright International Electrotechnical Commission Provided by IHS under license with IECLicensee=Boeing Co/5910770001 Not for Resale, 07/25/2008 01:57:51 MDTNo reproduction or networking permitted withou
12、t license from IHS -,-,- PAS 61169-39 IEC:2008(E) 2 CONTENTS FOREWORD.4 1 Scope.6 2 Normative reference.6 3 Mating interface and gauge information6 3.1 Dimensions General connectors Grade 2.7 3.1.1 Connector with pin centre contact.7 3.1.2 Connectors with socket-centre contact 8 3.2 Gauges .9 3.2.1
13、Connectors with socket-centre contact 9 3.3 Dimensions standard test connectors Grade 0.10 3.3.1 Connector with pin-centre contact10 3.3.2 Connector with socket-centre contact 11 4 Quality assessment procedure12 4.1 General.12 4.2 Rating and characteristics (see Clause 6 of IEC 61169-1/QC220000)12 4
14、.3 Test schedule and inspection requirements.14 4.3.1 Acceptance tests .14 4.3.2 Periodic tests 15 4.4 Procedures16 4.4.1 Quality conformance inspection.16 4.4.2 Qualification approval and its maintenance16 5 Instructions for preparation of detail specifications .16 5.1 General.16 5.2 Identification
15、 of the detail specification16 5.3 Identification of the component17 5.4 Performance17 5.5 Marking, ordering information and related matters.17 5.6 Selection of tests, test conditions and severities17 5.7 Blank detail specification pro-forma for type CQM connector.18 Bibliography23 Figure 1 Connecto
16、r with pin-centre contact (for dimensions, see Table 1).7 Figure 2 Connector with socket-centre contact (for dimensions, see Table 2) .8 Figure 3 Gauge for outer contact of socket connector (for dimensions, see Table 3).9 Figure 4 Gauge pin for socket contact (for dimensions, see Table 4) 9 Figure 5
17、 Connector of pin-centre contact (for dimensions, see Table 5) 10 Figure 6 Standard test connector with socket-centre contact (for dimensions, see Table 6) 11 Copyright International Electrotechnical Commission Provided by IHS under license with IECLicensee=Boeing Co/5910770001 Not for Resale, 07/25
18、/2008 01:57:51 MDTNo reproduction or networking permitted without license from IHS -,-,- PAS 61169-39 IEC:2008(E) 3 Table 1 Dimensions of connector with pin-centre contact.7 Table 2 Dimensions of connector with socket-centre contact8 Table 3 Dimensions of gauge for outer contact of socket connector
19、.9 Table 4 Dimensions of gauge pin for socket contact.10 Table 5 Dimensions of connector with pin-centre contact.11 Table 6 Dimensions of standard test connector with socket-centre contact 12 Table 7 Ratings and characteristics .13 Table 8 Acceptance tests.14 Table 9 Periodic tests 15 Copyright Inte
20、rnational Electrotechnical Commission Provided by IHS under license with IECLicensee=Boeing Co/5910770001 Not for Resale, 07/25/2008 01:57:51 MDTNo reproduction or networking permitted without license from IHS -,-,- PAS 61169-39 IEC:2008(E) 4 INTERNATIONAL ELECTROTECHNICAL COMMISSION _ RADIO-FREQUEN
21、CY CONNECTORS Part 39: Sectional specification for CQM series quick lock RF connectors FOREWORD 1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising all national electrotechnical committees (IEC National Committees). The object of IEC is t
22、o promote international co-operation on all questions concerning standardization in the electrical and electronic fields. To this end and in addition to other activities, IEC publishes International Standards, Technical Specifications, Technical Reports, Publicly Available Specifications (PAS) and G
23、uides (hereafter referred to as “IEC Publication(s)”). Their preparation is entrusted to technical committees; any IEC National Committee interested in the subject dealt with may participate in this preparatory work. International, governmental and non- governmental organizations liaising with the I
24、EC also participate in this preparation. IEC collaborates closely with the International Organization for Standardization (ISO) in accordance with conditions determined by agreement between the two organizations. 2) The formal decisions or agreements of IEC on technical matters express, as nearly as
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- IEC PAS 61169 39 2008
链接地址:https://www.31doc.com/p-3770644.html