IEEE-C37.016-2006.pdf
《IEEE-C37.016-2006.pdf》由会员分享,可在线阅读,更多相关《IEEE-C37.016-2006.pdf(87页珍藏版)》请在三一文库上搜索。
1、IEEE Std C37.016-2006 IEEE Standard for AC High-Voltage Circuit Switchers rated 15.5 kV through 245 kV I E E E 3 Park Avenue New York, NY 10016-5997, USA 6 June 2007 IEEE Power Engineering Society Sponsored by the Switchgear Committee -,-,- IEEE Std C37.016-2006 IEEE Standard for AC High-Voltage Cir
2、cuit Switchers rated 15.5 kV through 245 kV Sponsor Switchgear Committee of the IEEE Power Engineering Society Approved 6 December 2006 IEEE-SA Standards Board Abstract: This standard is applicable to ac circuit switchers designed for outdoor installation and for rated power frequencies of 50 Hz and
3、 60 Hz and rated maximum voltages of 15.5 kV through 245 kV. It is applicable only to three-pole circuit switchers for use in three-phase systems. This standard is also applicable to the operating devices of circuit switchers and to their auxiliary equipment. Keywords: ac circuit switcher, three-pol
4、e circuit switcher The Institute of Electrical and Electronics Engineers, Inc. 3 Park Avenue, New York, NY 10016-5997, USA Copyright 2007 by the Institute of Electrical and Electronics Engineers, Inc. All rights reserved. Published 6 June 2007. Printed in the United States of America. IEEE is a regi
5、stered trademark in the U.S. Patent +1 978 750 8400. Permission to photocopy portions of any individual standard for educational classroom use can also be obtained through the Copyright Clearance Center. Introduction This introduction is not part of IEEE Std C37.016-2006, IEEE Standard for AC High-V
6、oltage Circuit Switchers Rated 15.5 kV Through 245 kV. This standard was written to cover a class and type of equipment that has been manufactured by a few manufacturers for over 30 years, yet did not have an international standard. More manufacturers and users have started using and manufacturing t
7、his class of equipment, and a standard has become necessary. The IEC community has expressed interest in this type of device and has expressed interest in using this standard for its purposes. With that in mind, the Interrupter Switch Working Group has tried to reach out to both the IEEE and IEC com
8、munities. Therefore, the reader will find references to both IEEE and IEC standards within this standard. Where references to both standards are made, users are responsible for specifying the standard they desire, and manufacturers are responsible for specifying the standard they used for their desi
9、gn and testing. Where there is a clear need for different requirements in different applications, diverging standards are appropriate. This standard was written to provide the basic standard for circuit switchers. As such, an attempt was made to encompass as many different types of circuit switchers
10、 as practical. Part of the heritage of this standard comes from the treatment of interrupter switches in other IEEE C37 standards. It is anticipated that material relating to interrupter switches, currently in the IEEE C37.30 series, will be removed from those documents when this standard is publish
11、ed. Further, when this standard is published, it is anticipated that other standards not in the IEEE C37.30 series will begin to reference this standard. Although this standard will be published before the work on IEEE Std C37.100.1 (Common Clauses) is finished, it is the intention of the Interrupte
12、r Switch Working Group to adopt or reference common clauses as they become available. Notice to users Errata Errata, if any, for this and all other standards can be accessed at the following URL: http:/ standards.ieee.org/reading/ieee/updates/errata/index.html. Users are encouraged to check this URL
13、 for errata periodically. Interpretations Current interpretations can be accessed at the following URL: http:/standards.ieee.org/reading/ieee/interp/ index.html. iv Copyright 2007 IEEE. All rights reserved. -,-,- Patents Attention is called to the possibility that implementation of this standard may
14、 require use of subject matter covered by patent rights. By publication of this standard, no position is taken with respect to the existence or validity of any patent rights in connection therewith. The IEEE shall not be responsible for identifying patents or patent applications for which a license
15、may be required to implement an IEEE standard or for conducting inquiries into the legal validity or scope of those patents that are brought to its attention. Participants At the time this standard was completed, the Interrupter Switch Working Group had the following membership: Randall L. Dotson, C
16、hair Roy Alexander B. Bergman Anne Bosma P. DiLillo C. Garner V. Gor A. Kahn Antonio Mannarino A. McCabe Peter Meyer R. Munayirji Yasin Musa Jeffrey Nelson G. Perkins C. Reigart Hugh Ross G. Schauffler D. Seay H. M. Smith R. Sunkara J. Tannery Thomas Tobin The following members of the individual bal
17、loting committee voted on this standard. Balloters may have voted for approval, disapproval, or abstention. Roy Alexander Stan J. Arnot Edwin Averill W. J. (Bill) Bergman Stan Billings Anne Bosma Lyne Brisson John Brunke Ted Burse Tommy Cooper Alexander Dixon James Domo Randall Dotson Denis Dufourne
18、t Doug Edwards Leslie Falkingham Carl Fredericks Kenneth Gettman Harry Gianakouros Mietek Glinkowski Keith Gray Randall Groves Harold L. Hess Luther Holloman Edward Horgan, Jr. Richard Jackson Joseph L. Koepfinger Alan Kollar Thomas LaRose Stephen R. Lambert William Larzelere George Lester Maurice L
19、inker R. W. Long Gregory Luri Antonio Mannarino Fortin Marcel John Martin Thomas McCaffrey Kenneth McClenahan Nigel McQuin Peter Meyer Gary Michel Georges Montillet Yasin Musa Jeffrey Nelson Trapp Norbert T. W. Olsen David Peelo Anthony Picagli Hugh Ross Joe Rostron James Ruggieri H. Melvin Smith Da
20、vid Stone Stanton Telander Thomas Tobin Gerald Vaughn Jeffrey Williams James Wilson Richard York Jan Zawadzki v Copyright 2007 IEEE. All rights reserved. When the IEEE-SA Standards Board approved this standard on 6 December 2006, it had the following membership: Steve M. Mills, Chair Richard H. Hule
21、tt, Vice Chair Don Wright, Past Chair Judith Gorman, Secretary Mark D. Bowman Dennis B. Brophy Joseph Bruder Richard Cox Bob Davis Julian Forster* Joanna N. Guenin Mark S. Halpin Raymond Hapeman William B. Hopf Lowell G. Johnson Herman Koch Joseph L. Koepfinger* David J. Law Daleep C. Mohla Paul Nik
22、olich T. W. Olsen Glenn Parsons Ronald C. Petersen Gary S. Robinson Frank Stone Malcolm V. Thaden Richard L. Townsend Joe D. Watson Howard L. Wolfman *Member Emeritus Also included are the following nonvoting IEEE-SA Standards Board liaisons: Satish K. Aggarwal, NRC Representative Richard DeBlasio,
23、DOE Representative Alan H. Cookson, NIST Representative Don Messina IEEE Standards Program Manager, Document Development vi Copyright 2007 IEEE. All rights reserved. -,-,- Contents 1. Overview 1 1.1 Scope. 1 1.2 Normative references. 1 2. Usual and unusual service conditions. 3 2.1 Usual service con
24、ditions 3 2.2 Unusual service conditions 3 3. Definitions 4 3.1 General definitions 4 3.2 Definitions relating to gas and vacuum tightness 5 4. Rating. 7 4.1 Rated maximum voltage (Ur). 7 4.2 Rated insulation level 8 4.3 Rated power frequency (fr) 8 4.4 Rated continuous current (Ir). 9 4.5 Rated sho
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- IEEE C37 016 2006
链接地址:https://www.31doc.com/p-3771140.html