IEEE-C37.53.1-1989-R1996.pdf
《IEEE-C37.53.1-1989-R1996.pdf》由会员分享,可在线阅读,更多相关《IEEE-C37.53.1-1989-R1996.pdf(13页珍藏版)》请在三一文库上搜索。
1、 The Institute of Electrical and Electronics Engineers, Inc. 3 Park Avenue, New York, NY 10016-5997, USA Copyright 2003 by the Institute of Electrical and Electronics Engineers, Inc. All rights reserved. Printed in the United States of America. Print: ISBN 0-7381-3616-6SH95104 PDF: ISBN 0-7381-3617-
2、4SS95104 No part of this publication may be reproduced in any form, in an electronic retrieval system or otherwise, without the prior written permission of the publisher. ANSI C37.53.1-1989(R1996) (Revision of ANSI C37.53.1-1982) American National Standard High-Voltage Current-Limiting Motor-Starter
3、 Fuses Conference Test Procedures Approved 1/25/89 American National Standards Institute, Inc. Copyright The Institute of Electrical and Electronics Engineers, Inc. Provided by IHS under license with IEEELicensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/20/2007 08:37:10 MDTNo reprodu
4、ction or networking permitted without license from IHS -,-,- ii Foreword (This Foreword is not part of American National Standard C37.53.1-1989.) The High Voltage Apparatus Coordinating Committee (HVACC) was established July 24, 1973 by the Electrical and Electronic Technical Advisory Board of the A
5、merican National Standards Institute. In 1982, the advisory board was superseded by the Electrical and Electronic Standards Board. The responsibility assigned to HVACC was to review and evaluate existing ANSI-approved standards and other related standards for the purpose of developing a “Draft Stand
6、ard” for unit substations and recommendations for (1) correlating the requirements of these standards and (2) adding requirements to these standards appropriate for product evaluation. This standard results from the evaluation of existing ANSI-approved standards and from the need to add requirements
7、 to these standards for the evaluation and conformance certification of high-voltage motor-starter fuses. The intent of this standard is to allow qualification of high-voltage motor-starter fuses for use in accordance with the American National Standard National Electrical Code, ANSI/NFPA 70-1987. H
8、owever, this standard does not cover installations under the exclusive control of electric utilities and is not intended to cover application, installation, or operation of high-voltage motor-starter fuses. This 1989 revision of the standard was developed to modify Section 5. (Production Monitoring)
9、 and to update other sections. Suggestions for improvement of this standard are welcome. They should be sent to the National Electrical Manufacturers Association, 2101 L Street, NW, Washington, DC 20037. Copyright The Institute of Electrical and Electronics Engineers, Inc. Provided by IHS under lice
10、nse with IEEELicensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/20/2007 08:37:10 MDTNo reproduction or networking permitted without license from IHS -,-,- iii This standard was processed and approved for submittal to ANSI by Accredited Standards Committee on Power Switchgear, C37. Com
11、mittee approval of the standard does not necessarily imply that all committee members voted for its approval. At the time it approved this standard, the C37 Committee had the following members: W. E. Laubach, Chair A. K. McCabe, Executive Vice-Chair (High-Voltage Standards) S. H. Telander, Executive
12、 Vice-Chair (Low-Voltage Standards) D. L. Swindler, Executive Vice-Chair (International Electrotechnical Commission Activities) C. H. White, Secretary M. B. Williams (Program Administrator) Organization RepresentedName of Representative Association of Iron and Steel EngineersJ. M. Tillman Electric L
13、ight and Power Group R. L. Capra (Chair) D. A. Ditzler K. D. Hendrix J. H. Provanzana D. E. Soffrin D. T. Weston G. R. Brandenberger (Alt) T. E. Bruck (Alt) Institute of Electric and Electronics EngineersH. W. Mikulecky (Chair) W. F. Hoenigmann D. M. Larson E. W. Schmunk C. A. Schwalbe S. C. Atkinso
14、n (Alt) D. G. Kumbera (Alt) National Electrical Manufacturers Association .R. A. McMaster (Chair) T. C. Burnett R. H. Miller R. O. D. Whitt H. L. Miller (Alt) Tennessee Valley Authority.R. B. Rotton Testing Laboratory GroupL. Frier W. T. OGrady R. W. Seelbach (Alt) U.S. Department of Agriculture Rur
15、al Electrification AdministrationH. L. Bowles U.S. Department of the Army Office of the Chief of EngineersW. M. Jones U.S. Department of the Interior Bureau of Reclamation.J. W. Reif U.S. Department of the Navy Naval Construction Battalion Center.R. L. Clark Western Area Power Administration.G. D. B
16、irney Copyright The Institute of Electrical and Electronics Engineers, Inc. Provided by IHS under license with IEEELicensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/20/2007 08:37:10 MDTNo reproduction or networking permitted without license from IHS -,-,- iv The C37 Subcommittee on C
17、ertification Test Procedures, which reviewed and approved this standard, had the following members: W. E. Laubach, Chair P. Clickner N. Davies R. A. McMaster M. E. Newman A. J. Schaeffer E. G. Rapske R. W. Seelbach S. H. Telander The Working Group of the HVACC Subcommittee on High-Voltage Fuses, whi
18、ch developed the major portion of this standard, had the following members: R. H. Arndt, Chair R. H. Amundson J. G. Angelis E. H. Arjeski R. E. Bennett F. L. Cameron H. H. Fahnoe G. P. Gill H. A. Norberg W. H. Russell Copyright The Institute of Electrical and Electronics Engineers, Inc. Provided by
19、IHS under license with IEEELicensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/20/2007 08:37:10 MDTNo reproduction or networking permitted without license from IHS -,-,- v CLAUSEPAGE 1. Scope.1 1.1 General. 1 1.2 Insulating Evaluation . 1 2. Referenced and Related Standards2 2.1 Refere
20、nced American National Standards. 2 2.2 Related Standards. 2 3. General Test Conditions2 3.1 General. 2 3.2 Resistance Measurement 3 3.3 Temperature-Rise Tests . 3 3.4 Melting-Time-Current Characteristics. 3 3.5 Interrupting Tests. 3 3.6 Marking 4 4. Treatment of Failures4 5. Production Monitoring5
21、5.1 Monitoring Tests 5 5.2 Tests for Design Deviations. 5 6. Retesting6 6.1 General. 6 6.2 Design Changes 6 7. Requalification Tests.6 Copyright The Institute of Electrical and Electronics Engineers, Inc. Provided by IHS under license with IEEELicensee=NASA Technical Standards 1/9972545001 Not for R
22、esale, 04/20/2007 08:37:10 MDTNo reproduction or networking permitted without license from IHS -,-,- Copyright The Institute of Electrical and Electronics Engineers, Inc. Provided by IHS under license with IEEELicensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/20/2007 08:37:10 MDTNo r
23、eproduction or networking permitted without license from IHS -,-,- 1 American National Standard for Switchgear High-Voltage Current-Limiting Motor- Starter FusesConformance Test Procedures 1. Scope This standard covers the conformance test procedures for alternating-current high-voltage motor-starte
24、r fuses covered in the applicable American National Standards listed in 2.1. High-voltage motor-starter fuses are backup, current- limiting fuses used in conjunction with high-voltage Class E2 motor starters. This standard does not cover installations under the exclusive control of electric utilitie
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- IEEE C37 53.1 1989 R1996
链接地址:https://www.31doc.com/p-3771163.html