IEEE-525-2007.pdf
《IEEE-525-2007.pdf》由会员分享,可在线阅读,更多相关《IEEE-525-2007.pdf(132页珍藏版)》请在三一文库上搜索。
1、IEEE Std 525-2007 (Revision of IEEE Std 525-1992/Incorporates IEEE Std 525-2007/Cor1:2008) IEEE Guide for the Design and Installation of Cable Systems in Substations IEEE 3 Park Avenue New York, NY 10016-5997, USA 2 April 2008 IEEE Power Engineering Society Sponsored by the Substations Committee 525
2、 TM Copyright The Institute of Electrical and Electronics Engineers, Inc. Provided by IHS under license with IEEELicensee=IHS Employees/1111111001, User=Japan, IHS Not for Resale, 07/30/2008 02:02:18 MDTNo reproduction or networking permitted without license from IHS -,-,- Copyright The Institute of
3、 Electrical and Electronics Engineers, Inc. Provided by IHS under license with IEEELicensee=IHS Employees/1111111001, User=Japan, IHS Not for Resale, 07/30/2008 02:02:18 MDTNo reproduction or networking permitted without license from IHS -,-,- IEEE Std 525-2007 (Revision of IEEE Std 525-1992/Incorpo
4、rates IEEE Std 525-2007/Cor1:2008) IEEE Guide for the Design and Installation of Cable Systems in Substations Sponsor Substations Committee of the IEEE Power Engineering Society Approved 8 March 2007 IEEE-SA Standards Board Copyright The Institute of Electrical and Electronics Engineers, Inc. Provid
5、ed by IHS under license with IEEELicensee=IHS Employees/1111111001, User=Japan, IHS Not for Resale, 07/30/2008 02:02:18 MDTNo reproduction or networking permitted without license from IHS -,-,- Abstract: The design, installation, and protection of wire and cable systems in substations are covered in
6、 this guide, with the objective of minimizing cable failures and their consequences. Keywords: acceptance testing, cable, cable installation, cable selection, communication cable, electrical segregation, fiber-optic cable, handling, power cable, pulling tension, raceway, recommended maintenance, rou
7、ting, separation of redundant cable, service conditions, substation, transient protection _ The Institute of Electrical and Electronics Engineers, Inc. 3 Park Avenue, New York, NY 10016-5997, USA Copyright 2008 by the Institute of Electrical and Electronics Engineers, Inc. All rights reserved. Publi
8、shed 2 April 2008. Printed in the United States of America. Figure J.1 was replaced as required by IEEE Std 525-2007/Cor1:2008. IEEE is a registered trademark in the U.S. Patent +1 978 750 8400. Permission to photocopy portions of any individual standard for educational classroom use can also be obt
9、ained through the Copyright Clearance Center. Copyright The Institute of Electrical and Electronics Engineers, Inc. Provided by IHS under license with IEEELicensee=IHS Employees/1111111001, User=Japan, IHS Not for Resale, 07/30/2008 02:02:18 MDTNo reproduction or networking permitted without license
10、 from IHS -,-,- Introduction This introduction is not part of IEEE Std 525-2007, IEEE Guide for the Design and Installation of Cable Systems in Substations. This revision of the guide incorporates various changes in cable installation philosophies that have occurred since the 1992 version of the gui
11、de. Significant changes have been made in the following areas: a) Re-ordered much of the common information for all cables into the annexes, and rearranged the clauses to align with specific information for each differing type of cable b) Added a clause to cover communication cable c) Expanded and u
12、pdated the clause for fiber-optic cable d) Arranged the annexes to better follow the flow of control cable systems selection and design e) Expanded and updated the annex for cable selection to include a table of common cable sizes and additional equations for calculating resistance effects, and adde
13、d considerations for jacketing, attenuation and capacitance f) Added an annex as a design checklist for communication cables g) Expanded and updated the annex for transient protection (shielding) h) Added recommended maintenance i) Added a flowchart in Annex A that references each annex j) Added an
14、example of cable system design in Annex O for a small substation k) Removed the fire systems clauses and recommended these be included in the updating of IEEE Std 979-1994 B63 a l) Updated to latest version of the IEEE Standards Style Manual m) Corrected some of the axis labels for percent occupancy
15、 in Figure J.1 as required by IEEE Std 525-2007/Cor1:2008 Notice to users Laws and regulations Users of these documents should consult all applicable laws and regulations. Compliance with the provisions of this standard does not imply compliance to any applicable regulatory requirements. Implementer
16、s of the standard are responsible for observing or referring to the applicable regulatory requirements. IEEE does not, by the publication of its standards, intend to urge action that is not in compliance with applicable laws, and these documents may not be construed as doing so. a The numbers in bra
17、ckets correspond to those of the bibliography in Annex P. iv Copyright 2008 IEEE. All rights reserved. Copyright The Institute of Electrical and Electronics Engineers, Inc. Provided by IHS under license with IEEELicensee=IHS Employees/1111111001, User=Japan, IHS Not for Resale, 07/30/2008 02:02:18 M
18、DTNo reproduction or networking permitted without license from IHS -,-,- Copyrights This document is copyrighted by the IEEE. It is made available for a wide variety of both public and private uses. These include both use, by reference, in laws and regulations, and use in private self- regulation, s
19、tandardization, and the promotion of engineering practices and methods. By making this document available for use and adoption by public authorities and private users, the IEEE does not waive any rights in copyright to this document. Updating of IEEE documents Users of IEEE standards should be aware
20、 that these documents may be superseded at any time by the issuance of new editions or may be amended from time to time through the issuance of amendments, corrigenda, or errata. An official IEEE document at any point in time consists of the current edition of the document together with any amendmen
21、ts, corrigenda, or errata then in effect. In order to determine whether a given document is the current edition and whether it has been amended through the issuance of amendments, corrigenda, or errata, visit the IEEE Standards Association Web site at http:/ieeexplore.ieee.org/xpl/standards.jsp, or
22、contact the IEEE at the address listed previously. For more information about the IEEE Standards Association or the IEEE standards development process, visit the IEEE-SA Web site at http:/standards.ieee.org. Errata Errata, if any, for this and all other standards can be accessed at the following URL
23、: http:/standards.ieee.org/reading/ieee/updates/errata/index.html. Users are encouraged to check this URL for errata periodically. Interpretations Current interpretations can be accessed at the following URL: http:/standards.ieee.org/reading/ieee/interp/ index.html. Patents Attention is called to th
24、e possibility that implementation of this guide may require use of subject matter covered by patent rights. By publication of this guide, no position is taken with respect to the existence or validity of any patent rights in connection therewith. The IEEE is not responsible for identifying Essential
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- IEEE 525 2007
链接地址:https://www.31doc.com/p-3771755.html